VTech TR08-2013, TR06-2013, TR05-2013, TR02-2013, TR07-2013 User Manual
User’s manual
T
Compatible with
Hearing Aid T-Coil
TIA-1083
TR02-2013/TR05-2013/
TR06-2013/TR07-2013/
TR08-2013
DECT 6.0 accessory handset
for use with VTech models
TR1-2013/TR16-2013/TR17-2013/
TR2-2013/TR26-2013/TR27-2013
Congratulations
on purchasing your new VTech product. Before using this telephone, please read
Important safety instructions on page 5 of this manual.
This manual has instructions on how to set up and register your new handset.
For abridged instructions on using the handset, see the Abridged user’s manual
that came with your telephone base.
You may also view or download the online User’s manual for a full set of
installation and operation instructions at www.vtechphones.com.
In Canada, visit www.vtechcanada.com.
Telephones identified with this logo have reduced noise and
interference when used with most T-coil equipped hearing
aids and cochlear implants. The TIA-1083 Compliant Logo is
a trademark of the Telecommunications Industry Association.
Used under license.
The ENERGY STAR® program (www.energystar.gov) recognizes
and encourages the use of products that save energy and help
protect our environment. We are proud to mark this product with
the ENERGY STAR® label indicating it meets the latest energy
efficiency guidelines.
Register online to get an additional 3-month warranty!
Visit www.vtechphones.com.
Registration
Register your product online for enhanced warranty support.
Product news
Learn about the latest VTech products.
BC
1
Parts checklist
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
CR1232
Battery Pack / Bloc-piles :
(2.4V Ni-MH)
WARNING / AVERTISSEMENT :
DO NOT BURN OR PUNCTURE BATTERIES.
NE PAS INCINÉRER OU PERCER LES PILES.
Made in China / Fabriqué en chine
THIS SIDE UP / CE CÔTÉ VERS LE HAUT
CR1232
Your telephone package contains the following items. Save your sales receipt and
original packaging in the event warranty service is necessary.
Handset
Handset charger and
charger adapter
Handset battery
compartment cover
User’s manual
User’s manualHandset battery
Battery installation
Install the battery as shown below.
Plug the battery connector securely
1. Place the battery with the label
into the socket.
2.
THIS SIDE UP facing up and
the wires inside the battery
compartment.
Slide the battery compartment cover
3. Place the handset in the telephone
towards the center of the handset
4.
base or charger to charge.
until it clicks into place.
CHARGE light
remains on when
charging.
If the handset will not be used for a long time, disconnect and remove the battery
•
to prevent possible leakage.
To purchase a replacement battery, visit our website at www.vtechphones.com
•
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or
call 1 (800) 267-7377.
2
Battery charging
Once you have installed the battery, the screen indicates the battery status (see
the table below).
For best performance, keep the handset in the telephone base or charger
•
when not in use.
The battery is fully charged after 10 hours of continuous charging.
•
If you place the handset in the telephone base or the charger without
•
plugging in the battery, the screen displays No Battery.
Battery indicators Battery status
The screen is blank, or
displays Put in charger
and flashes.
The screen displays
Low battery and flashes.
The screen displays
HANDSET X.
The battery has no or very little
charge. The handset cannot
be used.
The battery has enough charge
to be used for a short time.
The battery is charged. To keep the battery
Charge without interruption
(at least 30 minutes).
Charge without interruption
(about 30 minutes).
charged, place it in the
telephone base or charger
when not in use.
Action
When the battery is fully charged, you can expect the following performance:
Operation Operating time
While in use (talking*) Up to 7 hours
While in speakerphone mode (talking*) Up to 3.5 hours
While not in use (standby**) Up to 5 days
* Operating times vary depending on your actual use and the age of the battery.
** Handset is not charging or in use.
Add and register a handset
This telephone system accommodates up to five handsets. Each new handset must
be registered with the telephone base before use. Additional handsets registered to
the telephone base are assigned numbers in the sequential order.
When first purchased and properly charged, each expansion handset shows
To register HS... and ...see manual alternately. Charge the handset before
registering it to the telephone base.
To register a handset:
Place the new/non-registered handset in the telephone base.
1.
Do not place the
handset in the charger.
2. After about 10 seconds, the handset displays Registering... When the
registration process completes, the handset displays Registered and you hear
a beep. The registration process takes about 90 seconds to complete.
3
Loading...