Vulcan VSX24G User Manual

Item # _____________________________

C.S.I. Section 11420

VSXG SERIES

GAS BOILER CONVECTION STEAMER
ON CABINET BASE

■ VSX24G 6 pan capacity

■ VSX24G5 10 pan capacity

STANDARD FEATURES

■ Two stainless steel cooking compartments with coved interior
corners. Each compartment accepts:

- 1" deep pans (6 - VSX24G)(10 - VSX24G5)

- 21/2" deep pans (3 - VSX24G)(5 - VSX24G5)

- 4" deep pans (2 - VSX24G)(3 - VSX24G5)

■ 11/4" drain in each compartment.

■ Heavy duty stainless steel "slammable" doors can be opened

and closed at anytime during the cooking cycle. Steam shuts
off when door(s) are opened.

■ 200,000 BTU/hr. steam boiler with electronic ignition. Includes
a CSD-1 compliant high pressure limit switch (15 psi), low
water cut-off, automatic water ll, automatic generator blow
down, 15 psi pressure relief valve and 15 psi kettle connection.

■ Compartment controls include 60 minute dial timer with
buzzer, green "ready" and red "cooking" indicator lights.

■ Convection steamer mounted on 28" high base cabinet with
stainless steel frame, front full height doors, slip-off stainless
steel side and aluminized rear panel with 6" adjustable legs
with anged feet for anchoring.

■ Stainless steel rear ue.

■ One year limited parts and labor warranty.

A2780

ISO9001

Vulcan-Hart Co.

MODELS: VSXG SERIES Gas Heated Convection Steamer on Cabinet Base

SPECIFICATIONS:

Gas heated convection steamer, Vulcan-Hart Model No.
(VSX24G) (VSX24G5). Two stainless steel cooking compart­ments with coved interior corners. 11/4" drain in each compart­ment. Heavy duty stainless steel "slammable" doors can be
opened and closed at anytime during the cooking cycle. Steam
shuts off when door(s) are opened. Convection steamer mounted

on 28" high base cabinet with stainless steel frame, front full
height doors, slip-off stainless steel side and aluminized rear

panel with 6" adjustable legs with anged feet for anchoring.
200,000 BTU/hr. steam boiler with electronic ignition. Includes a
CSD-1 compliant high pressure limit switch (15 psi), low water
cut-off, automatic water ll, automatic generator blow down, 15 psi
pressure relief valve and 15 psi kettle connection. Compartment
controls include 60 minute dial timer with buzzer, green "ready"
and red "cooking" indicator lights. Stainless steel rear ue.

Exterior dimensions:
VSX24G: 24"w x 33"d x 603/8"h.
VSX24G5: 24"w x 33"d x 73"h.

CSA design certied. Classied by U L to NSF std. #4. Meets
ASME code.

OPTIONS

■ Correction facility package:

a. Security type tamper resistant fasteners with tack welds.
b. Control cover with hasp (lock by others).
c. Cabinet door with hasp (lock by others).
d. Perforated ue cover.

■ Step down transformer for control circuit if higher than

120 volts.

■ Mount and interconnect boiler base with kettle at factory.

Includes steam supply piping. Shipped on one skid.

■ Second year extended limited parts and labor warranty.

ACCESSORIES

■ Stainless steel back panel.

■ Interconnecting steam supply plumbing kit.

■ Removable sliding shelf (Qty. ____).

■ Water treatment system.

F-32478 (08-04)

VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. [phone]

502-778-2791 QUOTE & ORDER FAX: [phone]

Printed On Recycled Paper

VSXG SERIES

GAS BOILER CONVECTION STEAMER
ON CABINET BASE

IMPORTANT:

1. A pressure regulator sized for this unit is included. Natural gas

8.0" W.C. Propane 10.5" W.C.

2. Gas line connecting to unit must be 3/4" or larger. If exible
connectors are used, the inside diameter must be at least the same
as the 3/4" iron pipe and rated for the correct gas input.

3. Requires 120V/60 Hz/1 ph electrical connection.

4. An adequate ventilation system is required for commercial cooking
equipment. Information may be obtained by writing to the National
Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
When writing, refer to NFPA No. 96.

5. These units are manufactured for installation in accordance with
ANSZ223.1a (latest edition), National Fuel Gas Code. Copies may
be obtained from the American Gas Association, 1515 Wilson Blvd.,
Arlington, VA 22209.

6. Equipment Clearances: Combustible Non-Combustible

Rear 6" 6"

Right/Left 6" 6"

WATER QUALITY STATEMENT:

The fact that a water supply is potable is no guarantee that it is suitable
for steam generation. Your water supply must be within these general
guidelines:

SUPPLY PRESSURE 20 - 60 psig
HARDNESS* less than 3 grains
SILICA less than 13 ppm
TOTAL CHLORIDE less than 4.0 ppm
pH RANGE 7-8
UN-DISSOLVED SOLIDS less than 5 microns
* 17.1 ppm = 1 grain of hardness

Other factors affecting steam generation are iron content, amount of
chloridation and dissolved gases. Water supplies vary from state to
state and from locations within a state. Therefore it is necessary that the
local water treatment specialist be consulted before the installation of
any steam generating equipment.

SERVICE CONNECTIONS:

Gas Connection: 3/4" NPT.

Electric Connection for Controls: 120/60/1, 300 watt maxi -

mum, power supply with grounding wire required. (For other
than 120 volt supply consu lt factory for location of t his
connection.)

Drain: Condenser box, compartment and boiler, 11/4" NPT.

(Provide an open air gap type drain within 12" of condenser
box and for best results at a distance so that steam vapors will
not enter the steamers from underneath the control area. Do
not connect solidly to any drain connection.)

Cold Water Connection: 1/2" NPT for boiler feed. Inlet ltered

water pressure between 20 and 80 psi.

Cold Water Connection: 1/8" NPT for condensate box. Inlet

unltered water pressure between 20 and 80 psi.

Steam Take-off Connection: 3/4" NPT.

NOTE:

• Dimensionswhichlocatetheaboveconnectionshaveatoleranceof
+ or -3" (+ or -75 mm).

• Installation of backow preventers, vacuum breakers and other
specic code requirements is the responsibility of the owner and
installer. It is the responsibility of the owner and installer to comply with
local codes.

• Plasticdrainsarenotrecommendedduetoinherentlimitedtempera­tures of the plastic. Boiler purge temperatures may exceed 180°F.
The installer may be required to provide means to reduce boiler purge
water temperature to be that of the condensate temperature of 140°F
or less.

• Thisapplianceismanufacturedforcommercialinstallationonlyandis
not intended for home use.

NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specications without notice.

F-32478 (08-04)

VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. [phone]

502-778-2791 QUOTE & ORDER FAX: [phone]