Veris V123 Installation Instructions

REL AY S

4.0"

HAZARD OF ELECTRIC SHOCK, EXPLOSION, OR ARC FLASH

• Follow safe electrical work practices.

See NFPA 70E in the USA, or applicable local codes.

• This equipment must only be installed and serviced by qualied electrical personnel.

• Read, understand and follow the instructions before installing this product.

• Turn o all power supplying equipment before working on or inside the equipment.

• Use a properly rated voltage sensing device to conrm power is o.
DO NOT DEPEND ON THIS PRODUCT FOR VOLTAGE INDICATION

Failure to follow these instructions will result in death or serious injury.

DANGER

TM

INSTALLATION GUIDE

V123

V123

20A SPST Enclosed Relay With

Digital HOA Monitor

Installer’s Specifications

Operating Temperature -40° to 60°C (-40° to 131°F)
Operating Humidity 10-90% RH, non-condensing
Expected Relay Life Electrical (@ rated current) 100,000 cycle s;
Mechanical (unpowered) 10,000,000 cycles
Relay Status LED ON=energized

Wire Specications:

Lead Length 14”(356mm) min.
Gauge UL1015; Coil: 18AWG; Contacts: 12AWG; HOA monitoring wires: 16AWG
Insulation Class 277VAC RMS

Digital Monitor Maximums:

Dry Circuit Contact R ating (Max.) 24VAC/DC@100mA
Agency Approvals UL 508 enclose d device listing, pollution degree 2

INSTALLATION

Disconnect and lock out all power sources before beginning the
installation.

1. Using the threaded nipple, connect the relay to the desired enclosure through a
knock out hole.

2. Secure with the conduit nut provided.

3. Connect coil wires:

• Choose the coil common lead (white with yellow stripe) and connect it to
the common (-) source termination point.

NOTICE

• This product is not intended for life or safety applications.

• Do not install this product in hazardous or classified locations.

• The installer is responsible for conformance to all applicable codes.

• Mount this product inside a suitable fire and electrical enclosure.

DIMENSIONS

(103 mm)

3.8"

(97 mm)

Z203403-0B PAGE 1 ©2012 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [e-mail] 04123

Alta Labs, Enercep t, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘ V’ logo are trademark s or registered tradema rks of Veris Industries, L.L .C. in the USA and /or other count ries.

3/4" NPT Nipple

2.3"

(59 mm)

2.0"

(52 mm)

2.5"

(64 mm)

• Choose either the low voltage (10-30VAC/DC, white with blue stripe) or
high voltage (120VAC, white with black stripe) lead, depending on the
application requirements, and connect it to the (+) source termination
point.*

Note: When connecting the control side of this device (#18 wires) to power
line circuits, provide currenting limiting at 7 amps max.

4. Connect relay contacts:

• Choose the relay common wire (yellow) and connect to the switched load.

• Choose the relay N.O. (orange) and/or* N.C. (blue) lead and connect to the

switched load.

5. Connect digital HOA monitor wires:

• Choose the solid brown and solid grey wires and connect them to two
dierent digital inputs, referencing the violet wire as common.

6. Secure the enclosure and reconnect power.

* Isolate or insulate all non-terminated wires according to local electrical code requirements, i.e.
wire nut.

V123

24VAC/DC

120VAC

LOW

wht/blue

COMM

wht/yellow

HI

wht/black

CONTACT OUTPUTCONTROL SYSTEM INPUT

Common

To Load

To Controls

COIL

CONTACTS

To Load

To Controls

Wire
Nut

C

O

I

L

CONTACTS

HAND

OFF

AUTO

Up position: contacts are closed.

Middle position: contacts are open.

Down position: control system actuates the contacts.

Coil Voltage 24VAC/DC, 120VAC

Voltage Coil Current
AC DC

24V.................... 75mA.................... 32mA

120V.................... 22mA –

TYPICAL COIL PERFORMANCE

CONTACT RATINGS

Resistive..... 20A(r)@240VAC

8A@28VDC
14A@14VDC

Motor......... 250VAC, 1HP N.O. & N.C.

TM

INSTALLATION GUIDE

WIRING COLOR CODES

Digital HOA Position Monitor

WIRING EXAMPLE

Nipple mount directly to a panel

Nipple mount to a 2x or 4x electrical box

CONTACT AND COIL SPECIFICATIONS

Z203403-0B PAGE 2 ©2012 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [e-mail] 04123

Alta Labs, Enercep t, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘ V’ logo are trademark s or registered tradema rks of Veris Industries, L.L .C. in the USA and /or other count ries.

HOA POSITIONS