VOLTCRAFT PL-125-T4USB User guide

Manual

Pic 1

Photo

Operation

temperature calibration procedure:
Press and hold the Unit button and power on the meter.The meter is with full

display now, keep pressing the Unit buton and press the Setup upper button, wait
for REL is displayed, release the Unit button first, and thence release the MAX/MIN

to start calibration. You can press the UP & DOWN button to adjust the room

temperature, press ENTER to confirm the data you desire.

Type-K probe temperature calibration, please refer to the user manual,T1/T2 Offset
in the Setup

time setting:
Power on the meter and hold the SET button, thence press REC button to enter K, J
switching mode, press UP and Down button for setting, and then press REC to display

SLP(Pic.1), this means Auto Power Off setting. Press the UP & DOWN button to set,
And thence press REC to the time setting mode (Pic 2), press MAX/MIN to set the
the data which is flash.

Pic 2