Viking VCAM-1IR, VCAM-2 User Manual
TECHNICAL
TECHNICAL
e
Y
T
EELLEECCOOM
T
M
S
OOLLUUTTIIOONNSSFFOORRTTHHE
S
PPrraaccttiicce
E
1
T
C
221
SST
EENNTTUURRY
C
Compact Color Camera Kits and
Single Gang Mountable Cameras
The VCAM-1 and VCAM-1IR are high resolution color composite video cameras. Their compact
size will allow mounting in even the smallest locations. The extreme temperature rating of this camera, makes it ideal for mounting in outdoor locations in a water tight enclosure.
The VCAM-2 is a compact, high resolution color composite video camera mounted behind a standard single gang wall plate. The VCAM-2 is available in two finishes: Brushed Stainless Steel
(VCAM-2-SS) and Oil Rubbed Bronze (VCAM-2-BN). The extreme temperature rating and
Enhanced Weather Protection make this camera ideal for mounting
Model VCAM-1
and VCAM-1IR
replacement for the cameras included in the following Viking models: AES-2005, E-35, E-50,
E-65, E-75, K-1205, K-1705-3 and W-3005.
in outdoor locations.
The VCAM-1 is not compatible with IR illuminators and is a direct
VCAM-1/1IR
VCAM-1/1IR
VCAM-2
VCAM-2
Compact Color
Video Camera Kit
April 27, 2018
The VCAM-1IR has a day/night OLP (optical low pass) filter and is compatible with standard
840-850nM IR illuminators. The VCAM-1IR is the same size as the VCAM-1 allowing it to be
used in all of the above Viking products.
All cameras are equipped with Enhanced Weather Protection (EWP) for outdoor installations
where the unit is exposed to precipitation or condensation. The VCAM-1, VCAM-1IR and
VCAM-2 feature sealed connections, as well as an epoxy potted circuit board.
FFeeaattuurrees
VCAM-1 / VCAM-1-IR / VCAM-2 Features:
• High resolution color composite video camera with wide 80° viewing
angle, tilt/swivel adjustments, and wide operating temperature range
• Designed for outdoor use, all cameras come standard with Enhanced
Weather Protection (EWP), see DOD 859 for more information
• All cameras designed to meet IP66 Ingress Protection Rating
• 12V DC adapter and wire connectors included
• VCAM-1-IR only: IR illuminator compatible
VCAM-2 Features:
• Compact size: Front panel is the size of a typical single gang midsize
wall plate
• Mounting: Flush mount in a single gang electrical box (2.25” deep x
2.00” wide x 2.84” tall min) electrical box or surface mount in a Viking
model VE-3x5 (not included, see DOD 424)
• Available in 2 standard faceplate finishes: Brushed Stainless Steel
and Oil Rubbed Bronze
• PNL-VCAM-2 faceplates: Replacement faceplates with matching
screws available in both finishes
• Vandal Resistant Features: 18 gauge 304 stainless steel faceplate,
stainless steel camera mounting plate, scratch resistant powder
coating, impact and scratch resistant camera lens, and hex drive
mounting screws
• Weather Resistant Features: Faceplate gasket, sealed camera lens,
potted camera circuit board, stainless steel camera mounting hardware
• VCAM-2-BN only: UV stable weather resistant powder coating
s
Model VCAM-2
AApppplliiccaattiioonns
• Door entry
• Gate entry
• Covert surveillance
s
PPhhoonnee::771155--338866--8888661
iinnffoo@@vviikkiinnggeelleeccttrroonniiccss..ccoom
wwwwww..VViikkiinnggEElleeccttrroonniiccss..ccoom
SSppeecciiffiiccaattiioonns
Shipping Weight: VCAM-1 / VCAM-1-IR: 1.0 lbs (0.45 kg)
VCAM-2: 0.8 lbs (0.36 kg)
Operating Temperature: -40°F to 185°F (-40°C to 85°C )
Connections: (3) gel-filled butt connectors (3M Scotchlok UR2)
(See page 2 for complete specifications)
s
m
m
1
IF YOU HAVE A PROBLEM WITH A VIKING PRODUCT, PLEASE CONTACT: VIKING TECHNICAL SUPPORT AT (715) 386-8666
Our Technical Support Department is available for assistance Monday through Friday 8am - 5pm central time. So that we can give you better service, before you call please:
1. Know the model number, the serial number and what software version you have (see serial label).
2. Have your Technical Practice in front of you.
3. It is best if you are on site.
RETURNING PRODUCT FOR REPAIR
The following procedure is for equipment that needs repair:
1. Customer must contact Viking's Technical Support Department at 715-386-8666 to obtain a Return Authorization (RA)
number. The customer MUST have a complete description of the problem, with all pertinent information regarding the
defect, such as options set, conditions, symptoms, methods to duplicate problem, frequency of failure, etc.
2. Packing: Return equipment in original box or in proper packing so that damage will not occur while in transit. Static
sensitive equipment such as a circuit board should be in an anti-static bag, sandwiched between foam and individually boxed. All equipment should be wrapped to avoid packing material lodging in or sticking to the equipment. Include
ALL parts of the equipment. C.O.D. or freight collect shipments cannot be accepted. Ship cartons prepaid to:
Viking Electronics, 1531 Industrial Street, Hudson, WI 54016
3. Return shipping address: Be sure to include your return shipping address inside the box. We cannot ship to a PO Box.
4. RA number on carton: In large printing, write the R.A. number on the outside of each carton being returned.
RETURNING PRODUCT FOR EXCHANGE
The following procedure is for equipment that has failed out-of-box (within 10 days of purchase
1. Customer must contact Viking’s Technical Support at 715-386-8666 to determine possible causes for the problem. The
customer MUST be able to step through recommended tests for diagnosis.
2. If the Technical Support Product Specialist determines that the equipment is defective based on the customer's input
and troubleshooting, a Return Authorization (R.A.) number will be issued. This number is valid for fourteen (14)
calendar days from the date of issue.
3. After obtaining the R.A. number, return the approved equipment to your distributor, referencing the R.A. number. Your
distributor will then replace the product over the counter at no charge. The distributor will then return the product to
Viking using the same R.A. number.
4. The distributor will NOT exchange this product without first obtaining the R.A. number from you. If you haven't
followed the steps listed in 1, 2 and 3, be aware that you will have to pay a restocking charge.
):
Viking warrants its products to be free from defects in the workmanship or materials, under normal use and service, for a period of two years from the date of purchase from any authorized Viking distributor.
If at any time during the warranty period, the product is deemed defective or malfunctions, return the product to Viking Electronics, Inc., 1531 Industrial Street, Hudson, WI., 54016. Customer must contact Viking's
Technical Support Department at 715-386-8666 to obtain a Return Authorization (R.A.) number.
This warranty does not cover any damage to the product due to lightning, over voltage, under voltage, accident, misuse, abuse, negligence or any damage caused by use of the product by the purchaser or
others. This warranty does not cover non-EWP products that have been exposed to wet or corrosive environments. This warranty does not cover stainless steel surfaces that have not been properly maintained.
NO OTHER WARRANTIES
MERCHANTABILITY OR FITNESS FOR ANY PARTICULAR PURPOSE.
EXCLUSION OF CONSEQUENTIAL DAMAGES. VIKING SHALL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE TO PURCHASER, OR ANY OTHER PARTY, FOR CONSEQUENTIAL, INCIDENTAL, SPE-
CIAL OR EXEMPLARY DAMAGES ARISING OUT OF OR RELATED TO THE SALE OR USE OF THE PRODUCT SOLD HEREUNDER.
EXCLUSIVE REMEDY AND LIMITATION OF LIABILITY. WHETHER IN AN ACTION BASED ON CONTRACT, TORT (INCLUDING NEGLIGENCE OR STRICT LIABILITY) OR ANY OTHER LEGAL THEORY,
ANY LIABILITY OF VIKING SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE PRODUCT, OR AT VIKING'S OPTION, REFUND OF THE PURCHASE PRICE AS THE EXCLUSIVE REMEDY AND
ANY LIABILITY OF VIKING SHALL BE SO LIMITED.
IT IS EXPRESSLY UNDERSTOOD AND AGREED THAT EACH AND EVERY PROVISION OF THIS AGREEMENT WHICH PROVIDES FOR DISCLAIMER OF WARRANTIES, EXCLUSION OF CONSEQUENTIAL DAMAGES, AND EXCLUSIVE REMEDY AND LIMITATION OF LIABILITY, ARE SEVERABLE FROM ANY OTHER PROVISION AND EACH PROVISION IS A SEPARABLE AND INDEPENDENT ELEMENT OF RISK ALLOCATION AND IS INTENDED TO BE ENFORCED AS SUCH.
. VIKING MAKES NO WARRANTIES RELATING TO ITS PRODUCTS OTHER THAN AS DESCRIBED ABOVE AND DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTIES OR
PART 15 LIMITATIONS
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
TWO YEAR LIMITED WARRANTY
SSppeecciiffiiccaattiioonns
Electrical
Image Sensor: 1/4” color CMOS
Active Pixels: 640 x 480 @ 30 fps
Resolution: 420TVL
Sensitivity: 0.025 lux (50 IRE) F 1.2 3200K
Lens: 2.1mm conical pinhole
FOV(Field of View): 80° Horizontal, 60° Verticle, 100° Diagonal
Signal to Noise Ratio: 46 dB
Gamma: 0.45
Gain: Automatic 36 dB
Synchronization: Internal
Back Light Compensation: Off
White Balance: AWB
Shutter Mode: Electronic rolling shutter
Shutter Speed: Auto exposure or fixed
Frame Rate: 30 fps
Scan Mode: Interlaced
Contour Enhancement: Enabled
Dynamic Range: 73.4 dB
Iris Controls: Electronic (no DC signal)
Video Output: 1V p-p composite, NTSC, 75 Ohms
Power Input: 6-22V DC (polarity protected) UL listed 12V DC
adapter included
Power Consumption: < 150mA
Connector: 6 pin JST SHR-06V-S-B
Wire: 7” flying leads, 24 AWG stranded, yellow = video out,
red = +5VDC, black = -/GND
s
Maximum Wire Run Length: 750 ft with RG59/RG6 for video
and CAT5 for power (3 pairs) and entry phone audio (1 pair). 150
ft with CAT5E for video, power and entry phone audio (longer
video runs are possible by using video balun tranceivers, see
Installation section).
Environmental
Operating Temperature: -40°C / -40°F ~ 85° / 185°F
Storage Temperature: -40°C / -40°F ~ 90° / 194°F
Operating Humidity: 5% - 95% non-condensing
Mechanical
Dimensions WxHxD: 1.03” x 0.94” x 0.76” (26mm x 24mm x
19mm)
Weight: 0.036 lbs (13.4g)
VCAM-1/VCAM-2 IR Compatibility: This camera is equipped with
an OLP (Optical Low Pass) filter to maintain correct video color in
outside applications. The standard camera is not compatible with
IR illuminators. If IR illumination is required, see Viking model
VCAM-1IR.
VCAM-1IR: This camera is equipped with a Day/Night OLP
(Optical Low Pass) filter and is compatible with standard 840850nM IR illuminators. All other specifications are identical to the
VCAM-1/VCAM-2.
2
Loading...