Visonic PowerMax Pro GSM Installation Instructions Manual

D-300964 1
POWERMAX PRO GSM
Internal GSM module for PowerMax Pro
1. INTRODUCTION
The internal GSM module enables the PowerMax Pro system to operate over a GSM/GPRS cellular network.
Internal GSM
2. INSTALLATION
1. Open the PowerMax Pro:
1
2
Release
screws
2. Plug in the GSM module and fasten it with the screw:
GSM
Front unit
Warning!
If external antenna removal is required, hold its connector (not the cable) and pull it out.
This prevents damage to the P.C.B.
3. Mount the optional GSM external antenna on the desired site surface, connect its connector to the internal GSM module and insert the SIM card, as shown below.
External GSM antenna cable
(optional)
1
Slide top
cover
Lock cover
to close
6
SIM card insertion
IMPORTANT
1.Before inserting SIM card, deactivate its PIN code (by using a cellular telephone).
2.Do not insert or remove SIM card when the control panel is Powered by AC power or battery.
4
Slide SIM
card into
cover
5
Rotate cover
to close
2
Open cover
Align SIM
card in cover
(note cover orientation)
3
3. DEFINING GSM PARAMETERS
Refer to the PowerMax Pro installer guide section 4.6
W.E.E.E. Product Recycling Declaration For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
VISONIC LTD. (ISRAEL): P.O.B 22020 TEL-AVIV 61220 ISRAEL. PHONE: (972-3) 645-6789, FAX: (972-3) 645-6788 VISONIC INC. (U.S.A
.): 65 WEST DUDLEY TOWN ROAD, BLOOMFIELD CT. 06002-1376. PHONE: (860) 243-0833, (800) 223-0020 FAX: (860) 242-8094
VISONIC LTD. (UK): 7 COPPERHOUSE COURT, CALDECOTTE, MILTON KEYNES. MK7 8NL. TEL: (0870) 7300800 FAX: (0870) 7300801
INTERNET: www.visonic.com ©VISONIC LTD. 2007 POWERMAX PRO GSM D-300964 (REV. 1, 6/07)
Loading...