ViewZ VZ-SM01 Installation Instructions

VZ-SM01
ViewZ Horizontal Gondola Mount
VZ-SM01 INSTALLATION INSTRUCTIONS
Contents
Gondola Mount Installation Guide
Weight Limit 2
Warning Statements 2
Installaon Tools 3
Parts List 3
Dimension & Technical Specicaons 6
Warranty 8
.........................................................................................................................................................................................................
............................................................................................................................................................................................
...................................................................................................................................................................................................
...............................................................................................................................................................................................................
..............................................................................................................................................................................................
..................................................................................................................................................................
...............................................................................................................................................................................................................
Weight Limit
THE WALL STRUCTURE MUST BE CAPABLE OF
5 lbs
SUPPORTING AT LEAST FIVE TIMES THE WEIGHT OF THE FLAT-PANEL. IF NOT, THE WALL STRUCTURE MUST BE REINFORCED.
Warning Statements
4Installing the Mount
PRIOR TO THE INSTALLATION OF THIS PRODUCT, THE INSTALLATION INSTRUCTIONS MUST BE READ AND COMPLETELY UNDERSTOOD. KEEP THESE INSTALLATION INSTRUCTIONS IN AN EASILY ACCESSIBLE LOCATION FOR FUTURE REFERENCE.
PROPER INSTALLATION PROCEDURE BY A QUALIFIED SERVICE TECHNICIAN MUST BE FOLLOWED, AS OUTLINED IN THESE INSTALLATION INSTRUCTIONS. FAILURE TO DO SO COULD RESULT IN PROPERTY DAMAGE, SERIOUS PERSONAL INJURY, OR EVEN DEATH.
SAFETY MEASURES MUST BE PRACTICED AT ALL TIMES DURING THE ASSEMBLY OF THIS PRODUCT. USE PROPER SAFETY EQUIPMENT AND TOOLS FOR THE ASSEMBLY PROCEDURE TO PREVENT PERSONAL INJURY.
ViewZ USA DOES NOT WARRANT AGAINST DAMAGE CAUSED BY THE USE OF ANY ViewZ USA PRODUCT FOR PURPOSES OTHER THAN THOSE FOR WHICH IT WAS DESIGNED OR DAMAGE CAUSED BY UNAUTHORIZED ATTACHMENTS OR MODIFICATIONS, AND IS NOT RESPONSIBLE FOR ANY DAMAGES, CLAIMS, DEMANDS, SUITS, ACTIONS OR CAUSES OF ACTION OF WHATEVER KIND RESULTING FROM, ARISING OUT OF OR IN ANY MANNER RELATING TO ANY SUCH USE, ATTACHMENTS OR MODIFICATIONS.
At least two qualied people should perform the assembly procedure. Personal injury and/or property damage can result from dropping or mishandling the at-panel.
If mounng to wall studs or ceiling studs, make sure that the mounng screws are anchored into the center of the wall studs or ceiling studs. Use of an edge-to-edge stud nder is recommended.
It is recommended that a maximum of ⅝˝ plaster board be used when mounng to wooden studs.
Be aware of the mounng environment. If drilling and/or cung into the mounng surface, always make sure that there are no electrical wires in wall. Cung or drilling into an electrical line may cause serious personal injury.
Make sure there are no water or natural gas lines inside the wall where the mount is to be located. Cung or drilling into a water or gas line may cause severe property damage or personal injury.
This product is intended for indoor use only. Use of this product outdoors could lead to product failure and/or serious personal injury.
Do not install near sources of high heat. Do not install on a structure that is prone to vibraon, movement or chance of impact.
Contact ViewZ with any quesons: (888) 998-4399
techsupport@viewzusa.com
2 Installation InstructionsVisit the ViewZ USA website at http://www.viewzusa.com
Gondola Mount Installation Guide
Installation Tools
The following tools may be required depending on your installaon.
Electronic Stud Finder
Level
Pencil
½˝ Socket
Protecve Eye-wear
Phillips Head Screwdriver
Portable Drill
Socket Wrench
Phillips Head Screw Drill
Horizontal Gondola Mount Assembly Components - provided
Your ViewZ mount product is shipped with all proper installaon hardware and components. If there are parts missing and/or damaged, please stop the installaon and contact ViewZ USA at (888)-998-4399.
Gondola Mount
(Qty 1)
Washers
(Qty 2)
M4 x L8 Screws
(Qty 4)
Cable e 14 cm
(Qty 1)
M8 x L140 Screw
(Qty 1)
User Manual (Qty 1)
N8 Lock nut
(Qty 1)
3Installation Instructions Visit the ViewZ USA website at http://www.viewzusa.com
Loading...
+ 5 hidden pages