CONSERVATORS
MANUAL OF INSTRUCTIONS FOR USE AND INSTALLATION
Field of application
The freezer is designed to store frozen foods.
Placing
The freezer must be placed on a firm and flat
surface. To ensure a correct functioning a good
air circulation around the freezer is imperative.
Between the air intake and the wall (at the compressor end) there should be at least 10 cm/4 in
and on the other sides at least 3 cm/1.5 in.
The appliance should stand in as cool as
possible and not be exposed to radiant heat from
the sun or other source of heat.
manufacturer does not give guarantee for any
consequent damages.
Near the freezer there should be an accessible
switch. No other current-consuming devices
should be connected to the same socket as the
freezer.
Many electric installations are equipped with an
GFI-relay . This rela y cuts off the current in case
of a leakage and thus gives security against
most accidents caused by electricity.
In regions where the electricity supply takes
place through overhead wires the lightning during a storm may affect the installation in such a
way that the GFI-relay cuts off the current. This
circumstance should be considered when the
appliance is placed in areas where a power cut
would not be noticed immediately. This
possibility should be considered when installing
the product.
Note: Some models are equipped with a detachable locking device . If the lock is not used it
should be kept out of reach of children.
Locking device
Push the lids against the ends so that the hole
at the end of the lid catches the pin mounted on
the frame. The locking device (key + lock) is
inserted in the keyhole, tumed to the right and
locked.
Mains connection
The freezer should be connected to a grounded
wall socket supply of 115 V 60 Hz A.C. via a 10
A fuse or circuit breaker. Permissible voltage
variations +/- 10%. Larger variations ma y affect
the operation of the freezer and the
Operation and temperature control
The thermostat is placed on the right side of
the freezer at the air intake of the compressor
(the gill grate).
The thermostat knob which is tumed with a coin
has continuously variable setting. The w armest
position is obtained by tuming the knob counter-clockwise whereas tuming clockwise gives
the lowest temperature.
The temperature in the freezer depends on the
ambient temperature, the quantity of goods, the
temperature of the goods when placed in the
freezer, how often the lid is opened, etc. If the
freezer is full the thermostat is set on a lower
temperature in order to ensure that the storage
temperature is sufficiently low also in the upper
packages.
Lamps (some models only)
The alarm lamp (red) lights up if the inside temperature of the chest freezer becomes too high,
i.e there is a risk that the frozen foods will thaw .
In the following situations the lamp may light up
without there being any risk as to the frozen
foods:
- when starting up the appliance,
- when placing major quantities of fresh
foods in the appliance and
- if the lid has been opened for some time.
The mains-on lamp (green) will stay lit as long
as the appliance is connected to the mains outlet and as long as the automatic adjustment of
temperature functions. If the mains plug is removed or if the power supply f ails due to other
reasons the lamp will switch off.
Starting
The freezer is plugged in and the thermostat is
set so that the temperature is always below
-18°C. Let the freezer run for a few hours be-
fore the frozen foods are placed in the freezer.
Packing and placing
The packing of the goods must be air- and moisture-proof to avoid drying. The freezer should
only be filled up to 30 mm (12 in) from the edge
of the inner tank.
Do not put bottles in the freezer to cool as the
liquid may burst the bottles when freezing.
Storage times
Notice that the storage times vary with the different foods . See the handbooks to the storage
of foods.
In case of prepacked frozen foods the manufacturer’s instructions should always be followed.
General advice
If the freezer will not start the following points
should be checked before you call in a service
engineer:
- that the plug is plugged in properly.
- that the fuse has not blown or breaker triffed.
- that the power supply has not been interrupted.
If the compressor makes repeated attempts to
start but still does not start running, tum off the
freezer and let the compressor rest for 15 to 20
minutes before another attempt to start is made.
It is quite normal that sometimes the freezer
feels warm on the outside. This is due to the
fact that the heat dev eloped during the freezing
process is emitted from the outer casing. At the
same time this heat prevents condensation of
moisture which could otherwise result in rusting.
Defrosting
Frost on the inner sides of the freezer cannot
be avoided. The formation of frost is the result
of the moisture of the air moving towards the
cold surfaces of the freezer .
Note! Non-tight-fitting packing also gives off
moisture which contributes to the formation of
frost. The lid should not be opened unnecessarily and never be left open for long. A thin
coat of frost or ice does not disturb the functioning of the freezer. When the coat of frost or
ice is approx. 5 mm (0.2 in) thick the freezer
should be defrosted.
The current is switched off. The goods are removed, packed in newspapers, blankets, or
simili and placed in a cool place.
Loose frost may carefully be removed with a
plastic scraper. Ne ver use a knife or other sharp
tool which may damage the freezer or the refrigerating system. The defrosting may be hastened by placing one or more bowls with hot
water in the freezer. After some time the lid is
opened and the loosened coat of ice is carefully removed. Never hasten the defrosting with
other source of heat than hot water as you may
otherwise damage the material of the freezer
or even cause a fire .
The defrosting should always be combined with
a cleaning of the freezer.
Cleaning
The freezer should be cleaned carefully from
time to time. The current must be switched off
and the plug is pulled out. The freezer should
be washed on the inside and on the outside with
lukewarm water with an unscented detergent
added. Grease and the like should be carefully
washed off. Leave the freezer open for some
time and let it dry thoroughly. Close the lid and
reconnect the appliance to the supply. After
approx. 20 minutes the goods ma y be put back
in the freezer.
If the freezer does not operate
satisfactorily
Check the following bef ore y ou call in a
service engineer:
- that the appliance is plugged in properly
and that the current is switched on.
- that the fuse has not blown or breaker
tripped.
- that there is no power cut.
- that the thermostat setting is correct.
- that the lids are closed properly .
- that the freezer is not placed too close to a
source of heat.
- that the interior coat of ice or frost is not
too thick.
If the compressor makes repeated attempts to
start but in vain, turn off the freezer for
approx. 20 minutes and try again. Do not
perform other operations. The wrong procedure may result in personal injuries or cause
further functional problems.
Equipment
Some models are equipped with lock and/or wire
baskets. A wire basket keeps the frozen foods
in order and facilitates positioning.
Additional equipment
Lock and wire baskets can be obtained from
the dealer as additional equipment.
Rights to alterations reserved.
Loading...