Vitamix Blending Station Installation Manual

COMPACT

COVER

with Removable Hinge Design

®

for Blending Station

Models

COMMERCIAL CUSTOMER SERVICE:

Tel: 800-4DRINK4, 800-437-4654, 440-235-0214; Fax: [phone]

Email: [e-mail]; www.vitamix.com/foodservice

ALL OTHER COUNTRIES contact your local Vita-Mix Distributor

or telephone: [phone]; Fax: [phone]

Email: [e-mail]; www.vitamix.com/foodservice

©2005 Vita-Mix Corporation. No part of this publication may be reproduced or transmitted in any form or

by any means, electronic or mechanical, including photocopy

Printed in U.S.A.

US, CANADA & LATIN AMERICA

VITA-MIX®CORPORATION

8615 Usher Road, Cleveland, Ohio 44138-2103 USA

, recording or any information storage and retrieval system

without the written permission of the Vita-Mix Corporation.

XTG022 10/05

IMPORTANT!

THE VITA-MIX

PLEASE READ THE FOLLOWING INFORMATION CAREFULLY.

®

COMPACT COVER MUST BE USED IN ACCORDANCE WITH

THESE INSTRUCTIONS.

COMPACT COVER INSTRUCTIONS

Cover Door:

1. The Cover Door can be removed by opening it
until the door is horizontal. Then, gently spread
the sides of the door over the round hinges
and remove.

2. To reinstall the Cover Door,
gently spread the sides of
the door and place the door
hinge cutouts over the
round hinges.

Back Cover:

1. To remove the Back Cover from the Blending Station:

Figure A

2. To replace the Back Cover on the Blending Station:

a. Place the Back Cover on the Motor Base

approximately 1 inch / 2.4 cm forward of its
normal position.

b. Slide the cover towards the back of the machine

(away from the Control Panel).

Make sure the

side latches slide into their tracks.

c. Push until back of cover is seated against the

Motor Base (see Figure D).

Make sure the Back
Cover is fully seated in the back and the side
latches are in their grooves before inserting
and tightening the mounting screws.

d. Replace and firmly hand-tighten the two (2) Back

Cover mounting screws (see Figure B).

DO NOT over­tighten or use any tools to tighten. DO NOT use the
mounting screws to pull the Back Cover into
position. Doing so will cause damage.

Figure D

a. First remove the Cover Door from the unit as

described above.

b. Remove the two (2) Back Cover mounting screws

from the rear of the machine (see Figure B).

c. From the rear of the machine, firmly push the

bottom of the cover forward (towards the Control
Panel), keeping the bottom edge of the cover
against the Motor Base.

DO NOT

tilt or strike the cover during removal.

d. Slide forward until the side latches on the front of

the cover are released from the Motor Base (see
Figure C).

DO NOT strike the cover to "pop" the
side latches from their tracks. Doing so will
cause damage. The cover must only be
removed by sliding it forward (towards the
Control Panel).

Figure B

Figure C

CARE AND CLEANING

The Cover can be removed (see Compact Cover Instructions) and cleaned by placing
under running water and washing with a soft cloth. Wipe dry and replace back on the base.

DO NOT wash Cover Door, handle or Back Cover in dishwasher. DO NOT
use abrasive cleaning agents or concentrated bleach when cleaning. DO
NOT use any cleaners containing Quatinary Sanitizers.

NOTE:

It is recommended that the handle not be disassembled during cleaning.
However, if you choose to disassemble the handle from the cover, make sure to not
over-tighten it when reattaching it to the cover. Doing so will cause damage.