Victorinox SWISSTOOL - REV 2010, SWISSTOOL User Manual
For more information about our complete line of products, please visit us
on-line at www.swissarmy.com.
© Victorinox Swiss Army, Inc. 2010. All Rights Reserved
OUR PRODUCTS
Victorinox produces and sells unique, high quality
products worldwide which are of practical use in
differing areas of life: Swiss Army Knives, Cutlery,
Timepieces, Travel Gear, Fashion and Fragrances.
The head office of the company is in Ibach, Schwyz,
in the heart of Switzerland, where founder Karl
Elsener first set up his cutler’s business in 1884 and,
a few years later, designed the legendary “Original
Swiss Army Knife”.
OUR LEGACY
14257 REV2010
SWISSTOOL
Tm
Extend each implement halfway, then apply a
few drops of oil at the base of that implement.
After seawater contact, rinse the tool immediately with fresh water. Then dry it well and oil the
marked areas.
MAINTENANCE
➯
Only when you see the
name Victorinox® stamped
on the blade can you be
assured you have the
Original Swiss ArmyTM Knife.
CONVENIENCE AND USE
Be extremely careful when handling and using implements as many have
sharp and/or pointed edges. Acc ess plier and wire cutter by opening
handles; wire cutter is loca ted at the base of the plier jaw s. To close, reve rse
opening procedu re. To ope n handle implements, grasp implement and pull out
slowly until locked in place. To close, release slide mechanism and carefully fold
implement back into the handle.
LOCK RELEASE
Sliding the button back towards the
SwissTool unlocks the implement, and
allows it to fold back into place.
2
1
CORKSCREW AVAILABLE ON SWISSTOOL SPIRIT PLUS AND
SWISSTOOL CS PLUS
To use: Gray portion of mini-screwdriver screws into corkscrew with screwdriver
tip facing-out. Then screwdriver slots into tool as shown above.
CAUTION
Never use the SwissTool implements at 90º; always fully extend and
lock implements before use.
Victorinox guarantees all Swiss Army Knives to be of first class steel and provides a lifetime guarantee against any defects in material and workmanship.
The warranty does not apply to damage caused by abnormal or unreasonable
use of any of the implements (including repairs or alterations other than by our
Authorized Repair Center).
This warranty gives you specific legal rights. Additional rights m ay be
available under the laws of your State or Province. It is in place of all other
warranties, i ncluding warra nty of fitness for a particu lar purpose and
warranty of merchantability and excludes any liability for incident al or
consequential damages.
LIFETIME LIMITED WARRANTY
If your Swiss Army Knife has a manufacturer’s defect covered by our warranty, we will either repair or replace it, at our option, without charge. Please
send to the address below. Include a brief description of the issue along
with your name, address, phone number and e-mail address (optional) with
your return. In California and other states so requiring, you may return the
Swiss Army Knife through your place of purchase.
A damaged Swiss Army Knife not covered by the warranty can be repaired.
Note that repair costs and handling charges may apply. If so, you will be notified
prior to any service. Please send to the address below. Include a brief description of the issue along with your name, address, phone number and e-mail
address (optional) with your return.
Service Center: Victorinox Swiss Army Service Center, 7 Victoria Drive, Monroe
CT 06468-1212
REPAIRS
35 Features
SwissTool features 1-27 plus:
28 Bit Case
29 Bit Wrench
30 Hex #3
31 Hex #4
32 Phillips #0
33 Phillips #3
34 Torx #10
35 Torx #15
SWISSTOOL PLUS
27 Features
SwissTool features ,
replacin g Serra ted
Blade with Scissors.
SWISSTOOL X
26 Features
SwissTool features, replacing
Metal File, Metal Saw, and
Serrated Blade with Scissors
and Seatbelt Cutter.
SWISSTOOL RS
37 Features
SwissTool X
features 1-27 plus:
28 Bit Case
29 Bit Wrench
30 Hex #3
31 Hex #4
32 Phillips #0
33 Phillips #3
34 Torx #10
35 Torx #15
36 Corkscrew
37 Patented Mini-screwdriver
SWISSTOOL CS PLUS
6 Bits, Bit Case
and Bit Wrench
Fully extend to use rulers.
Wire cutter for regul ar
wire (up to a hardness
of 40 hrc)
Important:
Cut hard wire
here only
4
1
6
17
13
14
21
8
12
9
10
11
15
5
3
18
7
16
2
22 (reverse)
23
19
20
26
25
24
SWISSTOOL
27 Features
1 Pliers
2 Screwdriver (2mm)
3 Screwdriver (3mm)
4 Wire Cutter
5 Screwdriver (5mm)
6 Bottle Opener
7 Screwdriver (7.5mm)
8 Large Blade
9 Serrated Blade
10 Metal File
11 Metal Saw
12 Wood Saw
13 Reamer
14 Phillips Screwdriver
15 Chisel / Scraper
16 Strong Crate Opener
17 Wire Bender
18 Wire Stripper
19 Wire Scraper
20 Can Opener
21 Ruler (230mm)
22 Ruler (9 inches)
23 Wire Crimper
24 Hard Wire Cutter
25 Lanyard Hole
26 Easy Kickback Springs
27 Lock Release
27
SWISSTOOL SPIRIT
38 Features
SwissTool Spirit features plus:
28 Case
29 Bit Wrench
30 Bit Hex #3
31 Bit Hex #4
32 Bit Phillips #0
33 Bit Phillips #3
34 Bit Torx #10
35 Bit Torx #15
36 Space for additional Bits
37 Patented Mini-Screwdriver
38 Corkscrew
SWISSTOOL SPIRIT PLUS
7
6
5
13
2
17
15
18
16
21
19
8
12
23
11
10
25
9
14
20
3
24
4
1
27
26
1 Needlenose Pliers
2 Screwdriver (2mm)
3 Screwdriver (3mm)
4 Wire Cutter
5 Bottle Opener
6 Screwdriver (6mm)
7 Crate Opener
8 Combi-edge Blade
9 Scissors
10 Metal File
11 Metal Saw
12 Wood Saw
13 Reamer and Punch
14 Phillips Screwdriver
15 Chisel / Scraper
16 Isolation
Length-Cutter
17 Wire Bender
18 Wire Stripper
19 Wire Scraper/
Round-Cutter
20 Can Opener
21 Multi Purpose
Hook
22 Leather or Nylon
Pouch
23 Coupling
for Corkscrew
24 Hard Wire Cutter
25 Lanyard Hole
26 Easy Kickback Springs
27 Lock Release
27 Features
Loading...