© 2015 VTech
Printed in China
91-003022-001
User’s Manual
Garage
2
SMARTPOINT®
TOW TRUCK
ELECTRONIC GATE
ON/OFF/VOLUME
CONTROL SWITCH
3 LIGHT-UP
BUTTONS
LIFT/
LAUNCHER
HELICOPTER
PA D
VEHICLE LIFT
9 SMARTPOINT
®
LOCATIONS
INTRODUCTION
Thank you for purchasing the VTech® Toot-Toot Drivers® Garage!
Park, play and learn with the Toot-Toot Drivers® Garage. This
interactive garage features three floors of pretend play and learning fun.
INTRODUCTION
33
INCLUDED IN THIS PACKAGE
INCLUDED IN THIS PACKAGE
One lift tower One vehicle lift
One welcome gate
One SmartPoint®
tow truck
One SmartPoint
®
car wash
One curved ramp track One straight ramp track
One ground floor
SmartPoint® platform
One first floor
SmartPoint® platform
One second floor
SmartPoint® platform
One fuel accessory
4
INCLUDED IN THIS PACKAGE
Two male/female connector tracks
Two male connector tracks
One 90-degree female track
One 90-degree male track
One lift support piece
One user’s manual
Two label sheets
One snap-in large support
One medium support
One snap-in small support
One mini support
Two snap-in mini supports
x2
5
GETTING STARTED
BATTERY INSTALLATION – TOW TRUCK
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the bottom
of the tow truck. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new “AAA” (AM-4/LR03)
batteries following the diagram inside
the battery box. (The use of new
alkaline batteries is recommended for
maximum performance.)
4. Replace the battery cover and tighten
the screw to secure.
GETTING STARTED
CAUTION:
Adult assembly required. For your child’s safety, do
not let your child play with the toy until it is fully
assembled.
WARNING:
All packing materials, such as tape, plastic sheets, packaging
locks and tags are not part of this toy, and should be discarded
for your child’s safety.
NOTE:
Please keep this user’s manual as it contains important
information.
Unlock the packaging locks:
Turn the packaging lock counter-clockwise
several times.
Pull out and discard the packaging lock.
6
BATTERY INSTALLATION - GARAGE
1. Make sure the unit is turned OFF.
2. Locate the battery cover on the top
platform of the Garage. Use a coin or a
screwdriver to loosen the screw.
3. Install 2 new ‘AA’ (AM-3/LR6) batteries
following the diagram inside the
battery box. (The use of new alkaline
batteries is recommended for maximum
performance.)
4. Replace the battery cover and tighten the
screw to secure.
BATTERY NOTICE
• Usenewalkalinebatteriesformaximumperformance.
• Useonlybatteriesofthesameorequivalenttypeasrecommended.
• Donotmixdifferenttypesofbatteries:alkaline,standard(carbon-
zinc) or rechargeable (Ni-Cd, Ni-MH), or new and used batteries.
• Donotusedamagedbatteries.
• Insertbatterieswiththecorrectpolarity.
• Donotshort-circuitthebatteryterminals.
• Removeexhaustedbatteriesfromthetoy.
• Removebatteriesduringlongperiodsofnon-use.
• Donotdisposeofbatteriesinfire.
• Donotchargenon-rechargeablebatteries.
• Remove rechargeable batteries from the toybefore charging (if
removable).
• Rechargeablebatteries are only to be charged under adult
supervision.
BATTERY NOTICE
7
LABEL INSTRUCTIONS
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked, indicate
that the battery contains more than the specified value of
mercury (Hg), cadmium (Cd) or lead (Pb) set out in Battery
Directive (2006/66/EC).
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Help protect the environment by disposing of your product
or batteries responsibly.
Formoreinformation,pleasevisit:
www.recycle-more.co.uk
www.recyclenow.com
Please stick the labels to the play set securely as
indicated on the following page:
1
4
5
6
8
8
9
10
7
11
12
2
16
17
13
14
15
8
9
2
17
16
5
10
13
15
11
14
12
6
1
4
7
LABEL INSTRUCTIONS
8
9
ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
With the VTech®
Toot-Toot Drivers® Garage safety comes first. To
ensureyourchild’ssafety,adultassemblyisrequired.
1. With the ground floor platform right-side up, insert the two snap-in
mini supports into the slots on the ground floor platform as shown.
The snap-in mini supports will fit in the slots snuggly. The teeth on
the snap-in mini supports will grip to the ground floor platform.
2. With the rst oor platform upside-down, insert the snap-in small
support into the slot on the rst oor platform as shown. The snapin small support will t in the slot snuggly. The tooth on the small
support will grip to the rst oor platform.
10
3. Turn the first floor platform right-side up. Next, connect the open first
floor platform support slots to the snap-in mini supports attached
to the ground floor platform as shown. Press down to make sure
the pieces are securely connected.
4. Insert the bottom of the vehicle lift into the first floor platform as
shown. You will hear a click sound to indicate the vehicle lift is
secure. Once the vehicle lift is connected to the first floor platform,
it cannot be detached.
5. Insert either side of the mini support into the slot on the first floor
platform as shown.
ASSEMBLY INSTRUCTIONS
11
6. With the second floor platform upside-down, insert the snap-in large
support into the largest slot on the second floor platform as shown.
The snap-in large support will fit in the slot snuggly. The tooth on
the snap-in large support will grip to the second floor platform.
7. Turn the second floor platform right-side up. Next, line-up the
vehicle lift and mini support with the second floor platform slot
openings as shown. Then, press down on the second floor platform
to secure it to the vehicle lift and mini support.
8. Attach the curved ramp track to the first floor platform and second
floor platform as shown.
ASSEMBLY INSTRUCTIONS
12
9. Insert the medium support into the slot on the bottom of the curved
ramp track as shown.
10. Attach the straight ramp track into the first floor platform as shown.
11. Attach the lift tower to the second floor platform. First, connect
the track portion of the second floor platform to the back of the lift
tower as shown. Next, connect the open slot on the lift tower to the
connecter piece on the second floor platform as shown. You will
hear a click sound to indicate the lift tower is secured to the second
floor platform. Once the lift tower is connected to the second floor
platform, it cannot be detached.
ASSEMBLY INSTRUCTIONS
13
12. Attach the fuel accessory to the second floor platform as shown.
You will hear a click sound to indicate the fuel accessory is secured
to the second floor platform. Once the fuel accessory is connected
to the second floor platform, it cannot be detached.
13. Attach the welcome gate to the second floor platform as shown.
14. With the lift/launcher at the base of the lift tower, attach the lift
support piece to the lift tower as shown. You will hear a click sound
to indicate the lift support piece is secured to the lift tower. Once
the lift support piece is connected to the lift tower, it cannot be
detached.
ASSEMBLY INSTRUCTIONS
14
Once you’ve completed the above steps, you are ready to play! You
can connect these pieces to the other included track pieces or you
can connect this play set to other Toot-Toot Drivers® play sets (each
sold separately).
ExPAND & ExPLORE
Connect to the
Toot-Toot Drivers®
Deluxe Track Set
(as shown
below) or other
Toot-Toot Drivers® play sets (each sold separately) to
expand the Toot-Toot Drivers Garage and inspire creativity.
PRODUCT FEATURES – TOW TRUCK
1. ON/OFF SWITCH
To turn the tow truck ON, slide the
ON/OFF SWITCH on the tow truck
to the ON ( ) position. To turn the
tow truck OFF, slide the ON/OFF
SWITCH to the OFF ( ) position.
PRODUCT FEATURES – TOW TRUCK
15
2. AUTOMATIC SHUT-OFF
To preserve battery life, the tow truck included with the VTech®
Toot-Toot Drivers® Garage will automatically power-down after
approximately 65 seconds without input. The unit can be turned
on again by pressing the light-up face button or pushing the tow truck
quickly.
Note: This product is in try-me mode in the packaging. After opening
the package, turn the vehicle off and on again to proceed with
normal play.
ACTIVITIES – TOW TRUCK
1. Slide the ON/OFF SWITCH to the ON
position to turn the unit ON. You will
hear a song, a phrase and sounds.
The light will flash with the sounds.
2. Press the light-up face button to
hear tow truck sounds, songs and
phrases. The light will flash with the
sounds.
3. Push the tow truck to hear fun
sounds, and melodies. While the
melody is playing, push the vehicle
again to add in fun sounds on top of
the melody. The light will flash with
the sounds.
ACTIVITIES – TOW TRUCK
16
PRODUCT FEATURES - GARAGE
4. For added fun, the tow truck interacts with the Toot-Toot Drivers®
Garage. Simply roll or place the tow truck on one of the play set’s
SmartPoint® locations to hear the tow truck play fun sounds, short
tunes and sing-along songs. The tow truck even interacts with other
Toot-Toot Drivers® play sets (each sold separately).
PRODUCT FEATURES - GARAGE
1. ON/OFF/VOLUME CONTROL SWITCH
To turn the unit ON, slide the ON/
OFF/ VOLUME CONTROL SWITCH
to the low volume ( ) or high
volume ( ) position. To turn the unit
OFF, slide the ON/OFF/VOLUME
CONTROL SWITCH to the OFF ( )
position.
2. SMARTPOINT® LOCATIONS
The Garage includes 9 SmartPoint® locations
that interact with the included tow truck or
any other Toot-Toot Drivers® SmartPoint®
vehicle (each sold separately). Simply roll or
place the vehicle over a SmartPoint® location
to hear fun sounds, phrases and music.
3. AUTOMATIC SHUT-OFF
To preserve battery life, the VTech® Toot-Toot Drivers® Garage will
automatically power-down after approximately 55 seconds without
input. To wake up the unit, activate any of the electronic features
on the play set.
17
ACTIVITIES - GARAGE
ACTIVITIES - GARAGE
1. Slide the ON/OFF/VOLUME
CONTROL SWITCH to either
volume setting to turn the unit on.
You will hear a song, phrase and fun
sounds. The lights will flash with the
sounds.
2. Press the LIGHT-UP BUTTONS to
hear fun phrases, sounds, songs
and melodies. While a melody is
playing, press any of the 3 LIGHT-
UP BUTTONS to add in fun sounds
on top of the melody. The lights will
flash with the sounds.
3. Place a vehicle on the LIFT/
LAUNCHER, and rotate the
HELICOPTER PAD clockwise or
counter-clockwise. Based on the way
the HELICOPTER PAD is rotated,
the LIFT/LAUNCHER will go up or
down the LIFT TOWER. As the LIFT/
LAUNCHER reaches each floor you
will hear fun sounds and phrases.
When the LIFT/LAUNCHER reaches
the second floor, it will trigger the
launcher button.
18
ACTIVITIES - GARAGE
4. Raise the VEHICLE LIFT up to hear
fun sounds. The lights will flash with
the sounds.
5. Raise the ELECTRONIC GATE up
or down to hear fun sounds and a
phrase. The lights will flash with the
sounds.
SING-ALONG SONG LYRICS
Garage
SONG 1
Here’s your parking ticket,
Drive on through.
Enjoy your stay.
There is so much to do!
SONG 2
Ride the lift floor to floor.
There are so many fun things to explore.
SONG 3
Fill up here,
Parking there,
Thanks for visiting and please take care!
19
MELODY LIST / CARE & MAINTENANCE
MELODY LIST
Garage
1. Alexander’s Ragtime Band
2. Green Grass Grew All Around
3. Bicycle Built for Two
4. Chicken Reel
5. Farmer in the Dell
6. It’s Raining, It’s Pouring
7. Muffin Man
8. Where Has My Little Dog Gone
9. One, Two, Buckle My Shoe
10. Polly Wolly Doodle
11. Shoo Fly
12. Ten Little Indians
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2.
Keep the unit out of direct sunlight and away from any direct heat
source.
3. Remove the batteries when the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
20
TROUBLESHOOTING
If for some reason the program/activity stops working or malfunctions,
pleasefollowthesesteps:
1. Please turn the unit OFF.
2. Interrupt the power supply by removing the batteries.
3. Let the unit sit for a few minutes, then replace the batteries.
4. Turn the unit ON. The unit should now be ready to play again.
5. If the product still does not work, replace with an entire set of new
batteries.
If the problem persists, please call our Consumer Services Department
on 01235 546810 (from UK) or +44 1235 546810 (outside UK) and a
service representative will be happy to help you.
IMPORTANT NOTE:
Creating and developing VTech
®
products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to call our Consumer Services Department on 01235 546810
(from UK) or +44 1235 546810 (outside UK), with any problems
and/or suggestions that you might have. A service representative
will be happy to help you.
TROUBLESHOOTING
Loading...