Venstar ACC-FP1xx, ACC-FP1 Series Installation Instructions Manual

ColorTouch Faceplate

Installation Instructions

MODEL ACC-FP1xx

1. Remove the thermostat backplate.

Using the Finger Pull Areas, pull the
front housing away from the backplate.

Look for these tabs to locate the pull areas

3. Using fingers or a screwdriver, pry

the top set of faceplate catches loose
and PUSH the faceplate forward slightly.

2. Note the location of the 4 catches that

hold the faceplate in place.

Top Faceplate Catches

Bottom Faceplate Catches

4. After the top set of catches are loose, pry

the bottom set of catches loose and PUSH
the faceplate forward to detatch it from the
front housing.

5. PUSH the new faceplate onto the front of the thermostat housing until all 4 catches

are firmly in place. PUSH the thermostat housing back onto the thermostat backplate.

©Venstar Inc. 11/2010

P/N 88-872 Rev. 1