Installation Guide
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930 USA (662) 455-1200
For product information, call 1-888-845-4641
LPKPDR - Universal LP Conversion Kit for
Professional & Designer Ranges/Rangetops
F20525E EN |
(041414) |
Table of Contents
Warnings __________________________________________________________________ 3
Kit Contents _______________________________________________________________ 4
Regulator Conversion ________________________________________________ 5
Infrared Broiler Conversion ____________________________________________ 6
Surface Burner Conversion
Sealed Type 1 ____________________________________________________ 7
Sealed Type 2 ____________________________________________________ 8
Designer Range & Rangetop ________________________________________ 9
Orifice Locations _________________________________________________ 10
Open Type 3 ____________________________________________________ 11
Griddle Conversion
U-Shape Burner with Spark Ignition_________________________________ 12
Straight Tube Burner with Spark Ignition ____________________________ 13
Straight Tube Burner with Glow Bar Ignition _________________________ 14
Grill Conversion _____________________________________________________ 15
Wok Conversion _____________________________________________________ 16
Bake Conversion
“L” Shaped ______________________________________________________ 17
“U” Shaped ______________________________________________________ 18
Rating Label Locations _______________________________________________ 19
IMPORTANT–Please Read and Follow!
Fire/explosion hazard.
IF THE INFORMATION IN
THIS MANUAL IS NOT
FOLLOWED EXACTLY, A
FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE,
PERSONAL INJURY, OR DEATH.
•DO NOT store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.
•WHAT TO DO IF YOU SMELL GAS:
–DO NOT try to light any appliance.
–DO NOT touch any electrical switch; DO NOT use any phone in your building.
–Immediately call your gas supplier from a neighbor’s phone.
–Follow the gas supplier’s instructions. –If you cannot reach your gas supplier,
call the fire department.
•Installation and service must be performed by a qualified installer, service agency, or the gas supplier.
2 |
3 |
LP Orifice Conversion Kit Contents
Burner Type |
Size |
Quantity |
Infrared Broiler |
56 |
(1) |
Sealed Type 1 |
1.1 |
(8) |
Sealed Type 2 |
1.07 |
(8) |
Designer Surface Burner |
57 |
(1) |
Designer Surface Burner |
61 |
(1) |
Designer Surface Burner |
63 |
(1) |
Designer Surface Burner |
65 |
(1) |
Designer Surface Burner |
67 |
(1) |
Designer Surface Burner |
58 |
(1) |
Designer Surface Burner |
60 |
(1) |
Designer Surface Burner |
70 |
(1) |
Open Type 3 |
57 |
(6) |
Griddle |
57 |
(2) |
Grill |
57 |
(2) |
Wok |
52 |
(1) |
“L” Type Bake |
57 |
(4) |
“U” Type Bake |
52 |
(1) |
Sealed Type 2 |
|
|
PowerPlus™ |
1.24 |
(1) |
Excludes models VGR, VCM, VRT, VRT-R and D3 models. For information on these models, please contact customer service at 1-888-845-4641.
Regulator Conversion
Flip Cap |
Hex Nut Cap |
•Sealed Surface Burner Models
Identify regulator type from rear of range/rangetop located underneath main top assembly.
•Open Surface Burner Models
Identify regulator type from front of unit by removing grates, burner bowls and grate support from far left side of range/rangetop.
Before proceeding with conversion, turn off gas supply and disconnect power to unit.
•Flip Cap
Press downward on regulator cap and turn counterclockwise to remove. NOTE: Regulator cap is marked “Nat” on one side and “LP” on opposite side. Reverse regulator cap and reinstall with LP side facing upward for LP operation.
•Hex Nut Cap
Remove brass hex nut from top of regulator. Unsnap plastic plunger from brass hex nut. Reverse plunger and reinstall onto brass hex nut by pressing firmly.
NOTE: Plunger is marked “Nat” and “LP”. Converted fuel type will be shown on the lower portion of plunger.
Reinstall hex nut onto regulator in configuration desired.
4 |
5 |
Loading...