Vintec v40bvc Instruction Manual
______________________________________________
INSTRUCTION MANUAL - BEVERAGE CENTRE
V40BVC
______________________________________________
WARNING
•
To prevent damage to the door gasket, make sure you have the door fully open when pulling
shelves out of the compartment.
•
The appliance must be positioned so that the plug is accessible. Release the electric cord. Move
your cabinet to its final location. Do not move your cabinet while loaded with wine as it will distort
the body. The beverage centre should be installed in a suitable place in order to avoid touching
the compressor with the hand. If the supply cord is damaged, it must be replaced by an approved service agent to ensure correct installation.
Important Safety Instructions
Warning
To reduce the risk of fire, electrical shock, or injury
when using your appliance, follow these basic pre-
cautions
•
Read all instructions before using the Beverage centre
•
DANGER OR WARNING: Risk of child entrapment. Child entrapment and suffocation are
not problems of the past. Junked or abandoned appliances are still dangerous ... even if they
will “just sit in the garage for a few days”
•
Before you throw away your old Beverage centre: Take off the door, Leave the shelves in
place so that children may not easily climb inside
•
Never allow children to operate, play with, or crawl inside the appliance.
•
Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or explosion.
•
Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this or
any other appliance. The fumes can create a fire hazard or explosion.
>> Save these instructions <<
Installation Instructions
Before Using Your Beverage Centre
★
Remove the exterior and interior packing.
★
Before connecting the Beverage centre to the power source, let it stand upright for
approximately 2 hours. this will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
★
Clean the interior surface with lukewarm water using a soft cloth.
Installation of your Beverage centre
★
This appliance s designed to be free standing installation or build-in (fully recessed)
★
Place your Beverage centre on a floor that is strong enough to support it when it is fully
loaded. To level your Beverage Centre, adjust the leveling legs of the Beverage
centre until it is balanced.
★
Locate the Beverage centre away from direct sunlight and sources of heat (stove,
heater, radiator, etc) Direct sunlight may affect the acrylic coating and heat sources
may increase electrical consumption. Extreme cold ambient temperatures may also
cause the unit not to perform properly.
★
Avoid locating the unit in moist areas.
★
Plug the Beverage centre into an exclusive, properly installed - grounded power outlet.
Do not under any circumstances cut or remove the third (ground)prong from the power
cord. Any questions concerning power and/or grounding should be directed toward a
certified electrician or an authorised service agent.
Reversing the Door Swing of Your Appliance
This appliance has reversible doors but is delivered with a right hinged door. The left hand hinge kit
comes with the unit (in the box) should you wish to opposite hinge your unit.
1. Lock Screws 2. Lower Hinge (right 3. Door axis
4. To hinge (right) 5. Door 6. Cabinet
7. Top hinge (left) 8. Lower hinge (left)
Loading...