Vivo DESK-EP43TB User guide

Black 43" x 24" Electric Desk

Instruction Manual

SKU: DESK-EP43TB

Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.

https://vivo-us.com/products/desk-ep43tb

GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

[e-mail]

www.vivo-us.com 309-278-5303

Chat live with an agent!

WARNING!

If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual and do not exceed weight capacity. We cannot be liable for damage
or injury caused by improper mounting, incorrect assembly, or inappropriate use.

ELECTRICAL SAFETY INSTRUCTIONS

THIS PRODUCT IS POWERED BY ELECTRICITY. IN ORDER TO AVOID BURNS, FIRE AND ELECTRIC
SHOCK, PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY.

• DO NOT CLEAN PRODUCT WHILE POWER IS CONNECTED.

• DO NOT DISASSEMBLE OR REPLACE COMPONENTS WHILE POWER IS CONNECTED.

• NEVER OPERATE THE SYSTEM WITH A DAMAGED CORD OR PLUG. PLEASE CONTACT YOUR
SELLER TO REPLACE DAMAGED PARTS.

• NEVER OPERATE SYSTEM IN DAMP ENVIRONMENTS OR IF ANY ELECTRICAL COMPONENTS HAVE
MADE CONTACT WITH LIQUIDS.

• ALTERATIONS OF THE GIVEN POWER UNIT ARE NOT ALLOWED.

• OUTDOOR USE IS PROHIBITED.

WARNING: CHOKING HAZARD

SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.

PACKAGE CONTENTS

A (x1)

Telescopic

Crossbar

F (x1)

Sync Rod

K (x1)

Controller

P (x24)

Flat Head

Screw

S-D (x3)

Cable Clip

B x1)

Motorized Leg

G (x2)

Foot

L (x1)

Le Desktop

Q (x4)

Desktop

Connector

S-E (x12)

Anti-Vibration

Pad

C (x1)

Leg

H x1)

Adapter Holder

M x1)

Center Desktop

S-A (x16)

M6x12

S-F (x1)

Allen

Wrench

D (x1)

Crossbar

Spacer

I (x1)

AC Adapter

N (x1)

Right Desktop

S-B x12)

ST4.2x20 Screw

E (x2)

Side Bracket

J (x1)

Power Cable

O (x2)

Support Pad

S-C (x2)

ST3. 5x20 Screw

2

TOOLS NEEDED

Tape

Measure

DO NOT EXCEED WEIGHT CAPACITY.

Failure to do so may result in serious injury.

121lbs
(55kg)

Level

ASSEMBLY STEPS

STEP 1

Assemble the desktops (L, M, N) using the desktop connectors (Q) and flat head
screws (P). Tighten screws with a Phillips screwdriver.

STEP 2

Loosen the two set screws on the telescopic
crossbar (A) using the Allen wrench (S-F) and
partially extend the crossbar.

Phillips

Screwdriver

Drill

STEP 3

Place the crossbar spacer (D) on the motorized leg (B) as shown. Attach the telescopic crossbar to the
legs (B, C) as shown using M6x12mm bolts (S-A), and tighten with the Allen wrench (S-F). NOTE: Insert
all necessary screws into holes before tightening.

3