Vitek VTC-T4T3HR2MD User Manual

VTC-T4T3HR2MD

2.1 Megapixel 4-in-1 HD-TVI /
AHD / CVI / CVBS Motorized

Varifocal Ball/Turret Camera

with 3 High Power IR LED

Illumination

VITEK

VITEK

FEATURES

• 1/2.9” 2.1 Megapixel Sony® Exmor™ Progressive Scan
CMOS Sensor

• 30fps live view @ 1920 x 1080p

• True Day/Night by IR Cut Filter

• HD-TVI / HD-CVI / AHD / 960H CVBS Video Output
(Selectable)

• Motorized 2.8~12mm MegaPixel IR Corrected Auto Focus
Varifocal Lens with CoC

• 3 Integrated High Power Dynamic IR LEDs with up to 135’
IR Range

• XD-DNR (2D-DNR + 3D-DNR) Noise Reduction

• Double Shutter Wide Dynamic Range (WDR)

• 16:9 Video format

• IP66 Weather Resistance

• Supports Up The COAX Control (CoC)

• Over 1500’ HD Video Transmission (Depending on cable
characteristics and integrity)

• Optional Junction Box Mount Available (VT-TJB04)

• 12VDC / 24VAC Dual Voltage Operation

• 3 Year Warranty

Safety Precaution

To prevent electrical shock and risk of fire hazards, do not expose this unit
to rain or moisture and only use specified power source..

CAUTION: TO REDUCE THE RISK OF ELECTICAL
SHOCK, DO NOT REMOVE COVER (OR BACK).
NO USER SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL

The symbol is intended to alert the user to the presence of uninsulated
"dangerous voltage" within the product's enclosure that may be of
sufficient magnitude to constitute a risk of electrical shock.

The symbol is intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the literature
accompanying the unit.

Warning :

This equipment has been tested and found to comply with the limits for a Class

A digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and
can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
their own expense.

Caution :
Any changes or modifications in construction of this device which are not expressly
approved by the party responsible for compliance could void the user's authority
to operate the equipment.
Main power quality should be that of a typical commercial environment. If the user
of the model requires continued operation during power interruptions, it is
recommended that the device be powered from an uninterruptible power supply
(UPS).

2 3

Installation

1) Disconnect power before installation.

2) Confirm proper 12VDC or 24VAC power supply is used to prevent

damage to the camera.

3) Do not use in an environment beyond the boundaries of the
specifications.

Power & Video Connections

Connect the HD-TVI Video or AHD/CVBS video connector to a BNC
patch cable, then to a DVR. Next connect the power connector to a
12VDC or 24VAC power adaptor.

Monitor

12VDC / 24VAC Power

Video

BNC Connections:

Green: HD Connection
Yellow: SD Connection

On Cable Switch:

Press & Hold button to cycle between HD-TVI, AHD, and CVI
Modes (Green BNC Connection required).

Press & Release the Switch quickly to enter OSD Menu
Screen.

3