Vintec VIN40SGEALRH Diagram Sheet

V40 SERIES

UNDERBENCH INSTALLATION INSTRUCTIONS

1. Cabinet dimensions:

Height 820mm – 860mm (40mm adjustable feet)
Width 595mm
Depth 571mm + 30mm stopper (=601mm)

2. This cabinet is not designed to be fully integrated behind a joinery door.

3. Please note that a minimum cut out of 615mm is required to facilitate installation,
removal and servicing.

4. This cabinet requires 10mm clearance on both sides and top and 30mm clearance at
the rear. A ventilation grid MUST be installed in the 30mm clearance at the rear.

Because hot air rises it is imperative that a grille with a Minimum grid size of
200mm x 40mm is installed at the top of the back wall or on either side at the
rear at the top giving cool fresh air full access to flow into the 30mm gap at the
rear of the cabinet. This means that you must not install the grille close to other
appliances such as an oven or to an area that is sealed or with out access to fresh
cool air. (You MUST call the Vintec Service Department on 1800 771 776 if you do

not understand any part of this statement. Failing to comply with the above
specifications could result in WARRANTY void.)

Frontal View

Vent specifications

Cross section