Venmar SV09956OR, SV09955RD, SV09953WH, SV09955OR, SV09957OR INSTALLATION INSTRUCTIONS
09530 Rev. A
GLASS PANEL
INSTALLATION INSTRUCTIONS
APPLIES TO THE FOLLOWING RANGE HOOD SERIES
C700, CC700, CIC700 AND CIS700
Venmar Ventilation Inc., 550 Lemire Blvd.
Drummondville QC J2C 7W9
1-800-567-3855
www.venmar.ca
- 2 -
•IT IS RECOMMENDED TO WEAR SAFETY GLASSES AND GLOVES WHILE PERFORMING THESE INSTRUCTIONS.
•HANDLE GLASS PANEL WITH CARE.
•ALL TEMPERED GLASS CAN EXPERIENCE SPONTANEOUS BREAKAGE. IFBROKEN, TEMPERED GLASS FALLS
OUTOFIT’S OPENING IN INTERLOCKING CLUMPS. TEMPERED GLASS CAN, ON OCCASION, BREAK INTO LARGE
SHARDS RATHER THAN THE CLASSIC TINY PIECE PATTERN.
•RISK OF ELECTRICAL SHOCK. BEFORE REPLACING THE GLASS PANEL, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK SERVICE DISCONNECTING MEANS TO PREVENT POWER FROM BEING SWITCHED ON
ACCIDENTALLY.
WARNING
!
C700 SERIES
IF THE RANGE HOOD IS NOT INSTALLED YET, REFER TO STEP 4 OF THE HOOD INSTALLATION GUIDE.
IF THE RANGE HOOS IS ALREADY INSTALLED FOLLOW THESE STEPS:
To remove filters: Lift filters by pushing
them towards the back and rotate. Set the
filters aside.
Remove the bottom panel 10 retaining
screws and set aside.
NOTE: Both light assemblies will have to
be disconnected in order to
remove the bottom panel (see
step 3).
Slightly pull the bottom panel out.
Press on tabs and pull to disconnect both
light assemblies electrical harenesses
from light connectors.
Slide bottom panel out and set aside.
Remove new glass panel nuts from both studs and set aside.
1
SCREW
LOCATIONS
HO0176
2
3
4
AFTER A POWER FAILURE OR DURING THE RANGE HOOD POWER UP, A 5-SECOND BOOTING SEQUENCE IS
EXECUTED. WAIT FOR THE CONTROL BACKLIGHTING TO TURN OFF BEFORE USE.
CAUTION
HO0181
HO0174
Loading...