Vertical Xcelerator IP Quick Start Guide

Quick Start Guide

P/N 7552-00

UNPACKING THE BOX CONTENTS

1

You will need the following parts to complete the installation of your Xcelerator IP

START HERE

It is strongly recommended that you follow

these step by step instructions to set up

and quickly start to use your Xcelerator IP

gateway.

XCELERATOR IP GATEWAY

INSTALLING THE XCELERATOR IP GATEWAY

2

If the Xcelerator IP gateway is to be wall mounted, print a
copy of the wall mount template from the documentation CD
for use in lining up the screw mounts with the mounting holes
in the gateway. To mount the Xcelerator IP on a table or other
flat surface, insert the Xcelerator IP gateway unit into the
provided stand.

Next, mount the antenna to the threaded connection on the
upper side of the Xcelerator IP gateway chassis. Once
mounted, the antenna must be fully extended for proper
operation as depicted in the diagram.

AC POWER ADAPTER

ANTENNA

GATEWAY STAND

Documentation

DOCUMENTATION CD

POWER THE XCELERATOR IP GATEWAY

3

Once the Xcelerator IP has been mounted, attach the AC power adapter to the “Power In” connector on the interface
panel of the gateway. Plug the AC power adapter into a grounded 120VAC power source. Move the ON/OFF switch
to the ON position.

A blue LED above “Power” on the front of the Xcelerator IP will indicate the gateway is powered and ready to
continue with the installation of the unit.

STARTING TO USE THE XCELERATOR IP

4

On new installations, or if the system is defaulted, the Xcelerator IP will start with a configuration Wizard to assist
with the installation. Refer to the Administrator Guide for details on the programming of the Xcelerator IP.

Attach a PC or laptop to the Xcelerator IP via one of the Ethernet ports or via
a wireless connection.

Open your internet browser and type in 192.168.1.1. This is the default
address of the Xcelerator IP Admin interface. The default password is
“admin” and the default user name is “admin”.

CONNECTIONS

5

A detailed description of the operation of these ports can be found in the Administrator Guide on the documentation
CD included with the Xcelerator IP gateway.

10/100baseT

Connectors for

RJ45 Wide Area

Network connection

for cable modem/

DSL modem

IP2007 phones or

Ethernet switch

RJ11

Connector for

Analog SLT

phone or fax

machine

Analog CO

Telephone lines

AC Power
connector

ON/OFF

Switch

Switch or

POE Switch

STATUS INDICATORS

6

Standalone
PCs can be

routed

through the

Xcelerator IP

IP2007 can be

connected to
Xcelerator IP

or hub/switch

The IP2007 contains a 10/100 switch which allows for

connecting a PC to the network via the phone’s Ethernet

Note: Refer to the IP2007 User

Guide for installation and use of the

IP2007 telephone

connection

The Xcelerator IP status LED lamps provide real time indicators of the operation of the gateway and can be used to
assist with troubleshooting.

When the specific lamp is lit, it is indicating:

Transmission and receipt of

data on the individual ports

Analog SLT port is in use

TELCO Trunk is in use

Wireless Access Point is active

Power ON

WAN port

connected