Vitamix 1420 Installation Manual

1. BASE ASSEMBLY 1 ASY409

SPRAYHEAD KIT (

Includes: 2a Sprayhead, Nozzle; 2b Gasket,

Nozzle; 2c Plunger, Nozzle; 2d Spring, Nozzle; 2e O-Ring, Upper

)

1 1411

3. SUCTION CUP FEET (Set of 3

)

1 1413

4. HOSE ASSEMBLY 1 1422

5. INTERNATIONAL FAUCET ADAPTER KIT (Set of 2)11423

USE & INSTALLATION INSTRUCTIONS

(

Not Shown

)

1XRM005

7. SANITIZING INSTRUCTIONS

(

Not Shown

)

1XRM006

USE & INSTALLATION INSTRUCTIONS

ON OTHER SIDE.

FIGURE

ITEM NUMBER

NAME

2-d

2-e

2-c

2-b

2-a

Vita-Mix®Corporation will repair or replace this product with new or rebuilt parts, free of charge, in the USA, Puerto Rico and Canada, in the event of a defect in materials or workmanship for a period of one year from the date of purchase. This warranty does not cover damage which occurs from shipment, accident, misuse, abuse, neglect, mishandling, misapplication, faulty installation, set-up adjustments, improper maintenance, alterations, modifications, tampering, negligence, lack of reasonable care, water power, acts of God, or repair or service by anyone other than a service facility authorized by Vita-Mix. Replacement nozzle parts, seals, suction cups, hoses and connectors are available for a reasonable cost. Vita-Mix Corporation shall not be liable for the loss of use of the product, inconvenience, loss or any other damages, whether direct, incidental, or consequential including, without limitation, damage to other equipment resulting from the use of this product, or arising out of any breach of this warranty. This limited warranty is in lieu of any other warranty expressed or implied. No representative or any other person is authorized to make any other warranty or to assume liability not strictly in accordance with the foregoing. This limited warranty gives you specific legal rights which may vary from state to state. To obtain warranty service in the United States, Puerto Rico and Canada call the Vita-Mix Service Hot Line toll free at 1-800-437-4654, 440-235-0214 or write Vita-Mix Rinse-o-matic Service Center, 8615 Usher Rd., Cleveland, Ohio 44138-2103 USA. In order to receive warranty service you may be required to provide proof of purchase. Should it become necessary to transport your Rinse-o-matic make sure it is properly packaged to avoid damage. Transportation is the user’s responsibility.

LIMITED ONE-YEAR WARRANTY

5-a

5-b

ATTENTION

Turn off water supply and disconnect system from faucet after closing time. Check water supply hose and connections for leakage at regular intervals.

MANUFACTURED BY VITA-MIX®CORPORATION

QTY.

Outside the United States, Puerto Rico and Canada other warranties may apply. Contact your local Vita-Mix distributor for details or telephone Vita-Mix International at +1(440)235-5494.

This package contains one item #1420 which includes the following:

Use the above item #’s for ordering replacement parts.

INSTALLATION INSTRUCTIONS

PLEASE NOTE: This equipment is to be installed to comply with the applicable Federal, state, or local plumbing codes having jurisdiction.

1. Ensure that you have received all of the parts in the diagram on the opposite side of this page. If you are missing any parts, please contact your local Vita-Mix distributor or telephone the Vita-Mix International division at +1 (440) 235-5494.

2. Make sure the faucet is turned off.

3. Remove the faucet aerator if one is installed.

4. Locate the pack-in bag. Find the faucet-to-hose thread adapter (fig. 6a) and screw onto the faucet. An additional adapter (fig. 6b) is provided to accommodate various faucet designs. Be sure that you use the correct washer if it is necessary to use an adapter.

5. Turn the faucet on to wet the bottom of the sink. The suction cups are more effective when the sink bottom is wet and clean. Turn the water off once the sink bottom is wet.

6. Connect the free hose end of the Rinse-o-matic unit to the faucet by tightening the free end of the hose to the adapter.

7. Place the rinsing unit in the bottom of the sink in the desired location and press

down firmly and evenly to secure the suction cups.

8. Turn on the cold water.

PLEASE NOTE: Periodically check water supply hose and connections for leakage. Refer to the troubleshooting guide if there is leakage.

Yo u are now ready to use the Rinse-o-matic.

To Faucet (Step 6)

ATTENTION

Turn off water supply and disconnect system from faucet after closing time. Periodically check water supply hose and connections for leakage.

MANUFACTURED BY VITA-MIX®CORPORATION

RINSING INSTRUCTIONS

1. Place the item to be rinsed upside down over the top of the Rinse-o-matic unit until it rests on the plunger.

2. Press down on the item to be rinsed. This will depress the plunger and release the water.

3. Hold the plunger down for 2-5 seconds or until the item is fully rinsed.

4. Lift the rinsed container from the Rinse-o-matic. The

water will stop flowing.