Vibra-Tite 710 Technical Data

Technical Data Sheet

Vibra-Tite® 710

Flexible Gasket Maker

September 2012

Product Description

Vibra-TITE 710 Gasket Maker is a single
component, medium strength, thixotropic, anaerobic
sealant which cures when confined between close
fitting metal surfaces. 710 Gasket Maker provides an
instant low pressure seal.

Typical Applications

710 Gasket Maker seals joints between rigid metal
faces and flanges such as valve covers and gearbox
casings. This product can be used with or without
pre-cut, pre-formed gaskets.

Instructions for Use

Ensure parts are clean, dry and free from oil and
grease.

Procedure for Application

Product is normally hand applied from the bottle onto
parts.

Compatible Primers

Vibra-TITE Excel 611 (Primer N) can be used. The
use of primers can cause loss of strength and
performance should be tested.

Technical Features

Resin:...Polyethylene Glycol Dimethacrylate

Color:.....................................................Pink

Fixture Speed w/out Activator…….<90 min
Viscosity(Thixotropic)...100000/500000 cps

Gap Fill............................................... .125"

Max. Operating Temp…….-65°F to +300°F

Cured Performance

Full Cure Time.................24 hours @ 68°F

Shear Strength……………..900-1500 psi

Presentation

Tubes....................................50ml & 250ml

General Information

Storage

Product should be stored in a cool and dry location at
temperatures between 14°F (-10°C) to 86°F (30°C).
Shelf life is 2 years from date of manufacture when

stored at 72±8°F (22±4°C).

Note

Where gap size is large or where the surface is
uneven, apply a Vibra-TITE primer to help cure the
product through volume. Gasket Maker can be roller
coated, screen printed or applied by pads.

Health & Safety in use

IRRITANT: Contains Methacrylate Esters which
may irritate eyes, respiratory organs and skin. In case
of contact with the skin, wash immediately with
plenty of water.