Vitek VTD-C510 User Manual

VTD-C510

High Resolution Color

Indoor Dome Camera

VITEK

The VTD-C510 high resolution color dome camera is a
small, attractive camera ideal for use in commercial or
residential applications. It measures less than 5” in
diameter and comes in dual voltage 24 Volt AC/12 Volt
DC power input for easy integration with standard
cameras and power systems.

• 1/3" High Resolution CCD (768 x 494)

• 580 TV Lines Resolution

• DSP Controls For Superior Backlight, White Balance, And

Gain Control

• 0.03 Lux Sensitivity

• Dual Voltage: 12VDC / 24VAC

• Also available in white

BLACK

WIRING CONNECTIONS

The VTD-C510 Dome Camera should be powered by 12 Volts DC or 24 Volts AC. You
should make sure that the power supply you are using is CSA Certified Class 2 Power
Supply delivering a minimum of 2.5 Watts.

For optimum video signal, use 95% copper shielded coax cable. Twisted pair or CAT-5E
cable may also be used with optional VT-TR1M Passive Video Transceivers. Maximum cable
distance for 95% copper braid coax is approximately. 800’; For Cat-5E or twisted pair, 1500’
using VT-TR1M transceivers, and up to 4500’ with use of VT-TR16AI Active UTP hub.

2

CAMERA SETUP

Your VTD-C510 Dome Camera has been set at average default settings from the factory so
the performance should be excellent right from the start. However, certain challenging
environments may require additional set-up procedures to enhance the image.

DIP SWITCH SETTINGS

There are four dip switches on the rear board of
the camera. The following adjustments may be
made:

Dip Switch Adjustments

Dip Switch 1

(Default ON)

Dip Switch 2

(Default OFF)

Dip Switch 3

(Default OFF)

Dip Switch 4

(Default OFF)

AE: Automatic Electronic Shutter Control

Leave this switch in the “On” position when using a fixed lens
version to enhance the camera’s ability to react to changing light.

Switch to “Off” position if your camera has an auto iris lens.

BLC: Back Light Compensation

Leave this switch in the “Off” position if your camera is being
installed outdoors or if the installation is indoors in a controlled
lighting environment.

Switch to “On” position when installing the camera indoors looking
toward windows or doors or if outdoors looking into semi-direct
sunlight. Never install camera looking into direct sunlight.

FL: Flickerless

Flickerless shutter speed for minimizing image flicker under
fluorescent lighting.

AGC: Automatic Gain Control

Used to increase the video signal in low light conditions. If used in
the wrong environment, this setting can add noise in the picture
giving a grainy appearance.

3

BLACK