Vitek VTD-MD7CH User Manual

VTD-MD7CH

Vandal Resistant Mini Dome

Camera with 700 TVL

VITEK

FEATURES:

• 1/3” Sony® Super HAD II CCD

• Sony Effio-E Digital Signal Processor (DSP)

• 700 TV Lines of Resolution

• 2.8mm Lens Included (3.6, 6, 8, 12 and 16mm also
available)

• Sensitivity of 0.0003Lux

• 2D-DNR - Two Dimensional Motion Adaptive Noise
Reduction

• Can be Semi-Flush or Surface Mounted

• IP-66 Rated Weather Resistant Aluminum Enclosure w/
Polished Chrome Finish

• 12VDC Operation

INSTALLATION

Open

1) Align the camera unit with the
surface of the ceiling, make marks
on the ceiling in the places where
the screw holes are to be drilled,
and then drill the three holes.

2) Cut a hole (diameter:50mm) in the
ceiling for routing the cables.

3) Pass the power cable (B) and video
cable (A) from the camera unit
through the cable hole in the ceiling.

4) Align the three screw holes in the
camera unit (C) with the screw holes
in the ceiling, and then secure the
camera in place by tightening the
three tapping screws.

Close

5) Use the supplied the four screws (E)
to secure the middle base (D) to the
bottom base (C)

6) Tighten the guide ring (G), then
adjustment the camera (F).

7) Attach the bubble (H) to the middle
base (D).

8) Attach the top cover (I) to the middle
base (D).

9) Use the supplied star-shaded
L-wrench to tighten the set screw on
the top cover.

1