IP Surveillance
AA-351/AA-352
Surveillance Power/Junction Box
Installation Guide
Rev.: 1.0
CAUTION:
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
UNPACKING:
Unpack carefully. Electronic components can be damaged if improperly handled or
dropped. If an item appears damaged in shipment, place it properly in its carton and
notify the shipper.
IMPORTANT!:
1. The electrical connections and conduit installations shall be made by a certied electrician following
local regulations.
2. Risks of electric shock exist. The mains supply shall be disconnected before installation.
3. Read and follow Instructions: All operating and user instructions should be read and followed before
the unit is to be operated.
4. This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
the protective device is listed rated not greater than 20A.
5. Attach the ground wire (to external ground) to a suitable grounding point, e.g., an earth stake.
6. Observe national and local regulations for the installation.
7. To avoid additional accummulation of moisture, please avoid installing the components in cabinet
during a raining weather.
8. Only use applicable tools when installing this product; excessive force can damage the product.
9. Use only accessories compliant with the technical specications of the product.
10. When the need arises for transportting this product, it is recommended to use the original shipping
package.
Revision History:
Rev. 1.0: Initial release.
Mechanical Dimensions:
2
Applicable Mount & Brackets
I
Item Models Applicable Mount or Bracket
Junction box AM-718 AM-21D, AM-21E, AM-314, AM-315, AM-414
Power box AA-351
Power box AA-352
Wiring
II
Route your power wires through a 3/4" conduit into the power box. The wiring scheme is shown below.
The power supply converts 115/230V power to the AC24V output to IP cameras.
115V power
IMPORTANT!:
Do not power down and power up using the
power switch within 30 seconds. The power
charge does not dissipate immediately, and
the fuse will be burnt.
English
115V Line IN
Neutral
230V Line IN
AC24V outputNeutral
Ground
230V power
AC24V output
3
Introduction
III
The power box can be mounted with the AM-314, AM315 pole-mount, AM-414 corner-mount bracket, or
directed secured to a wall.
4
Installation
IV
Use the included M10 hex socket screws to secure the power box to a pole-mount or corner mount
bracket.
M10
AM-314
AM-315
AM-414
3/4” conduit
The mounting hole denition is illustrated below. The same mounting hole pattern apply to all pole-
mount and corner-mount brackets.
English
Box:
AM-351
AM-352
AM-718
Outdoor PoE switch:
AW-GEU-083A-240
AW-GET-083A-120
AW-GET-123A-240
AW-GEU-086A-240
AW-GET-086A-120
AW-GET-126A-240
AM-21D
AM-21E
5
If the power box is directly mounted to wall, drill holes in a diameter of 9.5mm or 3/8", and 4cm deep.
M8
Use the following mounting positions for the camera housings (via AM-21D and AM-21E).
AM-21D
AM-21E
6
This page is intentionally left blank.
English
7
This page is intentionally left blank.
8
Loading...