Viking w-200 Service Manual

W-200

W-200

Door Communication

System

August 1, 2001

PPhhoonnee......771155..338866..8888661

1

i

i

n

n

f

f

o

o

@

@

v

v

i

i

k

k

i

i

n

n

g

g

e

e

l

l

e

e

c

c

t

t

r

r

o

o

n

n

i

i

c

c

s

s

.

.

c

c

o

o

m

m

hhttttpp::////wwwwww..vviikkiinnggeelleeccttrroonniiccss..ccoom

m

Power: 120V AC/12V DC, 500mA UL listed adapter provided
Talk Battery: 15V DC
Dimensions: Controller: 120mm x 70mm x 35mm (4.75” x

2.75” x 1.38”), Speaker Box: 140mm x 115mm x 38mm (5.5” x

4.5” x 1.5”)

Weight: .75 Kg (1.5 lbs.)
Environmental: Controller: 0°C to 32°C (32°F to 90°F) with 5%

to 95% non-condensing humidity, Speaker Box: -26°C to 54°C (­15°F to 130°F)

Connections: 6 wire modular cord (included)
Maximum Run: 500 feet to speaker box (24 gauge twisted)

Talk to Visitors at Your Door...

Even if You’re on the Phone!

PPrraaccttiicce

e

T

T

EELLEECCOOM

M

S

S

OOLLUUTTIIOONNSSFFOORRTTHHE

E

221

1

SST

T

C

C

EENNTTUURRY

Y

TECHNICAL

TECHNICAL

SSppeecciiffiiccaattiioonns

s

FFeeaattuurrees

s

• Communicate handsfree with doors or gates

• Commercial, industrial and residential
security applications

• Gas station fuel island communication

• Provide communication with delivery and
employee entrances

• Works in combination with existing doorbell

• Integrates easily with residential and busi­ness phone systems

• “Hold” feature allows communication with the
speaker box while a phone call is in progress

• Microphone volume adjustment for back­ground noise

• Electronics mount indoors

• Provides 15 volt talk battery

• Only two wires required to speaker box

phones. In addition, the W-
200 can also be configured to
work with business telephone
systems.

If the door bell sounds, even
when you are on the phone,

AApppplliiccaattiioonns

s

When used in combination with an existing doorbell, the
W-200 provides safe and reliable handsfree two way
communication through your existing residential

enter a Touch Tone command to communicate with the visitor at the door. Calls may be
disconnected or placed on “hold” and reconnected after the conversation with the
speaker box.

A. Accessing Dial Tone

To gain access to C.O. dial tone, dial a Touch Tone “9”, then follow the oper­ating examples below. When using private dial tone, remove JP1 shunt (see
diagram to the right). Note: Disconnect power and modular cord prior to
removing the cover of the W-200. Phones will instantly have dial tone for mak­ing calls. Follow the Operating Examples, in the table below, for speaker box
access.

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or
subsidiaries assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate
such changes.

Fax Back Doc 167

ZF301270 Rev C

Printed in the U.S.A.

PPrroodduuccttSSuuppppoorrttLLiinnee......771155..338866..8866666

6

FFaaxxBBaacckkLLiinnee......771155..338866..4433445

5

IInnssttaallllaattiioon

n

B. Microphone Volume

In certain noisy locations the microphone sensitivity may
need to be decreased. A pot is provided on the bottom of
the W-200 to increase (clockwise) or decrease (counter­clockwise) the microphone sensitivity. Note: The POT

comes factory set to the middle position.

A. Wiring the W-200

B. Mounting the W-200

PPrrooggrraammmmiinng

g

VIKING©

W-200

DOORCOM

SYSTEM

BUSY

UP

VIKING

©

Note: The W-200may also be used without a
dial tone source. Jumper JP1 must be left in
place. When the doorbell sounds, access line
2 of a two-line phone, pick up a dedicated
telephone or access that line on a KSU/PABX
phone system. Touch Tone commands are
not needed to communicate with a doorbox.

Speaker Box

(included)

W-200

120V AC

Adapter

(included)

PABX/KSU

2-Line

Phone

House

Phone(s)

Dial

Tone

Telephone Jack

Assembly

(not included)

Operating Examples

To access the speaker box (disconnects the call in progress)
To place the call on hold and the speaker box
To return a call placed on hold

Enter Digits

✱9 or #9
✱0 or #0
✱ or #

JP1

Internal View of the W-200

MIC

MIC

Increase

Decrease

Bottom View of the W-200

Red

Green

Blue

White

Black Yellow

Back panel of the Speaker Box

-
Q170200

100½

0.5W

UP

VIKING©

To open the speaker box, remove
the two screws from the cover.

Mount back panel to a wall, a sin­gle gang box or a 4”x4” junction
box with the arrow pointing up.

3.40”

1.55”

3.30”

2.35”

3.40”

Attach the cover to the base
with the two included screws
as shown.

Side view of the Speaker Box

Front view of the Speaker Box