VocoPro Club-8000 User Manual
1
2
4
3
Quick Start
CLUB-8000
Quick Reference Setup Guide
This quick reference guide is provided to help you set up your
CLUB-8000 system for the first time. It contains instructions
on setting up the products that are included in the
8000. If you are connecting any additional gear that is not
included in the
for detailed instructions.
CLUB-8000, refer to the appropriate manuals
Gathering Package Contents
The first step to putting together your new CLUB-8000 system is unpacking all of the necessary equipment. Remember to keep your manuals nearby when setting up, as you may need to reference them. The products listed below are
included in the CLUB-8000 system:
CLUB-
CDG-9000 PRO
• 1 Control interface connector wire
• [1] Instruction Manual
KJM-8000+ 9-Channel Digital Key Control KJ/DJ Mixer
• [1] Instruction Manual
VP-2100 PRO 2000W Professional Power Amplifier
• [1] Instruction Manual
VX-15 Vocal Speakers
• [4] VX-15 speakers
Mounting components into the CLUB-8
Follow these basic guidelines when mounting:
• Always screw in the mounting screws using an “X” formation.
• If possible, to keep the products cooler, leave some space in
between the components in the rack.
VSP-M1 Multi-Effect Digital Signal Processor/Mixer
• 1 Instruction manual
SS-88 Speaker Stands
• [4] SS-88 speaker stands
CLUB-8 Road Case
• [1] CLUB-8 road case
• [1] Rolling cart
• [2] MK-38 PRO microphones
• [1] Gooseneck DJ light
• 1 RCA to 1/4” Patch Cable (3.3 ft paired)
• Rack-mounting screws
Below is one way to configure your CLUB-8000:
CDG-9000 PRO CONTROLLER
KJM-8000+ MIXER
On the web at www.vocopro.com
or call toll free 1-800-678-5348
CDG-9000 PRO PLAYER
VP-2100 PRO AMPLIFIER
Setting up the speakers and speaker stands
1. Setup each SS-88 speaker stand by extending the support
legs to a position that is stable and tighten the tension mecha
nism firmly.
2. Place a VX-15 speaker on top of the SS-88 so that the
shaft of the SS-88 fits flush into the mounting cavity on the
bottom of the VX-15.
NOTE: Each end of the SS-88 pole has a particular diameter
fitted for common speakers’ mounting cavities. If the SS-88
shaft does NOT fit flush into the mounting cavity on the VX-15,
loosen the SS-88 pole and reverse it in the stand and then
remount the speaker.
3. Repeat the above steps for each speaker and stand.
-
VX-15 Speaker
1 1/4”
1 3/4”
SS-88 Stand
Connecting Power
Be sure that each product has a power cord firmly attached. It is recommended that you use a power strip/surge protector
when connecting your CLUB-8000 to a power outlet.
Connecting the components
Once you have mounted all of the components into the CLUB-8, it is time to connect them. Follow these directions on connecting the components.
NOTE: If you are also connecting components that are not part of the CLUB-8000 system, please refer to the manual of that
product for setup instructions.
MAKE SURE ALL PRODUCTS ARE POWERED OFF
PRIOR TO CONNECTING TO AN AC OUTLET
CDG-9000 PRO remote unit to the player unit
1
Connect the Control Interface Connector from “CONNECT TO MAIN UNIT” jack on the rear panel of the remote unit to the
“CONNECT TO REMOTE CONTROLLER” jack on the rear panel of the player unit.
CDG-9000 PRO Controller
CDG-9000 PRO Player
Loading...