Vidonn Information Technology Q2 User Manual

User Manual

Vidonn

Wireless Bone Conduction Headphones

Model: Q2

Bone conduction wireless headphones+MP3

User guide

Specifications

Power output---------------------------------750 mW

Headphones------------------------------------10.8mm driver

Frequency response---------------------------250Hz~20KHz

Rechargeable Lithium-ion battery----------3.7v, 175mA

Battery life----------------------------------------up to 3 hours

Charging time------------------------------------ approx. 1.5 hours

Weight---------------------------------------------approx. 31g

Size----------------------------------------------111mm(W)*120mm(L)*44mm(H)

Charge

1. Charge the headphones with the included Micro USB charging cable,

the USB output should be 5V, 0.5A or above, the headphones will be

fully charged in approximately 1.5 hours.

2. The LED indicator is red while charging, it will turn into blue when the

headphones are fully charged.

3. When the power is less than 30%, the LED indicator will flash red and

then turn off automatically when power runs out.

Wearing

Hang the speaker on ears as follow, make the speaker close to ear.

Wireless mode:

1. Pairing:

While F1 is power off, press the Power on/off button for 3

seconds, the LED flashes red and blue alternately and there is

voice prompt by the word “Pairing”, the LED flash blue after

paired.

Enter into pairing mode again:

Press and hold the Play/Pause button for 3 seconds while paired,

the LED flashes red and blue alternately, there is voice prompt by

“Pairing”, the LED flash blue after paired.

Note:

After paired, the headphones will pair with device automatically

if the device’s Bluetooth is on, if the headphones don’t pair

automatically, you may need to pair manually in device’s

“Settings-Bluetooth”, choose “Q2”.( This depends on the model

of devices)

2. MP3 mode:

Single click the Power on/off button while power is on, enter into

MP3 mode.

3. Instruction of buttons:

3.1 Press Volume + button to increase the volume.

3.2 Press Volume – button to decrease the volume.

3.3 Press Play/Pause button once to play or pause the audio.

3.4 Press and hold Volume + button for 3 seconds to move one track

backward.

3.5 Press and hold Volume - button for 3 seconds to move one track

forward.