Installation
Professional Built-In Electric Warming Drawers
(Indoor and Outdoor Models)
VEWD527 / CVEWD527 / VEWD530 / CVEWD530
VEWDO530 / CVEWDO530 / VEWDO536 / CVEWDO536
Table of Contents
Warnings & Important Safety Instructions _______________________________________________3
Dimensions _________________________________________________________________________4
Specifications _______________________________________________________________________5
Cutout Dimensions (VEWD/VEWDO)___________________________________________________6
Electrical Requirements ______________________________________________________________7
General Information__________________________________________________________________8
Installation (VEWD/VEWDO) __________________________________________________________9
Final Preparation ___________________________________________________________________10
Service & Registration_______________________________________________________________11
2
IMPORTANT– Read and Follow!
Your safety and the safety of others is
very important.
We have provided many important safety
messages in this manual and on your
appliance. Always read and obey all
safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded by
the safety alert symbol and the word
“DANGER,” “WARNING” or “CAUTION.”
These words mean:
Hazards or unsafe practices
which WILL result in severe personal
injury or death
DANGER
Hazards or unsafe practices
which COULD result in severe personal
injury or death
Hazards or unsafe practices which
COULD result in minor personal injury or
property damage.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
WARNING
CAUTION
• Before beginning, please read these
instructions completely and carefully.
• DO NOT remove permanently affixed
labels, warnings, or plates from product.
This may void the warranty.
• All local and national codes and ordinances
must be observed. Installation must
conform with local codes, or in the absence
of codes, the National Electrical Code,
ANSI/NFPA70 - latest edition.
• The installer must leave these instructions
with the consumer who should retain for
local inspector’s use and for future
reference.
In Canada: Installation must be in accordance
with the current CSA C22.1 Canadian
Electrical Codes Part 1 and/or local codes.
WARNING
FIRE AND ELECTRICAL
SHOCK HAZARD
To reduce the risk of electric
shock and fire, DO NOT use a
flexible power-supply cord with
this appliance.
WARNING
For outdoor installation, installer must
install a ground fault interrupt.
WARNING
Make sure that incoming voltage is the
same as unit rating. An electric rating plate
specifying voltage, hertz, wattage, amps,
and phase is attached to the product.
Wiring the warming drawer with more
voltage than it is rated for may cause
severe damage to the thermostat,
element, and other components. Wiring
the warming drawer with less voltage than
it is rated for may cause significant
decrease in performance.
WARNING
To reduce the risk of fire, electric shock, or
injury to persons, installation work and
electrical wiring must be done by qualified
people in accordance with all applicable
codes and standards, including fire-rated
conditions.
3
Dimensions - VEWD
4
23-1/4”
(59.1 cm)
27-3/4”
(70.5 cm)
8-31/32”
(22.8 cm)
10-1/4”
(26.0 cm)
A
Custom
VEWD527/530
VEWD527 VEWD530
Overall
width A
26-1/2”
(67.3 cm)
29-1/2”
(74.9 cm)
23-1/4”
(59.1 cm)
26-3/4”
(67.9 cm)
8-31/32”
(22.8 cm)
10”
(25.4 cm)
A
Outdoor
VEWDO530/536
VEWD530 VEWD536
Overall
width A
29-1/2”
(74.9 cm)
35-1/4”
(89.5 cm)
27-3/4”
(70.5 cm)
1-3/8”
26-3/4”
(67.9 cm)
(3.5 cm)
23-1/4”
(59.1 cm)
25-3/4”
(65.4 cm)
1-3/8”
(3.5 cm)
26-3/4”
(67.9 cm)
23-1/4”
(59.1 cm)
Specifications
5
Description
VEWD527 VEWD530 VEWDO530 VEWDO536
Overall width 26-1/2”
(67.3 cm)
29-1/2”
(74.9 cm)
29-1/2”
(74.9 cm)
35-1/4”
(89.5 cm)
Overall height
(from bottom)
10-1/4” (26.0 cm)
Overall depth (from rear)
To end of handle
With drawer fully extended
27-3/4”(70.5 cm)
51-3/8” (130.5 cm)
26-3/4”(67.9 cm)
50-3/8” (128.0 cm)
Interior width 17-1/4”
(43.8 cm)
20-1/2”
(52.1 cm)
20-1/2”
(52.1 cm
25”
(63.5 cm)
Interior height 6” (15.2 cm)
Interior depth 22-3/4” (27.8 cm)
Electrical
Requirements
Hard wire direct with separate 15 amp minimum 2-wire
with ground circuit;120 VAC/50-60 Hz
Max. Amp Usage 425 watts
3.6 amps
450 watts
3.8 amps
450 watts
3.8 amps
550 watts
4.6 amps
Approx. shipping wt. 80 lb.
(36 kg)
90 lb.
(40.5 kg)
90 lb.
(40.5 kg)
110 lb.
(49.5 kg)
Rear View
VEWD/VEWDO
VEWD527 VEWD530/
VEWDO530/
Overall
width C
24-7/8”
(63.2 cm)
27-7/8”
(70.8 cm)
Dimensions
C
2”
(5.1 cm)
2” (5.1 cm)
120V Electrical Opening
(When facing cabinet, opening is
located on right side.)
8-31/32”
(22.8 cm)
Cutout Dimensions - VEWD/VEWDO
6
A
C
B
VEWD527 VEWD530
Cutout width (A) 25-1/4” (64.1 cm) 28-1/4” (71.8 cm)
Cutout depth (B) 23-1/2” (59.7 cm) 23-1/2” (59.7 cm)
Cutout height (C) 9-1/4” (23.5 cm) 9-1/4” (23.5 cm)
VEWDO530 VEWDO536
Cutout width (A) 28-1/4” (71.8 cm) 34” (86.4 cm)
Cutout depth (B) 23-1/2” (59.7 cm) 23-1/2” (59.7 cm)
Cutout height (C) 9-1/4” (23.5 cm) 9-1/4” (23.5 cm)
C
B
A
2” min.
(5.1 cm)
Outdoor
Indoor
Note: For Outdoor Models, seal around drawer opening with silicon caulk that is provided.
Flush Mount Option:
Note: To install the warming drawer in a flush mount application, a flush mount
accessory kit is required and sold separately.
VEWD527 VEWD530
Cutout width (A) 26-15/16” (68.4 cm) 29-15/16” (76.0 cm)
Cutout depth (B) 25-3/8” (64.5 cm) 25-3/8” (64.5 cm)
Cutout height (C) 10-5/8” (27.0 cm) 10-5/8” (27.0 cm)
Electrical Requirements
WARNING
Electrical shock hazard.
To avoid the risk of electrical
shock, personal injury or death;
verify electrical power is turned
off at the breaker box until the range is
installed and ready to operate, installation
by an authorized installer only.
7
Electrical Connection
VEWD527/ VEWD530/
VEWDO530
VEWDO536
Max.
amp
usage
425 watts
3.6 amps
450 watts
3.8 amps
550 watts
4.6 amps
Electrical Requirements
Check your national and local codes
regarding this unit. Hard wire direct with
seperate 120V/15 amp minimum 2-wire
wtih ground circuit. Maximum amp usage.
Note: Use copper conductors ONLY!
Grounding Instructions
This appliance must be connected to a
grounded metal, permanent wiring system,
or an equipment-grounding conductor
must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on the appliance.
With the appliance positioned in front of
the cabinet opening, connect wire leads
extending from the power supply to the
terminal block of the unit. Make sure the
colored wires of the terminal block are
connected to the corresponding colored
wires extending from the power supply.
General Information
8
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION
WHEN INSTALLING THIS
APPLIANCE.
Moving, Handling and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the
outside and inside of the warming drawer.
Some stainless steel parts may have a
plastic protective wrap which must be
peeled off. The interior should be washed
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
being used, then rinsed and wiped dry.
Solutions stronger than soap and water are
rarely needed.
• When installing this unit directly
other units, only install with Viking
Range, LLC built-in products.
• Remove warming drawer carefully from
carton. Remove all loose packaging and
accessories.
• It is the responsibility of the installer to
comply with local codes. If no local
codes are applicable, wire in accordance
with the National Electrical Code, ANSI/
NFPA 70 - latest edition.
• This appliance is not fused. Protect
with a proper sized fuse or circuit
breaker and a GFI for outdoor models.
• Line disconnect switch, circuit breaker,
GFI (for outdoor models) or
plug/receptacle of power cord
connection should be readily accessible
to the operator.
below
• Ground unit per applicable electrical
codes.
• Any installation not matching the
specifications discussed in these
instructions will void the manufacturer’s
warranty.
Installation - VEWD & VEWDO
9
1
2
1
2
Pull out warming drawer
pan until fully extended.
Slide finger along right and left side until you reach the
black hand latches (located at the front of the rails). Pull
up on both the right and left latches and pull out drawer
pan support.
3
Outdoor onlyOutdoor onlyOutdoor only
Electrical opening
(from rear)
4
Apply silicone caulk around the back
of the warming drawer trim.
Note: For outdoor models ONLY.
2
1
1
5
Feed supply cord up through
hole in rear of warming drawer.
Remove strain relief bracket and mounting
screws on the terminals.
1
2
6
Attach the white (neutral) and black (line) lead terminals.
Attach ground wire to the center terminal.
2”
(5.1 cm)
2”
(5.1 cm)
10
1
2
7
Push supply cord toward terminal
block to relieve strain, reattach supply cord strain relief
bracket over supply cord.
8
9
x4
Slide cavity assembly into the cabinet opening.
Secure the warming drawer using four
#8 mounting screws (four screws provided).
10
Replace drawer assembly.
Installation - VEWD & VEWDO
Final Preparation
• All stainless steel body parts should be wiped with hot, soapy water and with a liquid cleaner designed
for this material. If buildup occurs, DO NOT use steel wool, abrasive cloths, cleansers, or powders!
If it is necessary to scrape stainless steel to remove encrusted materials, soak with hot, wet cloths to
loosen the material, then use a wool or nylon scraper. DO NOT use a metal knife, spatula, or any other
material tool to scrape stainless steel! Scratches are almost impossible to remove.
11
Service & Registration
Only authorized replacement parts may be used in performing service on the appliance.
All servicing should be referred to a qualified technician.
Contact Viking Range, LLC at 1-888-(845-4641), for the nearest service parts distributor in your
area, visit online at vikingrange.com or write to:
VIKING RANGE, LLC
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi 38930 USA
Warming Drawer – The serial number and model number for your
appliance can be found by pulling drawer out until it stops and lifting
inner lining. Rating/Serial plate is located on the left, rear side.
Record the following information indicated below. You will need it if service is ever required.
Model number ____________________________________________________________________________________
Serial number _____________________________________________________________________________________
Date of purchase __________________________________________________________________________________
Date installed ______________________________________________________________________________________
Dealer's name _____________________________________________________________________________________
Address ___________________________________________________________________________________________
These installation instructions should remain with the unit for future
reference.
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For more product information, call 1-888-(845-4641) or
visit our web site at vikingrange.com in the US
of brigade.ca in Canada
F20664F EN
(101515)
Loading...