Page 1
1
TC2-HDBTv2_manual_en_v1.doc
TECHCONNECT HDBT
OWNERS MANUAL
www.visionaudiovisual.com/techconnect/tc2-hdbt
Page 2
2
TC2-HDBTv2_manual_en_v1.doc
DECLARATION OF CONFORMITY
Where appli cable Vision products are ce rtified and c o mply with all known l o cal regulations to a
‘CB Cer t ification’ standard. Vision co m mits to ensure all produc t s are fully comp liant with all
applicable certification standards for sale in the EU and other participating countries.
The product described in this owner manual is in compliance with RoHS (EU directive
2002/95/EC), and WEEE (EU directive 2002/96/EC) standards. This product should be returned
to the place of purchase at the end of its useful life for recycling.
WARNINGS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the
user to the presence of uninsulated “danger ous voltage” within the pr oduct’s enclosur e that may be
of sufficient magnitude to constitute a risk of electric shock to persons.
The exclamation point within an equilateral triangle, is intended to alert the user to the presenc e of
impo rtant operating and maintenance (servicing) instructions in the literature accompanying the
appliance.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE
THIS A PPLIANC E TO RA IN OR MOISTU RE .
All products are designed and importe d into the EU by ‘Visio n’ who is wholly owned by ‘Azlan
Logistics Ltd.’, Registered in England Nr. 04625566 at Lion House, 4 Pioneer Business Park,
Clifton Moor, York, YO30 4GH. WEEE Reg is tration : GD0046SY
DECLA RATION O F OR IGI N
All Vision products are made in the People’s Republic of China (PRC).
Page 3
3
TC2-HDBTv2_manual_en_v1.doc
USE ONLY D OMESTI C AC OUTLETS
Connecting the unit to an outlet supplying a higher voltage may create a fire hazard.
HANDL E T HE POW ER CORD WITH CARE
Do not disconnect the plug from the AC outlet by pulling the cord; always pull the plug itself.
Pulling the cord may damage it. If you do not intend to use your unit for any considerable
length of time, unplug the unit. Do not place furniture or other heavy objects on the cord, and
try to avoid dropping heavy objects on it. Do not tie a knot in the power cord. Not only could
the cord be damaged, but a short circuit could also be caused with a consequent fire hazard.
PLACE OF INSTALLATION
Avoid installing this product under the following conditions:
• Moist or humid pla ces
• Places exposed to direct sunlight or close to heating equipment
• Extr emely cold loc ations
• Places subject to excessi ve v i brati on or dust
• Poor ly ventilated place s
Do not expose this pro d uct to dripping or splashing. DO NOT PLA CE OBJE C T S FILLED WITH
LIQUIDS ON OR NEAR THIS PRODUCT!
MOVING THE UNIT
Before moving the unit, be sure to pull out the power cord from the AC outlet and disconnect
the interconnection cords with other units.
WARNING S I GNS
If you detect an abnormal smell or smoke, turn this product off immediately and unplug the
power cord. Contact your reseller or Vision.
PACKAGING
Save a ll packing ma te r ial. It is essential for s hipping in the event the unit ever needs repair.
IF ORIGINAL PACKAGING IS NOT USED TO RETURN THE UNIT TO THE SERVICE CENTRE,
DAMAGE IN TRANSIT WILL NOT BE COVERED BY WARRANTY.
Page 4
4
TC2-HDBTv2_manual_en_v1.doc
OVERVIEW
This product sends uncompressed HDMI over CAT6 (eth er n et ) ca bles. The cable can be up to
70m long.
Vision’ s HDBaseT p r oducts will work with othe r HDB aseT approved by the HDBa s eT Alliance.
HDBaseT signal cannot be routed through a TCP/IP network.
This product simply passes the EDID information through and cannot change it.
TRANSMITTER
1. 12V 2A Power input
2. RJ45 (CAT6) Output
3. HDMI Input
RECEIVER
1. 12V 2A Power input
2. RJ45 (CAT6) Input
3. HDMI Output
NOTE: Power only needs to be co nnect ed at one end.
The TC2-HDBT uses proprietary PoE to send power to the other end.
1 2 3 1 2
3
Page 5
5
TC2-HDBTv2_manual_en_v1.doc
INDICATOR LIGHTS
4. Power LED
5. Status LE D – indicates trans m i tter and receiver are connected to each other
6. Link LED – indicates HDMI input is connected
7. HDCP LED – indicates signal is encrypted (flashing means not encrypted)
INSTALLATION
1. CONNECT CABLES You can use unshielded or shielded twisted pair. It is technically
possible to use either CAT5e or CAT6 cable. CAT6 is superior qualit y and has a lower skew
rate.
NOTE: The most common cause of problems is poor quality CAT5e/6 cable.
Vision strongly recommends you use quality CAT6 cable with a low skew rate.
2. POWER ON HDBT DEVICES
3. POWER ON DISPLAY
4. POWER ON SOURCE
4
5
7
6
Page 6
6
TC2-HDBTv2_manual_en_v1.doc
TROUBLESHOOTING
If your system is not operating properly, please refer to the following information. If the
problem persists, disconnect from power and contact your AV reseller immediately.
Problem
Correction
Status lights no on
• Check CAT5e/6 cable
• The cable should be wired to 568B standard at both ends.
If one end has green and orange swapped this is a crossover cable and cannot be used.
• Try uns hi el ded cable
No Power light
• Check power connections
• Try alternative power supply
Link light not on
• Check HDMI cable between source and transmitter
Status light not on
• Replace CAT5e/6 cable
Image di s played
incorrectly
• Repeat start-up sequence
Lights all on but no
image
• Check that source is turned on
Page 7
7
TC2-HDBTv2_manual_en_v1.doc
SPECIFICATIONS
TRANSMITTER/RECEIVER DIMENSIONS: 106 x 74 x 15 mm
PRODUCT WEIGHT: 0.36 kg (per set)
CONSTRUCTION MATERIAL: Metal
COLOU R: W hi t e
TECHNICAL DETAILS:
Signaling rates: 2.97Gbits x 3
Input Video Signal: 0.5-1.0 volts p-p
Input DDC Signal: 5 volts p-p (TTL)
HDMI Maxim um Res olution: 3840 x 2160 (“4k”)
HDMI Version: 1.4 (3D)
Operating temperature range: -5 to +35°C (-41 to +95 °F)
Operating humidity range: 5 to 90 % RH (no condensation)
Power Consumption: 12 Watts (max.)
INPUTS:
1 x HDMI (type A)
OUTPUTS:
1 x HDMI (type A)
POWER SUPPLY: 100-240v 50/60Hz AC External Power Supply – integrated transformer/plug
type. DC Output 12V 2A, DC Cable 1.8m. Transformer di m ens ions: 81 x 52 x 38mm.
COMPLIANCES : RoH S, WEEE, CE/EMC, C-TICK, FCC.
ACCESSORIES
1 x Pair of mounting ears
Page 8
8
TC2-HDBTv2_manual_en_v1.doc
WARRANTY
This product comes with a 2-year return to base warranty, effective from the date of purchase.
This warranty applies only to the original purchaser and is not transferable. For the avoidance of
doubt, this will be taken from the information held by the appointed natio nal distrib utor at th e
point of sale. If the product is DOA (dead on arrival), you have 21 days from purchase date to
notify the national distr ibutor via you r A V re s eller. The lia bility o f th e manufactur er and its
appointed service company is limited to the cost of repair and/or replacement of the faulty unit
under warranty, except for death or injury (EU85/374/EEC). This warranty protects you against
the following:
• Failure of any components, including the power supply.
• Damage when the product is first removed from its packaging if reported within 24 hours of
purchase.
If you find you do have a problem with this product, you should contact the AV reseller you
purchased this product from. The original purchaser is responsible for shipment of the product
to the manufacturer’s appointed service centre for repair.
We will endeavour to return repair ed units within 5 working days, however this may no t always
be possi ble, in wh ich case it will be r eturned a s soon as practic ably possible . In line with our
WEEE commitments, the manufacturer endeavours to replace the faulty parts of the product
rather than replacing the whole unit. This warranty does not protect this product against faults
caused by abuse, misuse, incorrect installation, unstable or faulty power input, which might be
cau sed by ignorin g the guidelines set out in this manua l.
LEGAL DISCLAIMER: Because we are committed to improving our products, the details above
may change without prior warning. This User Manual is published without warr anty and an y
improvements or changes to the User Manual necessitated by typographical errors, inaccuracies
of current information, or improvements to programs and/or equipment, may be made at any
time and without notice. Such changes will be incorporated in to new edi t i ons of th e Us er
Manual.
Loading...