Page 1
ZigBee Pro Module Installation Guide
VT8000 Series Room Controllers
Optional ZigBee Pro Module (VCM8000V5000P)
Page 2
2
ZIGBEE PRO MODULE INSTALLATION
Installation
1. Remove security screw (if any) on bottom of Room Controller cover.
2. Open unit by pulling on bottom side of Room Controller (Figure 1).
3. Carefully remove Room Controllers Motherboard from casing and turn
over.
4. Locate gap in upper-right corner of Room Controllers Motherboard and
locate holes to insert ZigBee Pro module to Motherboard (Figure 2).
5. Align connector pins on ZigBee Pro module with holes on Motherboard
NOTE: ensure alignment of pins is correct so as to not damage ZigBee
Pro module.
6. Gently press ZigBee Pro module into Room Controllers Motherboard until
it fits snugly in place.
NOTE: do not press too hard to avoid damage to ZigBee Pro module.
7. Gently replace Room Controllers Motherboard into casing.
8. Gently align cover to top of base and snap in place from bottom
(Figure 3).
9. Install security screw (if any).
Installation Guide
Figure-1
ZigBee Pro Module
Viconics Technologies Inc. | 9245 Lang elier B lvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax : (514 ) 3 21- 4150
028-0425-01 www.viconics.com Ma y 2015
Figure-2
Figure-3
© 2015 Viconics Technologies. All rights reserved.
Page 3
Installation Guide
ZigBee Pro Module
Quick Setup
The quick set-up shows how to pair a ZigBee sensor with a Room Controller. It assumes that all the back-end
configuration of the stand alone Room Controller acting as coordinator or the Multi-Purpose Manager (MPM)
coordinator for the ZigBee network is complete. It assumes the User is familiar with the Permit Join function and the
Wireless Ecosystem screen functions.
PROCEDURE
1. Set Permit Join on Room Controller (or networked MPM coordinator if used) to On.
2. Go to first unused Zone screen in Wireless Ecosystem section of Room Controller’s interface.
3. Insert battery or remove pull tab (for contact sensors) to activate ZigBee sensor.
4. Verify sensor has joined network and Paired field status reads Yes on Zone screen.
5. Set the Set function to parameter.
6. Set Permit Join on Room Controller (or networked MPM coordinator if used) to Off.
7. Do step 7 for door or window contact sensors. Otherwise go to step 8.
a. Go to first screen in Configuration section of interface.
b. For window sensor, set UI 16 to Window.
c. For door sensor, set UI 17 to Door Dry.
3
8. Physically install sensor.
TROUBLESHOOTING
If the short procedure described here is insufficient or an MPM or Room Controller needs to be configured, refer to the
VT8000 Room Controllers ZigBee Pro Wireless Integration Guide available at www.viconics.com.
Viconics Technologies Inc. | 9245 Lang elier B lvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax : (514 ) 3 21- 4150
028-0425-01 www.viconics.com Ma y 2015
© 2015 Viconics Technologies. All rights reserved.
Loading...