ViewSonic® Corporation
381 Brea Canyon Road •• Walnut, CA 91789 •• Tel: (909) 444-8727 •• Fax: (909) 444-8654
SB # VG150_SB_003
To : Authorized Service Providers Issue Date: May 10, 2001 ECO # : 1268-2
Model # : VG150 Cut-in S/N : VSE – GQ10620155, VSA – GQ10610001
S/N Range :
Target Date :
Subject: Countermeasure for failure when used with PCs equipped with hot plug detection.
Prepared By :
Tommy Jue
Purpose:
Original pin #9 of the video cable connection in PCB layout was connected to GND. This will cause error for
some PC systems when system pin #9 is connected to +5V. Cutting the trace on the PCB will resolve this issue.
Service Bulletin Application: ASP Distribution:
Recall. - USA ASP
Service Inventory, Repairs In-Process & No Problem Found (NPF). - Canada ASP
Repairs In-Process & NPF. - Latin America ASP
Repairs In-Process. - 3rd Party ASP
Technician judgement for unit under service (symptomatic). - Supplier Service ASP
Approved By :
Richard Tanimoto
- Limited ASP
- ViewSonic Internal
- Complete ASP Listing
Change(s)/Countermeasure(s):
Part Location Part Description Part Number Repair Action Comment Failure
Video cable
input connector
*Note: Repair action(s) that consist of the countermeasures contained in this or any other service bulletin(s), shall use D5 as the repair code. All other repair
action(s) outside of the service bulletin(s) shall use the appropriate repair codes contained in the Repair and Defect Codes Handbook (i.e. C7).
Cut trace for pin #9 on the
PCB board.
See photos GOA D5
Code
Repair
Code
Cut trace here
between pin #9
and #10.
Please contact the Quality Assurance Department at (909) 444-8727 for further information.
FORM: SERVBULL_4.19_V5 Page 1 of 1 7/3/2000
Ref.