Vitesse VS-651 User Manual [ru]

NOU S VIVONS SAIN

We l iv e health y

STEAM IRON

ПАРОВОЙ УТЮГ

“Vitesse France S.A.R.L”

91 rue du Faubourg Saint Honore´
75008 Paris-France

www.vitesse.ru

VS-651

www.vitesse.ru

DEAR CUSTOMER!

You have made an excellent decision. Vitesse® “Nouveau” home range offers
you an exclusive, high quality range of appliances for your ultimate home luxury
and healthy living.

IMPORTANT SAFEGUARDS

Make sure to read all the safety precautions below and look at the illustrations
before you start using the appliance.

1. Read all instructions carefully before using.

2. Use the appliance for its intended use only.

3. The appliance is intended for household use only.

4. To protect against the risk of electric shock, do not immerse the appliance into
water or any other liquids.

5. The appliance should always be turned to OFF before plugging or unplugging
from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and
pull to disconnect.

6. Do not allow power cord to touch hot surface.

7. Always disconnect the plug of the appliance from electrical outlet when filling
with water or emptying and when not in use.

8. Do not operate the appliance with a damaged cord or if the appliance has
been dropped or damaged. To avoid a hazard such as the risk of electric
shock, do not disassemble the appliance, it must be taken to a qualified
serviceman or manufacturer or its service agent for examination and repair.
Incorrect re-assembly can cause a risk of electric shock when the iron is used.

9. Place the iron out of the reach of children, close supervision is necessary for
any appliance being used by or near children.

10. Always rest and use the appliance on a stable, level and horizontal surface or
ironing board.

11. Burns can occur from touching hot metal parts, hot water or steam. Use
caution when using the appliance. Do not touch the sole-plate until they have
cooled down completely.

12. Never use the iron facing towards people because the steam can cause
burns.

13. The iron must not left unattended while it is connected to the supply mains.

14. The iron is not to be used if it has been dropped, if there are visible signs of
damage or if it is leaking.

15. The appliance is not intended for use by children or other persons without
assistance or supervision if their physical, sensory or mental capabilities
prevent them from using it safety. Children should be supervised to ensure
that they do not play with the appliance.

16. When placing the iron on its stand, ensure the surface on which the stand is
placed is stable.

SPECIAL INSTRUCTIONS

1. To avoid a circuit overload, do not operate another high wattage
appliance in the same circuit.

2. If an extension cord is absolutely necessary, a 10-ampere cord should
be used. Cords rated for a lower amperage may overheat, care should
be taken to ensure that the cord cannot be accidentally pulled or
tripped over.

3. Never yank cord to disconnect from outlet; instead, grasp plug and
pull to disconnect.

PARTS AND FEATURE

1. Heating Indicator Light

2. Temperature control dial

3. Self-cleaning button

4. Reservoir

11

5. Soleplate

6. Nozzle

7. Inlet Cover

8. Steam control knob

9. Spray water button

10

9

8

1

10. Turbo steam button

11. Cord guard

12. Anti-calc box

6

12

7

2

3

4

5

P/1 P/2

www.vitesse.ru

FABRIC SETTING CHART

Temperature Setting

Min

Fabric Setting

Off

Synthetic

Silk/Wool

Cotton

Max

Ironing Instruction

Dr

y iron for lower ironing temperature,

such as Nylon, Acrylic, Polyester

y iron for mid ironing

Dr
temperature, such as Silk Wool

Dr

y iron for higher temperature,

such as Cotton/Linen

Steam iron for all fabrics

IRONING TEMPERATURE SETTING GUIDE

1. Follow up the ironing instructions on the garment label. If there is not any
instruction label, but you know what kind of the fabric is, please refer to the
FABRIC SETTING CHART described in this instruction manual.

2. The fabric setting chart is only valid for plain fabrics and not for materials to
which finishes, glosses etc., have been applied. Textile to which some kind of
finish has been applied (gloss, crinkle, relief etc.) is best ironed at lower
temperature.

3. First sort laundry according to ironing FABRIC SETTING CHART: wool with
wool, cotton with cotton, etc.

4. The iron heats up more quickly than it cools down. Therefore, start ironing
articles that need to be ironed at the lowest temperature, such as those made
of synthetic fibres.

5. If the fabric consists of various kinds of fibres, always select the temperature
required by the most delicate fibres, i.e. the lowest temperature. If, for
example, an article consists of 60% polyester and 40% cotton, according to
the fabric setting chart it should be ironed for polyester and without steam.

6. If you do not know what kind of fabric the article is made of, iron a piece of the
material which is not visible when you wear to find out the appropriate
temperature for your articles.

7. Pure woolen fabrics (100% wool) should be ironed with the iron setting to
steam ironing position. It is advisable to set the temperature control dial to
“Max” position and use a dry pressing cloth.

8. When steam ironing woolen fabrics, shiny patches may occur. You may
prevent this by turning the article inside out and ironing the reverse side.

9. After using of steam ironing for cotton fabrics, do not iron articles required by
lower temperature (such as nylon etc.) immediately. It is advisable to adjust
the temperature dial to the lower setting, waiting for about 2-4 minutes till the
power indicator light turn off, and then you can start ironing.

HOW TO FILL RESERVOIR

Make sure that the iron is unplugged from main socket or steam control knob is set
at “O” position before filling water into the reservoir.

1. Set the steam control knob to”0”position as shown in figure 2.

Fig.2

2. Open inlet cover and take Anti-calc box upwards out of the filling hole (Fig.3).

3. Using a cup, slowly pour tap water or distilled water into the reservoir as show
in figure 4. Never to fill beyond the Max filling line.

4. Replace the Anti-calc box back into the filling hole as show in figure 5.

5. Hold the iron in horizontal direction, and then move the iron front and back for
about 30 seconds so that limescales in water can be purified by the ion
exchange resin in the Anti-calc box.

Fig.3 Fig.4 Fig.5

Note:

When using distilled water, you can mix it with tap water in a proportion of 50%.

P/3 P/4