Vestil LAD Instructions Manual

Website: www.vestilmfg.com e-Mail:
info@vestil.comU
Table of Contents
Limited Warranty……………………………………………………………………………………………………………..…...
11
Table of Contents Rev. 11/19/2019 LAD (1-5 STEPS), MANUAL
Vestil Manufacturing Corp.
2999 North Wayne Street, P.O. Box 507, Angola, IN 46703
Telephone: (260) 665-7586 -or- Toll Free (800) 348-0868
Fax: (260) 665-1339
HU
LAD-series Portable Warehouse Ladders, 1-5 Steps
Instruction Manual
After delivery, remove the packaging from the product. Inspect the product closely to determine whether it sustained damage during transport. If damage is discovered, record a complete description of it on the bill of lading. If the product is undamaged, discard the packaging.
NOTE: The end-user is solely responsible for confirming that product design, use, and maintenance comply with laws, regulations, codes, and mandatory standards applied where the product is used.
Technical Service & Replacement Parts
For answers to questions not addressed in these instructions and to order replacement parts, labels, and accessories, call our Technical Service and Parts Department at (260) 665-7586. The department can also be contacted online at http://www.vestilmfg.com/parts_info.htm
.
Electronic Copies of Instruction Manuals
Additional copies of this instruction manual may be downloaded from https://www.vestil.com/page-manuals.php
.
Signal Words…………..…………………………………………………………………………………………………………... 2
Safety Instructions……..……………………………………………………………..………………………………………….... 2
Specifications, Exploded Views, and Bills of Materials…………………………………………………….…….…3, 4, 5, 6, 7
Assembling the Ladder……………………………………………………………………………………………………......... ... 8
Record of Satisfactory Condition…………………………………………………………………………………………………. 9 National Standards………………………………………………………………………………………………………………… 9 Using the Ladder…………………………………………………………………………………………………………………... 9 Inspections & Maintenance…………………………………………………………………………………………………...9 - 10 Labeling Diagram………………………………………………………..………………………………………………………...10
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 1 of 11
.....
Table of Contents Rev. 11/19/2019 LAD (1-5 STEPS), MANUAL

SIGNAL WORDS

This manual uses SIGNAL WORDS to indicate the likelihood of personal injuries, as well as the probable
seriousness of those injuries, if the product is misused in the ways described. Other signal words call attention to uses of the product likely cause property damage. The signal words used appear below along with the meaning of each word:
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
Identifies practices likely to result in product/property damage, such as operation that
SERIOUS INJURY. Use of this signal word is limited to the most extreme situations.
SERIOUS INJURY.
might damage the crane.
SAFETY INSTRUCTIONS
Vestil strives to identify foreseeable hazards associated with the use of its products. However, no manual can address every conceivable risk. The most effective way to avoid injury is to exercise sound judgment when assembling, using, inspecting, and maintaining this ladder. Keep a copy of this manual with the ladder at all times. For example, put the copy inside a plastic pouch and attach the pouch to the frame. Anyone who uses this ladder must be made aware that a copy of the manual is available and where to find it.
Improper or careless use could result in serious personal injuries or death.
Read and understand the entire manual before assembling, using, inspecting, or servicing the ladder.
DO NOT use this ladder unless you are in good health. NEVER use the ladder while under the influence of
alcohol or drugs, including prescription medication that affects balance, perception, or judgment.
DO NOT exceed the capacity/rated load. The total weight applied to the ladder (weight of the user plus tools, etc.)
must not be greater than the capacity. The capacity is provided on label 287. See Labeling Diagram on p. 10.
Wear appropriate footwear. DO NOT wear high-heeled shoes or footwear with smooth soles.
DO NOT use the ladder on uneven, sloped, or unstable surfaces. ONLY use the ladder on even, level, improved
surfaces (concrete or asphalt).
Make sure that you will not contact overhead objects with either your body or with the ladder during use.
Avoid electrical shock! Take precautions to prevent any contact, or possible contact, with an energized, insulated
conductor (electrical line).
Remove foreign matter, e.g. mud, from your shoes before walking on the ladder. Only wear slip-resistant shoes.
Only stand on the steps. DO NOT climb on the railing. DO NOT slide on the railing.
DO NOT access, or egress from, any step from another elevated surface unless the ladder is positively secured
against movement.
ALWAYS face the stairs and use the handrails while ascending and descending the ladder.
DO NOT increase the height of a step by standing on other objects placed on the ladder.
Inspect the ladder as described in Inspections & Maintenance on p. 9-10. DO NOT use the ladder unless it is in
Satisfactory Condition. ONLY use manufacturer-approved replacement parts when repairs are necessary.
DO NOT use the ladder if the caster guards are significantly worn. See applicable Exploded View on p. 3-7. Guards
should prevent the ladder from sliding. Replace worn and damaged guards before using the ladder.
ONLY use the ladder to access elevated working positions. DO NOT use the ladder for any other purpose. DO NOT
store materials and/or equipment on the steps. Always unload the ladder before leaving it unattended.
DO NOT position an occupied ladder in front of a door unless that door is secured in an open position, is locked, is
attended, or is barricaded.
DO NOT lean, or reach, over the side rails or handrails of the ladder. Position the ladder as close to the work as
possible. Reposition the ladder to prevent overreaching. Overreaching could cause instability and result in a fall.
Avoid sudden shifts while on the ladder.
DO NOT push, pull, or lean on the handrails.
DO NOT skip steps. Climb the ladder one step at a time.
DO NOT attempt to move the ladder while someone is using it. The ladder must be unoccupied before it is moved.
DO NOT use the ladder to transport people or objects. DO NOT ride on the ladder.
DO NOT remove or obscure any label. Each label must be readable, undamaged, and present in the appropriate
location. See Labeling Diagram on p. 10.
DO NOT modify this ladder! Unauthorized modifications automatically void the Limited Warranty (p. 11) and might
make the ladder unsafe to use.
While assembling this ladder, confirm that only locking fasteners are provided, i.e. only locking nuts. Contact
Technical Service (p. 1) if you find non-locking nuts. Only lock nuts should be used. However, lock nuts can only
safely be used once. Discard the used lock nut and install a new lock nut after unfastening a connection.
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 2 of 11
Table of Contents Rev. 11/19/2019 LAD (1-5 STEPS), MANUAL
SPECIFICATIONS, EXPLODED VIEWS, AND BILLS OF MATERIALS (P. 3-7)
information is provided on the cover page of this manual.
Net
weight
LAD-1-B-P
LAD-1-W-P
LAD-1-B/Y/W-P
LAD-1-B/Y/W
Net
weight
LAD-1-B
LAD-1-W
Item
Part no.
Description
Qty.
1
44-514-041
Step weldment
1 2 16-632-001
Assembly, caster guard/cover
4
3
44-016-035
Caster collar
4
5
44-147-027
Rubber grip matting (top step)
1
Item
Part no.
Description
Qty.
1
44-514-200
Step weldment
1
2
16-632-001
Assembly, caster guard/cover
4 3 44-016-035
Caster collar
4
Documents that provide specifications for LAD series mobile ladder stands are available online to anyone who visits the Vestil website. Specifications include dimensions, net weight, and capacity information. Acquire the appropriate specifications document by opening this webpage: https://www.vestil.com/product.php?FID=607. Click the “Specifications” tab. Scroll the page to the entry for the product you purchased. Click the button in the “PDF” column that looks like a pencil inside a blue-bordered box. A PDF file will open. This file is the specifications document. Print a copy of the document and keep it with your copy of this manual.
Information that appears on p. 3-7 is subject to change, so you should print the specifications document from the website as soon as your ladder is delivered. If information in the specifications document differs with any information on p. 3-7, or if you cannot access and/or print the specifications document, contact Technical Service
. Contact
4 28963
Model
LAD-1-Y
10-24 x 5/8” Phillips machine screw
Model
LAD-1-Y-P
19 lb.
8.5 kg
20 lb.
8.7 kg
Capacity
300 lb.
136.4 kg
4
Capacity
300 lb.
136.4 kg
4 28963
10-24 x 5/8” Phillips machine screw
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 3 of 11
4
LAD-2-B/Y/W
Model
Net weight
Capacity
LAD-2-B
LAD-2-W
Model
Net weight
Capacity
LAD-2-B-P
LAD-2-W-P
Item
Part no.
Description
Qty.
1
44-514-042
Step weldment
1 2 16-632-001
Assembly, caster guard/cover
4
3
44-016-035
Caster collar
4
5
44-147-026
Rubber grip matting
1
6
44-147-027
Rubber grip matting (top step)
1
Item
Part no.
Description
Qty.
1
44-514-201
Step weldment
1 2 16-632-001
Assembly, caster guard/cover
4 3 44-016-035
Caster collar
4
LAD-2-B/Y/W -P
Table of Contents Rev. 11/19/2019 LAD (1-5 STEPS), MANUAL
LAD-2-Y
4 28963 10-24 x 5/8” Phillips machine screw 4
LAD-2-Y-P
26 lb.
11.8 kg
27 lb.
12.2 kg
300 lb.
136.4 kg
300 lb.
136.4 kg
Table of Contents Copyright 2019 Vestil Manufacturing Co. Page 4 of 11
4 28963
10-24 x 5/8” Phillips machine screw
4
Loading...
+ 7 hidden pages