Vulcan GH30S User Manual

Model GH30C
Shown with 17" backguard
SPECIFICATIONS
Heavy duty radial n hot top gas range with oven, Vulcan-Hart Model No. GH30. Stainless Steel body and 6" adjustable legs. 1 diameter front gas manifold. Radial n hot top with ceramic re brick provides graduated heat from 900° center to 300° outside area. Three concentric cast ring burners with separate manual controls. Inner ring 10,000 BTU/hr., middle ring 15,000 BTU/hr., outer ring 20,000 BTU/hr. Pilot ignition. Oven interior measures 26"w x 28"d x 14"h. Porcelain enamel on steel hearth, door and side liners. One oven rack and two rack positions. 50,000 BTU/hr. heavy cast "Flame Retention" burner with pilot ignition. Thermostat adjusts from 150° to 500°F. Controls located in the cool zone.
Exterior dimensions: 34"w x 39 6" legs.
CSA design certied. NSF listed.
SPECIFY TYPE OF GAS AND FINISH WHEN ORDERING.
SPECIFY ALTITUDE WHEN ABOVE 2,000 FT.
1
8"d x 36" working height on
1
4
Item # __________________________
MODEL GH30
RADIAL FIN HOT TOP HEAVY DUTY GAS RANGE
GH30 Standard Oven GH30C Convection Oven GH30S
STANDARD FEATURES
Stainless steel body and 6" adjustable legs.
1
4" diameter front gas manifold.
1
Radial n hot top with ceramic re brick provides graduated heat from 900° center ring to 300° outside area. Three concentric cast ring burners with separate manual controls. Inner ring 10,000 BTU/hr., middle ring 15,000 BTU/hr., outer ring 20,000 BTU/hr. Pilot ignition.
Oven controls located in the cool zone.
Oven interior measures 26"w x 28"d x 14"h. Porcelain enamel on steel hearth, door and side liners. One oven rack and two rack positions. 50,000 BTU/hr. “Flame Retention” burner with pilot ignition. Thermostat adjusts from 150° to 500°F.
One year limited parts and labor warranty.
OPTIONS
SnorkelTM convection oven in place of standard oven. Add sux “C” to the model number. Porcelain enamel on steel interior measures 26 racks and ve rack positions. 32,000 BTU/hr. burner with pilot ignition. Thermostat adjusts from 200° to 500°F. blower motor with 7 foot power cord and plug. 120/60/1, 5 amps.
"
Stainless steel back nishing panel.
Common front top ledge up to 68" wide. (Not for use on griddle tops, spreader plates and deep fat fryers.)
Cap and cover manifold end(s). (No charge.)
5
8" stainless steel toe base - 315⁄8" working height.
1
Set of four 5" diameter casters, two locking.
Stainless steel dolly frame with casters, up to 102" wide.
Cooling fan for Snorkel when unit is installed with a back nishing panel or a toe base.
Rear gas connection. (Reference spec sheet F-31525.)
Second year extended limited parts and labor warranty.
650° Thermostat Statement.
Stainless steel center shelves on cabinet base units statement.
Cabinet storage base in place of standard oven. Add the
sux “S” to the model number.
Standard Base
1
" w x 223⁄32 " d x 141⁄8" h. Three oven
8
TM
convection oven motor. Required
C.S.I. Section 11420
1
4 H.P.
.oC traH-nacluV
M O D
E L
:
G H
3 0
R a
d i
a l
F i
n
H o
t
T o
p
H e
a v
y
D u
t y
G a
s
R a
n g e
0872A
1009OSI
F-31510 (05/06)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
MODEL GH30
RADIAL FIN HOT TOP HEAVY DUTY GAS RANGE
ACCESSORIES
17" high stainless steel backguard. (Common backguards available up to 102" wide.)
23" high stainless steel single deck high shelf. (Common high shelves available up to 72" wide.)
35" high stainless steel double deck high shelf. (Common high shelves available up to 72" wide.)
Additional oven rack(s). Gas pressure regulator (specify size and type of gas). Flexible gas hose with quick disconnect and restraining
device. Consult price book for available sizes.
IMPORTANT
1. A gas pressure regulator suitable for battery or single unit application must be furnished and installed. Natural gas
6.0" W.C., propane gas 10.0" W.C.
2. An adequate ventilation system is required for commercial cooking equipment. Information may be obtained by writing to the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269. When writing refer to NFPA No. 96.
3. These units are manufactured for installation in accordance with ANSZ223.1a (latest edition), National Fuel Gas Code. Copies may be obtained from the American Gas Association, 1515 Wilson Blvd., Arlington, VA 22209.
4. All models require a 6" (152 mm) clearance at both sides and rear adjacent to combustible construction.
5. For proper ueing a backguard or high shelf must be installed with each unit. Please refer to spec sheet F31537 for specic styles and sizes.
6. This appliance is manufactured for commercial installation only and is not intended for home use.
MODEL
GH30
GH30C
GH30S
TOP: 45,000
TOP: 45,000
TOP: 45,000
GAS RATED INPUT BTU/hr.
OVEN: 50,000 TOTAL: 95,000
OVEN: 35,000
OVEN: N/A
TOTAL: 77,000
TOTAL: 45,000
WIDTH
34" 39
34" 39
34" 39
DEPTH
1
" 36"
8
1
" 36"
8
1
" 36"
8
WKG. HEIGHT
APPX. SHP. WT.
65O lbs./299 kg
720 lbs./326 kg
UNKNOWN
NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and specications without notice.
F-31510 (05-06)
VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. 1-800-814-2028
502-778-2791 QUOTE & ORDER FAX: 1-800-444-0602
Printed On Recycled Paper
Loading...