VIZIO VMT13-32 Owner's Manual
VMA13-32
Articulating Swingout Arm
VMT13-32
Tilt/Pivot Mount
Installation Instructions
Vizio
320 A Kalmus Dr.
Costa Mesa, CA 92626
Phone: (714) 668-0588
Fax: (714) 668-9099
www.vizioce.com
F
or use with Vizio LCD TVs from 13”-32”
VMA13-32 / VMT13-32
TABLE OF CONTENTS
Warning Statements 3
Parts List 4
Installation Tools 4
Backplate Installation- Wood stud 5
Backplate Installation - Concrete Surface 6
Mount Installation 7
Installing the Monitor 8
Adjusting the Swingout Arm 9
Adjusting the Tilt/Pivot Mount 10
Technical Specifications 11
Warranty 12
Contact Vizio 12
Page 2 Installation Instructions
VMA13-32 / VMT13-32
Installation Instructions Page 3
Warning Statements
WARNING: THE WALL STRUCTURE MUST BE CAPABLE OF SUPPORTING AT LEAST A MAXIMUM
WEIGHT OF 50 LBS. IF NOT, THE WALL MUST BE REINFORCED. PROPER INSTALLATION
PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN, AS OUTLINED IN THE INSTALLATION
INSTRUCTIONS, MUST BE ADHERED TO. FAILURE TO DO SO COULD RESULT IN SERIOUS
PERSONAL INJURY, OR EVEN DEATH.
W
ARNING
: SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE INSTALLATION OF
THIS PRODUCT. USE PROPER SAFETY GEAR AND TOOLS FOR THE INSTALLATION
PROCEDURE TO PREVENT PERSONAL INJURY.
WARNING
: PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS
SHOULD BE READ AND COMPLETELY UNDERSTOOD. THE INSTALLATION INSTRUCTIONS
MUST BE READ TO PREVENT PERSONAL INJURY AND PROPERTY DAMAGE. KEEP THESE
INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE
REFERENCE.
Indicates that the power plug is to be disconnected from the power outlet.
Safety precautions must be taken at all times.
Warning and Caution statements.
A secure structure must support the weight, or load, of the display. When mounting to a wall that contains
wooden studs, dead center of the wooden stud must be confirmed prior to installation.
Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could
result in damage to the display and/or damage to the mounting surface.
Do not install near heater, fireplace, direct sunlight, air conditioning or any other source of direct heat energy.
Failure to do so may result in damage to the display and could increase the risk of fire.
At least two qualified people should perform the installation procedure. Injury and/or damage can result from
dropping or mishandling the display.
Recommended mounting surfaces: wooden studs and solid-flat concrete. If the mount is to be installed on any
surface other than wooden studs, use suitable hardware (which is commercially available).
Contact VIZIO with any technical/ installation questions.
VMA13-32 / VMT13-32
Page 4 Installation Instructions
Parts List
NOTE: This mount is shipped with all installation hardware and components. Make sure that none
of these parts are missing and/ or damaged before beginning installation. If there are parts
missing and/or damaged, please stop and contact Vizio (714) 668-0588.
Installation Tools
Phillips Head Screw Driver Portable Drill
Soft Material/ Blanket Pencil
5/16” Drill Bit (for wedge anchors) Level
Tape Measure Stud Finder
Swingout Arm (1ea)
Mounting Backplate
(1ea)
1/4” Wedge Anchors
(4ea). These are used only
for concrete applications.
#14 x 2”Wood
Screws (4ea)
M4 x 10mm Phillips
Head Screws (4ea)
M3 Allen Wrench
M6 x 35mm Set Screw
(1ea)
Tilt/Pivot Mount (1ea)
OR*
*
This will depend on the product that was purchased.
14mm Socket
M4 x 16mm Phillips Head
Screws (4ea)
Loading...