Vitek VTC-TNT2HR4F2B, VTC-TNT2HR4F2-2, VTC-TNT2HR3F2-2 Quick Start Guide

VTC-TNT2HR3F2 VTC-TNT2HR4F2

VTC-TNT2HR4M2

3.0 & 4.0 Megapixel Indoor/

Outdoor WDR IP IR Cameras

VITEK

QUICK START GUIDE

VITEK

FEATURES

• 1/3” Megapixel Progressive Scan CMOS image sensor

• Up to 30fps live view

• Motorized 3.3-12mm (VTC-TNT2HR4M2 ) & 3.6mm or 2.8mm Fixed Iris (VTC-TNT2HR3F2 & VTC-TNT2HR4F2) Lens Options

• 2 High Power Infrared LED’s

• 120dB Super Wide Dynamic Range (WDR)

• True Mechanical Day/Night function by ICR

• XD-DNR (2D-DNR & 3D-DNR) Noise Reduction

• On Board Motion Detection

• H.265/H.264/MJPEG Triple Streaming

• Secondary Video Output (CVBS)

• Remote Viewing via CMS, Internet Explorer, and iOS & Android Apps

• Minimal Latency with up to 10 simultaneous user connections

• ONVIF Compliant

• IP66 Weather Resistance

• Optional Junction Box Mount Available (VT-TJB01)

• 12VDC & PoE (Power over Ethernet) Operation

PLEASE NOTE:

Complete User Guide, Software, Tools, and Updates are available online. Scan the QR Code or visit: http://www.vitekcctv.com/Downloads

Components and Accessories

Camera

Quick Guide

Screws

Hex Wrench

Focus

Zoom

Drill Template

Rubber Plug

Waterproof Cap

Overview

This camera series supports both fixed and varifocal lenses. Please note that the zoom and focus features mentioned below are not features of the fixed lens version.

Lens

RJ-45 Ethernet

CVBS Output

Audio Input

Power Input

2 3

Network Cable & Power Connections

First connect the Waterproof Cap to an Ethernet patch cable, then connect the cameras ethernet adaptor. If not powering the camera with PoE, also connect the power Cable to an approved 12VDC Power Supply.

Network Cable

12VDC

Optional 12VDC

Power Connection.

Not needed with PoE

Weather Resistant Network Coupler

1. Loosen the nut from the Weather Resistant Network Coupler,

2. Run ethernet cable through coupler, then attach a RJ-45 connector.

3. Tighten the nut and coupler for a weather resistant seal.

+ 5 hidden pages