Vulcan GDC24 User Manual

Item # __________________________

C.S.I. Section 11420

GDC SERIES

GAS DUPLEX™ COOKER

GENERAL INFORMATION: Vulcan duplex cookers combine a
flat griddle surface with a swing-down heated top platen to provide
two sided cooking. Griddles are available in 24", 36", 48", 60" and
72" widths. Top platens have a removable cooking shoe with a
non-stick cooking surface. Top platens may be specified over any
portion or all of the griddle plate.

STANDARD FEATURES

■ Stainless steel front, sides, back splashers and 4" legs.

■ Spatula width front grease trough feeds into two removable

side mounted stainless steel grease collectors.

■ 1" thick rolled steel griddle plate, machine ground and
polished.

■ 30,000 BTU/hr. input for each 12" of griddle width.

■ Electronic pilot ignition.

■ One solid state temperature control for each 12" of griddle

width. Step-down transformer provided for control circuit.

■ Gas pressure regulator and manual shut-off valve.

■ Top platens with removable non-stick cooking shoes available

in 208 volt, 1 or 3 phase, 2.0 KW input, or 240 volt, 1 or 3 phase,

2.67 KW input.

■ One solid state temperature control for each top platen.
Step-down transformer provided for control circuit.

■ Counter balanced lift assists hold each platen in the “UP”
position when raised.

■ 135 day warranty on the non-stick surface of the cooking shoe,
one year limited parts and labor warranty on the balance of
the unit.

Vulcan-Hart Co.

ISO9001

A2780

SPECIFICATIONS:

Combination gas and electric two sided duplex cooker, Vulcan­Hart model no. GDC _________. Base griddle unit has stainless
steel front, sides, back splashers and 4" legs. (24")(36")(48")
(60")(72") wide 1" thick steel griddle plate is machine ground
and polished. Spatula width front grease trough feeds into two
removable side mounted stainless steel grease collectors.
30,000 BTU/hr. input for each 12" of griddle width. Electronic pilot
ignition. One solid state temperature control for each 12" of griddle
width. Step-down transformer provided for control circuit. Gas
pressure regulator and manual gas shut-off valve.

Top cooking platens located in position(s) (specify from left to
right: A, B, C, D, E, F). Counter balanced lift assists hold each
individual plate in the “UP” position when raised. Each platen has
a removable cooking shoe with a non-stick cooking surface. (2
KW, 208 volt, 1 or 3 phase) (2.67 KW, 240 volt, 1 or 3 phase) input
per platen. One solid state temperature control for each top
platen. Step-down transformer provided for control circuit.

Listed by U L and NSF.

SPECIFY VOLTAGE, PHASE AND TYPE OF GAS WHEN
ORDERING. SPECIFY ALTITTUDE WHEN ABOVE 2,000 FT.

VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. [phone]

F-31833 (12-01)

502-778-2791 QUOTE & ORDER FAX: [phone]

OPTIONS

■■ Stainless steel floor stand with 6" legs and undershelf.

■■ Set of four 4" diameter casters (two locking) for floor stand.

■■ Towel bar.

3

■■ 7

⁄8" wide cutting board. (NOTE: Cutting board is not available

on models that have a towel bar).

■■ Power cord connection. Specify NEMA plug configuration

(15-50 or 15-60). Available on 24", 36" and 48" models only.
Direct wire connection required on 60" and 72" models.

ACCESSORIES

■■ Flexible gas hose with quick disconnect and restraining

device. Consult price book for available sizes.

GDC SERIES

Gas Duplex

™ Cooker

GDC SERIES

GAS DUPLEX™ COOKER

IMPORTANT

1. A gas pressure regulator sized for this unit is installed.

2. An adequate ventilation system is required for commercial
cooking equipment. Information may be obtained by writing
to the National Fire Protection Association, Batterymarch
Park, Quincy, MA 02269.

When writing refer to NFPA No. 96.

3. All models require a 6" clearance at both sides and rear
adjacent to combustible construction.

NOTE: Floor models are shipped with 4" adjustable casters.
Specify if adjustable bullet style legs are desired in place of
casters.

Counter models are shipped with adjustable 6" legs. Counter
models are designed to be used on either a refrigerated base
or a stand. Counter models must be installed with legs in place
to insure space height is correct for platens to swing up freely.

NOTE: In line with its policy to continually improve its products, Vulcan-Hart Company reserves the right to change materials and
specifications without notice.

F-31833 (12-01)

VULCAN-HART COMPANY, P.O. BOX 696, LOUISVILLE, KY 40201, TEL. [phone]

502-778-2791 QUOTE & ORDER FAX: [phone]

Printed On Recycled Paper