Vibra-Tite 730 Technical Data

730 Cure Rate

0

20

40

60

80

100

120

5 20 30 1 4 8 24

Cure Time

Percent of Cure

Product Description

Vibra-TITE 730 Gasket Maker is a single
component, medium strength, thixotropic, anaerobic
sealant which cures when confined between close
fitting metal surfaces. 730 Gasket Maker provides an
instant low pressure seal.

Typical Applications

730 Gasket Maker seals joints between rigid metal
faces and flanges such as valve covers and gearbox
casings. This product can be used with or without
pre-cut, pre-formed gaskets.

Instructions for Use

Ensure parts are clean, dry and free from oil and
grease.

Procedure for Application

Product is normally hand applied from the bottle onto
parts.

Compatible Primers

Vibra-TITE Excel 611 (Primer N) can be used. The
use of primers can cause loss of strength and
performance should be tested.

Technical Features

Resin:...............Modified Urethane Acrylate

Color:....................................Red

Fixture Speed w/Activator……<10 minutes
Fixture Speed w/out Activator……….20 min
Viscosity(Thixotropic).250,000/750,000 cps

Gap Fill............................................... .125"

Max. Operating Temp…….-65°F to +300°F

Environmental and Fluid Resistance

(Shear strength values)
Typical Values
Heat age 100%
Engine oil@ 150oC 100%
Brake fluid @ 150oC 80%
ATF @ 150oC 85%
50/50 water/
ethylene glycol @ 120oC 85%
Water @ 100oC 80%
Gasoline @ 25oC 85%
Diesel fuel @ 25oC 100%
Ethyl Alcohol @25oC 90%

Technical Data Sheet

Vibra-Tite® 730

Flexible Gasket Maker

April 2017

Cured Performance

Full Cure Time.................24 hours @ 68°F

Shear Strength……………..900-1500 psi

Presentation

Tubes....................................50ml & 250ml

General Information

Storage

Product should be stored in a cool and dry location at
temperatures between 14°F (-10°C) to 86°F (30°C).
Shelf life is 2 years from date of manufacture when
stored at 72±8°F (22±4°C).

Note

Where gap size is large or where the surface is
uneven, apply a Vibra-TITE primer to help cure the
product through volume. Gasket Maker can be roller
coated, screen printed or applied by pads. Product
conforms to GM-1182863

Health & Safety in use

IRRITANT: Contains Methacrylate Esters which

may irritate eyes, respiratory organs and skin. In

case of contact with the skin, wash immediately

with plenty of water.