To mount your camera to a wall, follow the steps below.
FOR WOODEN WALLS OR STUDS
Use the included mounting screws for wooden walls or studs. They
will first go through the screw holes on the mounting plate, and then
screw into the wall.
FOR CONCRETE, BRICK OR STUCCO WALLS
Use the included mounting anchors for concrete, brick or stucco
walls. First screw the mounting anchors into the wall. Then the
mounting screws will go through the screw holes on the mounting
plate, and then screw into the mounting anchors.
Once the mounting plate is attached to the wall, attach your camera
to the mounting plate. Make sure the camera stays in place securely.
4.
APP INSTALLATION
In order to use your camera, you will first need to download the Vivitar
Smart Security 2 App, which is available on the Google Play Store and
on the iPhone App Store.
OR
iPhoneAndroid
Install
Vivitar
Smart
Security 2
App
5.
APP REGISTRATION
To successfully use the Vivitar Smart Security 2 App, you will first
need to create an account. To do so, follow the steps below.
Open the Vivitar
Smart Security 2 App
and press “Register.”
Enter your e-mail
address or phone
number to create an
account.
Agree to the terms of
the privacy policy.
You will receive a
verification code over
email or text message.
Enter it here.
Setup a password for your
account. Once finished,
you can login to your
account.
6.
APP SETUP
Once you login to your account, press “Create
Family” to store the location of your home and
describe the dierent rooms where your smart
home devices will be located.
7.
CAMERA SETUP
1. Near the bottom of your camera is a Micro USB port. Plug the
included USB cable into this port, and connect the other end to the
included power adapter.
30-60 seconds
2. Wait as your camera gets ready to enter Wi-Fi setup mode. This
might take up to a minute.
3. Once in Wi-Fi setup mode, your camera will emit a prompt
musical melody and then beep every few seconds.
For best results, insert a high
speed Micro SD memory card
between 8-64GB into the Micro
SD memory card slot when using
your camera.
NOTE: If you are having trouble connecting to Wi-Fi, press the
reset button for approximately 5 seconds to reset your camera.
The reset button can be accessed by sliding a pin or paper clip in
the recessed hole on the rear of your camera.
Wi-Fi
MyNetwork2.4g
8.
WIFI CONNECTION
Go to your phone’s
settings menu, and make
sure that your phone is
connected to a 2.4GHz
WIFI network.
Confirm that the LED Indicator
Light on your camera is still
blinking rapidly, then proceed
to the next step.
NOTE: For models without an
LED Indicator Light, you can
continue if your camera is
beeping consistently.
Open your Vivitar Smart
Security 2 app. Choose to
add a device, and In the
Add Device screen, select
to add a Smart Camera.
MyNetwork2.4g
PASSWORD
Enter your WIFI network
name and password.
9.
WIFI CONNECTION
Your app will display a QR
code. Once displayed on
the screen, hold your
phone directly in front of
your camera’s lens.
Wait as the WiFi connection is
established.
Your camera should emit
a beep to indicate that it
is ready to connect to
your network.
Once the connection is
established, you can use
the App to control your
camera.
10.
USING THE APP
On your app’s main screen
you will see the
connection status of your
camera. Press the camera
icon to view video.
Press the Me icon to
access settings and
additional help with using
your app.
View your home, dorm
room, oce and much
more.
NOTE: Screen shots
displayed in this user’s
guide of the Smart
Security 2 software
application may appear
dierently than those
currently featured in your
app as frequent updates
and improvements are
being made to the
software.
11.
FCC STATEMENT
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit dierent from
that to which
the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
Keep manual and all relevant
information for future reference.
10.
12.
WARRANTY CARD
WARRANTY CARD
This warranty covers the original consumer purchaser only and is not
transferable.
This warranty covers products that fail to function properly UNDER
NORMAL USAGE, due to defects in material or workmanship. Your
product will be repaired or replaced at no charge for parts or labor for
a period of one year.
What Is Not Covered by Warranty:
Damages or malfunctions not resulting from defects in material or
workmanship and damages or malfunctions from other than normal
use, including but limited to, repair by unauthorized parties,
tampering, modification or accident.
To Obtain Warranty Service and Troubleshooting Information:
Call 1-800-592-9541 or Visit our website at www.vivitar.com.
To receive Warranty service along with the name and address of an
authorized product service center, the original consumer purchaser
must contact us for problem determination and service procedures.
Proof of purchase in the form of a bill of sale or receipted invoice,
evidencing that the Product is within the applicable Warranty
period(s), MUST be presented in order to obtain the requested service.
It is your responsibility to properly package and send any defective
products along with a dated copy of proof of purchase, a written
explanation of the problem, and a valid return address to the
authorized service center at your expense. Do not include any other
items or accessories with the defective product. Any products
received by the authorized service center that are not covered by
warranty will be returned unrepaired.
NO WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING, BUT NOT
LIMITED TO, ANY IMPLIED WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, OTHER THAN THOSE EXPRESSLY
DESCRIBED ABOVE SHALL APPLY. DISTRIBUTOR FURTHER DISCLAIMS ALL
WARRANTIES AFTER THE EXPRESS WARRANTY PERIOD STATED ABOVE.
NO OTHER EXPRESS WARRANTY OR GUARANTY GIVEN BY ANY PERSON,
FIRM OR ENTITY WITH RESPECT TO THE PRODUCT SHALL BE BINDING ON
DISTRIBUTOR. REPAIR, REPLACEMENT, OR REFUND OF THE ORIGINAL
PURCHASE PRICE - AT DISTRIBUTOR’S SOLE DISCRETION -ARE THE
EXCLUSIVE REMEDIES OF THE CONSUMER. IN NO EVENT WILL
DISTRIBUTOR, ITS MANUFACTURERS, OR SAKAR INT. BE LIABLE FOR ANY
INCIDENTAL, DIRECT, INDIRECT, SPECIAL, PUNITIVE OR CONSEQUENTIAL
DAMAGES (SUCH AS, BUT NOT LIMITED TO, DAMAGES FOR LOSS OF
PROFITS, BUSINESS, SAVINGS, DATA OR RECORDS) CAUSED BY THE USE,
MISUSE OR INABILITY TO USE THE PRODUCT. EXCEPT AS STATED HEREIN,
NO OTHER WARRANTIES SHALL APPLY. NOTWITHSTANDING THE
FOREGOING, CONSUMER’S RECOVERY AGAINST DISTRIBUTOR SHALL NOT
EXCEED THE PURCHASE PRICE OF THE PRODUCT SOLD BY DISTRIBUTOR.
THIS WARRANTY SHALL NOT EXTEND TO ANYONE OTHER THAN THE
ORIGINAL CONSUMER WHO PURCHASED THE PRODUCT AND IS NOT
TRANSFERABLE.
Some countries, states or provinces do not allow the exclusion or limitation of
incidental or consequential damages or allow limitations on warranties, so
limitation or exclusions may not apply to you. This warranty gives you specific
legal rights, and you may have other rights that vary from state to state or
province to province. Contact your authorized retailer to determine if another
warranty applies. This product is manufactured, distributed and sold by
SAKAR International, Inc. All other trademarks are the property of the
respective owner, who has not sponsored, endorsed or approved this product.
Loading...
+ hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.