Vizio V-128 User Manual

Vax V-128 User Guide.qxd:V-128 User Guide 14/4/08 16:01 Page 1

0870 6061248

Carpet cleaner

Vax model number:

V-128

Vax careline

www.vax.co.uk

instruction manual

Please read carefully before using this cleaner.

Always fully extend the mains cable before use.

Retain for future reference.

Vax V-128 User Guide.qxd:V-128 User Guide 14/4/08 16:01 Page 2

www.vax.co.uk

1. Diagram

V-128

12

11

10

1

2

3

4

5

16

6

9

7

13

Fig.1/1

1 Hand grip

2 Telescoping handle
3 Telescoping handle collar
4 Carry handle
5 On/Off switch
6 Solution tank
7 Tool connector / hose
8 Nozzle

2

parts overview

14

16

8

15

9 Recovery tank

10 Recovery tank lid

11 Float indicator window

12 Upper handle release button

13 Solution trigger (press to release cleaning solution)
14 Stair / upholstery tool
15 Handle release pedal
16 Cord hooks

!

Vax V-128 User Guide.qxd:V-128 User Guide 14/4/08 16:01 Page 3

ax Careline 0870 606 1248

V

2. Safety Information

FOR HOUSEHOLD USE ONLY.

When using the carpet washer, basic safety precautions
should always be observed, including the following:

1. Do not leave the carpet washer unattended when
plugged in. Unplug it from socket when not in use.

2. To prevent electric shock do not use outdoors.

3. Notto be usedas a toy. Childrenshouldbe supervisedto
ensure that they do not play with the appliance.

4. This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack ofexperienceand knowledge,
unless they have been given supervision or instruction
concerning the use of the appliance by a person
responsible for their safety.

5. Use only as described in this manual.

6. Do not use with a damaged cord or plug. If the supply
cord and/or plug is damaged, they must be replaced
by the manufacturer, a Vax Service Agent or similarly
qualified persons in order to avoid hazard.

7. Do not pull or carry by the cord, use the cord as a
handle, allow the cord to come into contact with hot
or sharp surfaces or close a door on the cord.

8. Do not unplug by pulling on the cord.

9. Do not handle the plug or carpet washer with wet
hands.

10. Do not put any objects into openings or operate with
openings blocked, keep them free of anything that
may reduce airflow.

11. Keep hair, loose clothing, fingers and all parts of the
body away from openings and moving parts.

12. Do not use the carpet washer on any glowing,
burning or smoking particles.

13. Do not use without the solution tank and dirty water
tank in place.

14. Turn off all controls before unplugging.

15. Do not use to pick up flammable or combustible
liquids such as petrol, or use in areas where they may
be present.

16. Keep the unit on the floor.

17. Do not use an extension cord.

18. Do not attempt to remove blockages with sharp
objects as they may cause damage.

19. Store indoors put away after use to prevent tripping
accidents.

20. Using improper voltage may result in damage to the
motor and possible injury to the user. The correct
voltage is listed on the rating label.

21. A hazard may occur if the carpet washer runs over
the power supply cord.

22. To prevent dirty water from running into motor, do
not hold the appliance upside-down or lay on its side.
Use appliance in normal vacuuming position.

23. Use extra care when cleaning on stairs.

24. Do not carry appliance while motor is running.

NOTE: Carpets should be dry vacuumed thoroughly
before washing.

NOTE: The unit must be unplugged from the mains
socket outlet after use, and before cleaning or
maintaining the unit.

NOTE: The brush bar will only rotate when the
machine is in the reclined floor cleaning position and
the power switch is on. The brushbar will turn off
when in tool mode or upright position.

IMPORTANT: This unit is not intended for
commercial use.

PLEASE KEEP THESE INSTRUCTIONS
FOR FURTHER USE.

safety information

3

!

Vax V-128 User Guide.qxd:V-128 User Guide 14/4/08 16:01 Page 4

www.vax.co.uk

3. Carpet Cleaner Basics

Unfold handle

Raise handle from storage position until it locks in place
(Fig.3/1).

Fig.3/4

Turn tank upside down and unscrew cap (B) (Fig.3/5). The
cap consists of 2 pieces - the cap ring (C) and the solution
tank valve (D).

Fig.3/1

Slide collar (A) up on telescoping handle (B) to adjust
handle to desired height (Fig.3/2).

B

A

B

Fig.3/2

Folding handle

Push up on the collar (A) to lower the telescoping handle.
Rotate knob (C) backwards to drop the handle into storage
position (Fig.3/3).

C

Fig.3/3

Filling the Solution Tank

IMPORTANT: Unplug carpet cleaner from electrical outlet.

Pull up on solution tank handle (A) and remove solution
tank (Fig.3/4).

A

A

C

Fig.3/5

Pour solution into tank to solution fill line (E) (Fig.3/6).

Fig.3/6

Fill tank completely with hot tap water (max 50°C).
Replace cap. Be sure the valve (D) is in the cap ring (C)
before screwing the cap back on the tank (Fig.3/5).

Place tank back onto cleaner (Fig.3/7), pressing firmly to
be sure tank is fully positioned.

CAUTION: Avoidsolution contactwith the eyes and

skin. In case of contact with eyes, flush with cold
water for 15 minutes. In case of contact with skin, wash
with water. If irritation persists, consult your GP.

D

E

4

unfolding handle / filling the solution tank