Vulcan CEM20U User Manual

STEAM
Model CEM20U
SPECIFICATIONS
Electric heated combination oven convection steamer, Vulcan­Hart Model No. CEM20U. Stainless steel interior and exterior. Cooking compartment is fully welded stainless steel with fully coved and large radius corners and interior light. Removable 10 position pan rack assembly with 1 wire rack. Door is welded stainless steel for strength with sealed door hinges. Single pane glass mounted in door with hinged oating inner reective glass panel with full perimeter silicone gasket. Door is cool to the touch and includes a mounted drip tray. Deluxe manual control with seven position master control (convection cooking, steam cooking, thermostat controlled steam cooking, combination cooking, warming-rethermalization, cool down and off), vent control. Temperature selection range: 68° to 518°F in convection cooking, 212° to 518°F combination cooking, or 68° to 212°F in ther mo stat controlled steam cooking. Two position humidity control and two speed convection fan. Automatic shut-down at elapsed time with audible buzzer which continues until manually shut off. 4" stainless steel legs with counter feet.
Exterior Dimensions:
53"w x 45"d x 42"h on 4" legs. 53"w x 45"d x 64"h on oven support.
UL listed. UL listed to Canadian safety standards. Classied by UL to NSF Std. #4.
Item # C.S.I. Section 11420
CEM20U
ELECTRIC COMBI OVEN
CEM20U 10 level, full size
STANDARD FEATURES
Stainless steel interior and exterior.
Cooking compartment is fully welded stainless steel with fully coved and large radius corners and interior light.
Removable 10 position pan rack assembly with 1 wire rack.
Door is welded stainless steel for strength with sealed door hinges. Single pane glass mounted in door with hinged oating inner reective glass panel with full perimeter silicone gasket. Door is cool to the touch and includes a mounted drip tray.
Deluxe manual control with seven position master control (convection cooking, steam cooking, thermostat controlled steam cooking, combination cooking, warming-rethermalization, cool down and off).
Temperature selection range: 68° to 518°F in convection cooking, 212° to 518°F combination cooking, or 68° to 212°F in ther mo stat controlled steam cooking.
Two position humidity control and two speed convection fan.
Automatic shut-down at elapsed time with audible buzzer which continues until manually shut off.
4" stainless steel legs with counter feet.
Requires 208 or 240 volts, 60 Hz, 3 phase power supply.
One year limited parts and labor warranty.
OPTIONS
Correction facility package:
a. Security type tamper resistant fasteners with tack
welds. b. Control cover with hasp (lock by others). c. No internal product probe.
480 volts, 60 Hz, 3 phase.
Second year extended limited parts and labor warranty.
ACCESSORIES (Packaged & Sold Separately)
Stainless steel oven support.
Product probe kit (eld installed).
Core probe for vacuum package 2MM.
Flexible water connection with (3⁄4" NSHT) - 2 required.
External oven spray with retractable hose.
Wire racks. Qty.______.
12 x 20 Wire basket. Qty.______.
Chicken rack. Qty.______.
Water treatment system.
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F-37465 (09/10)
STEAM
CEM20U
ELECTRIC COMBI OVEN
WATER QUALITY STATEMENT
The fact that a water supply is potable is no guarantee that it is suitable for steam generation. Your water supply must be within these general guidelines:
SUPPLY PRESSURE 20 - 60 psig HARDNESS* less than 3 grains SILICA less than 13 ppm TOTAL CHLORIDE less than 4.0 ppm CHLORINE & CHLORAMINES 0 ppm pH RANGE 7-8 UN-DISSOLVED SOLIDS less than 5 microns * 17.1 ppm = 1 grain of hardness
Other factors affecting steam generation are iron content, amount of chlorination and dissolved gases. Water supplies vary from state to state and from locations within a state. Therefore it is necessary that the local water treatment specialist be consulted before the installation of any steam generating equipment.
CLEARANCES
Rear - 6", Left Side - 2", Right Side - 6"
Allow for sufcient distance if a “high heat source” (i.e. Broiler) is • located next to the unit.
Allow for sufcient clearance on right side for service access • (contact the factory service department for recommendations).
Installation must comply with all local re and health codes.•
ELECTRICAL RATING
208V/60/3 240V/60/3 480V/60/3
KW AMP KW AMP KW AMP
19 55 24 58 22.1 27
SERVICE CON NECTIONS
E Electric connection: Single point supply 2" (51 mm) dia.
(3⁄4" - 19 mm strain relief).
C1 Cold water connection: 3⁄4" NSHT for generator feed. Inlet
water pressure between 20 and 60 psi (138-414 kPa).
C2 Cold water connection: 3⁄4" NSHT for cold water condenser.
Inlet water pressure between 20 and 60 psi (138-414 kPa).
D Drain: Condensate box, compartment and boiler 11⁄2" NPT.
(Provide an open air type drain within 12" of condensate box and for best results at a distance so that steam vapors will not enter the steamer from underneath the control area. Do not connect solidly to any drain connection.)
NOTE
Dimensions which locate the above connections have a tolerance • of + or -3" (+ or -75 mm).
Installation of backow preventers, vacuum breakers and other • specic code requirements is the responsibility of the owner and installer. It is the responsibility of the owner and installer to comply with local codes.
Do not use plastic drains. • This appliance is manufactured for commercial installation only •
and is not intended for home use.
PAN CAPACITY
STEAM TABLE PANS BAKE PANS
12" x 20" x 21⁄2" 12" x 20" x 4" 18" x 13" 18" x 26"
20 10 20 10
P.O. Box 696 ■ Louisville, KY 40201 ■ Toll-free: 1-800-814-2028 ■ Local: 502-778-2791 ■ Quote & Order Fax: 1-800-444-0602
F-37465 (09/10)
NOTE: In line w ith its p olicy to continually imp rove its products, Vulcan rese rves the right to change m ateri als and s pecicatio ns without noti ce.
Loading...