Voodoo Lab Pedal Power 2 Plus User Manual

™

PEDAL POWER

®

2

PLUS

User’s Manual

Please visit our web site at:

www.voodoolab.com

Copyright ©1998-2010 by Digital Music Corporation.
This publication is protected by copyright and all rights are reserved.
Voodoo Lab and Pedal Power are trademarks of Digital Music Corp.

rev 3/15/10

VOODOO LAB PEDAL POWER

User’s Manual

Introduction

The Voodoo Lab Pedal Power 2 Plus is the finest power supply
available for guitar effects. It’s eight 9V outputs will power any
type of battery operated effect. Each output is completely isolated,
short-circuit protected, highly filtered and regulated. This insures
reliable operation, free of hum and noise.

Pedal Power 2 Plus includes two high current outputs, capable of
properly powering newer high power effects such as Boss Twin,
Line 6 modelers, and TC Electronic Nova pedals. It also features
two variable voltage outputs to simulate worn batteries. Using an
optional voltage doubler cable, you can power many 18V and 24V
effects as well.

Please take the time to read this entire manual before operating
your Voodoo Lab Pedal Power. This will eliminate the possibility
of damage to your effects from improper usage. You can also visit
our web site at www.voodoolab.com for the latest information on
this and other products.

Important: Pedal Power units purchased in North America should
only be powered from 120VAC. Attempting to use 220-240VAC
mains directly will cause permanent damage to your Pedal Power!
You must use an appropriate stepdown transformer.

Unpacking

Your Voodoo Lab Pedal Power box should contain the following:
Pedal Power 2 Plus system unit
Warranty card
AC power cord
DC Power cables:

5.5x2.1mm right angle barrel connectors (6)

5.5x2.1mm straight barrel connectors (2)

5.5x2.5mm “red” barrel (1)

3.5mm mini plug (1)
9V battery snap (1)

Please take a moment to fill out and mail your warranty card. This
will register your warranty, make you eligible for technical support,
and allow us to notify you with updates and new product information.
Don’t worry, we respect your privacy and never sell our mailing list.

System Unit Description

1. AC auxiliary. This is a courtesy AC outlet for convenient
powering of AC powered effects or a MIDI foot controller.
Note the 200 watt maximum rating. Do NOT plug in your
amp here!

2. AC power input jack. This is a standard “IEC-type” connector.