Viking PIDP15L Installation Manual

Gasket

Accessory
Door Panel

Cover

Machine

Screw

Use Upper
Holeatthe

Top

Use Lower
Holeatthe

Bottom

Hole Plug

Hole
p

lug

Cover

Gasket

ICE MACHINE ACCESSORY DOOR PANEL INSTALLATION

ACCESSORY DOOR PANEL

The ice machine is supplied without a finished door panel. Accessory door panels are
offered or a custom panel may be used.

Accessory Door Panel Attachment

Note: If door swing is to be changed, it must be done before panel is attached (See
Installation Instructions).

To attach a door panel:
The panel will be held on by 6 screws and 2 machine screws (supplied).

1. Remove the gasket and retain for later use.

2. If the door panel is stainless steel, remove any plastic covering the stainless steel
panel.

3. Place the panel onto the outside of the door, and secure it to the door using two
machine screws, located at the left center and right center (behind door gasket).

4. Fasten the panel to the door using the 6 screws (supplied in kit). In the hinge area, use the outermost screw holes.

5. Place the covers over the hinge areas, and secure each cover to the door using a screw (supplied).

6. Insert hole plug over screw installed in step 5 (supplied).

7. Return the gasket to its original position.

ACCESSORY DOOR PANEL ATTACHMENT

F20759A EN (120610)