Rack-Mount VHF/UHF FM Repeater
32 CHANNELS SYNTHESIZED
POWER OUTPUT: 50/25/10 W (HIGH/MID/LOW)
(100 W / Option)
WIDE OR NARROW BANDWIDTH
PROGRAMMABLE
PER CHANNEL
PLL STEP SIZES: 2.5/5.0/6.25 kHz
LOW LEVEL AND HIGH LEVEL ENCRYPTION
OPTIONS
8 cm SQUARE COOLING FAN WITH
"MALFUNCTION"
SENSOR OUTPUT
CTCSS REVERSE BURST WITH
PROGRAMMABLE LENGTH
MULTI-TONE DECODE
5-STEP COMMAND SEQUENCE FOR STARTUP,
POWER SOURCE: MAIN TO SUB, AND SUB TO MAIN
CW ID AND CW MESSAGES SELECTED BY TRIGGER
COAXIAL RELAY DRIVERS FOR SINGLE
ANTENNA OPERATION; ALSO TX ATTENUATOR
PROGRAMMED MESSAGE BANKS FOR
MAINTENANCE LOGS OR ANY OTHER FREE TEXT
REPEATER OCCUPATION SETTINGS TO HOLD
THE LAST TONE CODE (PRESET TIMER)
AUDIO VOICE COMPANDING BUILT IN
CHANNEL SCANNING WITH PRIORITY CHANNEL
AUTOMATIC DC BACKUP SWITCHING WITH ALERT
BUILT IN POWER SUPPLY UNIT FP-31 (OPTION)
VXR
-
9000
SERIES
VXR
-
9000
SERIES
VERSATILITY
HIGH PERFORMANCE
CONSERVATIVE DESIGN FOR HIGH RELIABILITY
The large-diameter cooling fan (8 cm) is thermostatically
controlled, ensuring a stable temperature environment for
the VXR-9000. Fan operation may be programmed via
software (Off, Continuous, or Temperature-Controlled),
and a "Malfunction" alarm is provided.
READY FOR RACK MOUNTING
For easy integration into existing repeater sites, the VXR9000 is shipped ready for mounting in a standard 19" rack.
32 CHANNEL CAPACITY
The VXR-9000 may be dealer-programmed with up to 32
channels over a wide frequency range, and may be
operated either in a "Repeater" or "Base Station" mode,
depending on your application.
SIX DUAL-FUNCTION PROGRAMMABLE KEYS ON
FRONT PANEL
Over twenty different functions are available for selection
and assignment to any of the six dual-function programmable
keys on the front panel of the VXR-9000. These functions
include Channel Up/Down, High/Low Power, Repeater/Base
mode, Encryption On/Off, Transmit/Receive, Panel Lights
On/Off, and many more!
EXCELLENT RECEIVER PERFORMANCE
The VXR-9000 is crafted to survive in the most difficult RF
environments. Outstanding selectivity, intermodulation
rejection, and spurious and image rejection performance
ensure reliable service during peak spectrum congestion times.
AUDIO COMPANDING PER CHANNEL
The VXR-9000’s versatile configuration capability permits
inclusion
of
narrow-band, compandered channels among
wide-band, non-compandered
channels.
DC BACKUP WITH ALERT
Should DC power fail at the repeater site, the VXR-9000
will automatically revert to a backup DC power source, if
available. Under emergency DC power, the repeater will
transmit an alert message, to alert the communications
supervisor that the DC power situation requires immediate
attention at the repeater site.
50 W RF POWER/AVAILABLE 100 W VERSION (Optional)
The VXR-9000 provides 50 Watts of clean, reliable power output
in its standard configuration. For applications requiring
extended range, the optional VPA-9000H Power Amplifier
increases the transmitter’s power to 100 Watts.
50 W/100 W* Rack-Mount FM Repeater
SECURITY
SELECTABLE ENCRYPTION OPTIONS
The VXR-9000 may be set up for either rolling code or
inversion-type encryption (optional module required). The
security required by your customer is available for easy
installation.
FIVE-STEP AUTOMATIC COMMAND SEQUENCE
During certain operating events (such as Startup, switch
from main DC to backup DC, etc.) the VXR-9000 may be
programmed to undertake an automatic sequence of
commands, so it can be configured for the particular event.
For example, if DC fails and the repeater switches to
emergency DC, the repeater can be set up to switch to
Low Power, send a CW ID advising of
the DC power
situation, and other auto-command sequences, as well.
D-SUB 25-PIN ACCESSORY CONNECTOR ON REAR PANEL
For convenient interfacing to external controllers or other
accessories,
the rear-panel DSUB 25-Pin Accessory Jack
provides access to
important repeater circuitry without the need
for a specialized connector.
PROGRAMMABLE MESSAGE BANKS
Enter date, subject, and notes such as programming or
service memos, for recall at any time in the future.
TWO-TONE DECODE STARTUP
The VXR-9000 may be booted up using two-tone commands.
Four popular two-tone formats are supported, and the
precise frequencies of each of the two tones may be
manually adjusted from 100 Hz to 5 kHz, in 0.1 Hz steps.
Reliable in operation, and flexible in setup options, the VXR-9000 is a high-tech 50 W/100 W*
FM Repeater designed for advanced commercial applications. Its slim-line design is
crafted for easy installation in a standard 19-inch rack mount, and all programming
parameters may be accomplished by the Dealer in minutes using a personal computer
and Vertex Standard’s Programming Software.
*100 W w/optional VPA-9000H
Photo is built in Power Supply Unit (Option)
Accessories & Options
Specifications
Measurements per EIA standards unless noted above. Specifications are subject to change without notice or obligation.
Various accessories listed may not be available in some countries.
General Specifications
Frequency Range
134~160 MHz (A) 400~430 MHz (A)
148~174 MHz (C) 450~490 MHz (D)
480~512 MHz (F)
Number of Channels 32 Channels
Channel Spacing 2.5 kHz/5 kHz/6.25 kHz
Operating Voltage 13.6 V DC ±10 %
Current Drain 12 A Maximum (50 W) / 30 A Maximum (100 W)
Duty Cycle Receive : 100 % , Transmit : 100 % (@25 W output)
Frequency Stability 1.5 ppm , 1.0 ppm (30 min after wake up)
Operating Temperature Range
–22° F to +140° F (–30° C to +60° C)
Dimensions (W x H x D) 19" x 3.5" x 13.5" (483 x 88 x 343 mm)
Weight (approx.) 21.4 lbs. (9.7 kg) (VXR-9000 Only)
Receiver Specifications
Antenna Impedance 50 Ohms
Antenna Connector BNC
Receiver Type Double-Conversion Superheterodyne
Sensitivity 0.25 µV (12 dB SINAD) 0.30 µV (12 dB SINAD)
0.35 µV (20 dB Noise Quieting) 0.45 µV (20 dB Noise Quieting)
Selectivity 84 dB (Wide), 77 dB (Narrow)
Intermodulation 82 dB (Wide), 80 dB (Narrow)
Image Rejection 90 dB
Squelch Threshold
0.4
µV (Adjustable)
Audio Output 4 W @ 4 Ohms
Audio Distortion < 3 %
Hum and Noise > 50 dB
Audio Frequency Response
De-emphasis : 6 dB/oct (From 300 Hz to 3 kHz)
Conducted Spurious < –90 dBm
VXR-9000 (VHF) VXR-9000 (UHF)
Transmitter Specifications
RF Output Power (50 W) 50/25/10 W (High/Mid/Low) / 100 W (Option)
Antenna Impedance 50 Ohms
Antenna Connector Type-N
Modulation Type 16K0F3E/11K0F3E
System Deviation ±5.0 kHz (Wide), ±2.5 kHz (Narrow)
Hum and Noise >50 dB (Wide), >45 dB (Narrow)
Microphone Sensitivity 5 mV
Audio Frequency Response
Pre-emphasis : 6 dB/oct (From 300 Hz to 3 kHz)
Spurious Emission 80 dB below carrier
Audio Distortion 2.5 % @1 kHz
Microphone Impedance 600 Ohms
FIF-9 4 Wire Line Interface Unit
FP-31
Power Supply Unit ( for 50 W version)
FVP-25 Encryption Unit
FVP-35
Rolling Code Encryption Unit
MD-11A8J Desktop Microphone
MD-12
A8J Desktop Microphone
MH-25
A8J Hand Microphone
Supplied Accessories
DC Power Cord,15-A Blade Fuse, Knob Cap
VERTEX STANDARD
US Headquarters
10900 Walker Street, Cypress, CA 90630, U.S.A.
YAESU EUROPE B.V.
P.O. Box 75525, 1118 ZN Schiphol, The Netherlands
YAESU UK LTD.
Unit 12, Sun Valley Business Park, Winnall Close
Winchester, Hampshire, SO23 0LB, U.K.
VERTEX STANDARD HK LTD.
Unit 5, 20/F., Seaview Centre, 139-141 Hoi Bun Road,
Kwun Tong, Kowloon, Hong Kong
http://www.yaesu.co.uk
Email: sales@yaesu.co.uk
Phone +1 714-827-7600
http://www.vxstd.com.hk
Normanby Business Park, Unit 14/45 Normanby Road
Notting Hill 3168, Victoria, Australia
Phone +31 20-5005270
Phone
+44 196 286 6667
Phone +852 2732 2288
Phone +61 3 95182100
VERTEX STANDARD CO., LTD.
For our latest product news, visit us on the Internet:
http://www.vxstd.com
4-8-8 Nakameguro, Meguro-ku, Tokyo 153-8644, Japan
2006.1003NA(EXP)
B9200455A Printed in Japan
http://www.vertexstandard.com
VERTEX STANDARD AUSTRALIA PTY. LTD.
Backup Power Source Terminals
Main Power Source Connector
Circuit Protection Fuse
RX Antenna Jack
TX Antenna Jack
External Speaker Jack
Power Supply FP-31 (Option)
D-SUB 25-pin Accessory Connector
Rear Panel
VPA-9000 V-H / U-H
(VHF) (UHF)
100 W Power Amplifier Unit
Programming Cable USB
FIF-10/A + CT-104/A
RS-232C CT-29 + CT-126
Programming Software
CE60
Loading...