Venmar FAE125, VFAE125, FAE 125M, VFAE125M Installation And User Manual

09219 rev. 02

INSTALLATION AND USER MANUAL

VB0134

FURNACE AIR EXCHANGER WITH HEAT RECOVERY

MODELS

ADDRESS OF YOUR INSTALLER

FAE125

VFAE125

FAE 125M

VFAE125M

INSTALLER: LEAVE THIS MANUAL WITH HOMEOWNER

CUSTOMER SERVICE PHONE NUMBER: 1-800-567-3855

2

This manual uses the following symbols to emphasize particular information:

NOTE: Indicates supplementary information needed to fully complete an instruction.

ABOUT THIS MANUAL

WARRANTY

Venmar Ventilation inc. or vänEE Canada warrants to the original purchaser of its products
that such products will be guaranteed against all manufacturing defects and defective
material for a period of two (2) years from the date of original purchase. The heat recovery
core is protected by a limited lifetime warranty.

THERE ARE NO OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT
NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR
A PARTICULAR PURPOSE.VENMAR VENTILATION INC. OR vänEE CANADA WILL NOT
BE HELD RESPONSIBLE FOR ANY CLAIMS OVER THE ORIGINAL PURCHASE PRICE
OF A FURNACE AIR EXCHANGER WITH HEAT RECOVERY, NOR HELD RESPONSIBLE
FOR SUBSEQUENT DAMAGE OR INCIDENT.

During the period stated above, Venmar Ventilation Inc. or vänEE Canada will, at its option,
repair or replace, without charge, any product or part which is found to be defective under
normal use and service. This warranty does not cover a) normal maintenance and service,
b) any products or parts which have been subject to misuse, negligence, accident, improper
maintenance or repairs made by other than Venmar Ventilation inc. or vänEE Canada, or
c) a faulty installation or installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the 2-year period as specified for the
express warranty. Some jurisdictions do not allow limitation on how long an implied warranty
lasts, so the above limitation may not apply to you.

VENMAR VENTILATION INC. OR vänEE CANADA'S OBLIGATION TO REPAIR OR
REPLACE AT VENMAR OR vänEE'S OPTION, SHALL BE THE PURCHASER'S SOLE
AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. VENMAR OR vänEE SHALL NOT
BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING
OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. SOME
JURISDICTIONS DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL
OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY
NOT APPLY TO YOU.

This warranty gives you specific legal rights and you may also have other rights, which vary
from province to another. This warranty supersedes all prior warranties. To contact Venmar
Ventilation inc. or vänEE Canada warranty service, call 1-800-567-3855.

In order to qualify for a warranty claim, the owner of a Furnace Air Exchanger with heat
recovery must have the model and serial number along with a proof of the original purchase
date. At the time of requesting service, describe the nature of any defect in the product or
part.

WARNING

Identifies an instruction which, if not followed, might cause serious personal
injuries including possibility of death.

!

CAUTION

Denotes an instruction which, if not followed, may severely damage the unit
and/or its components.

3

ABOUT THESE UNITS

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSON(S), OBSERVE THE FOLLOWING:

1. This unit is intented for residential installation only.

2. Installation work and electrical wiring must be done by a qualified
person(s) in accordance with all applicable codes and standards,
including fire-rated construction codes and standards.

3. This unit is not designed to provide combustion and/or dilution air for
fuel-burning appliances.

4. Do not install in a cooking area or connect directly to an appliance.

5. Before servicing or cleaning the unit, disconnect power from HVAC
system.

6. When cutting or drilling into wall or ceiling, do not damage electrical
wiring or other hidden utilities.

7. Do not use FAE125M and VFAE125M units with any solid-state speed
control device. Use only with Dehumidistat wall control provided with
the unit.

8. This unit must be installed in a weatherized location, out of direct
sunlight and protected from the elements.

9. Use this unit only in the manner intended by the manufacturer. If you
have questions, contact the manufacturer at the telephone number
listed in the warranty.

10. When performing installation, servicing or cleaning the unit, it is
recommended to wear safety glasses and gloves.

11. Servicing shall be done by qualified service personnel.

12. When applicable local regulations comprise more restrictive installation
and/or certification requirements, the aforementioned requirements
prevail on those of this document and the installer agrees to conform to
these at his own expenses.

!

CAUTION

1. For general ventilation use only. Do not use to exhaust hazardous or
explosive materials and vapors.

2. Intended for residential installation only in accordance with the
requirements of NFPA 90B and in compliance with all local and national
codes that are applicable.

3. Be sure to duct air outside. Do not intake/exhaust air into spaces within
walls or ceiling or into attics, crawl spaces, or garage.

4. To avoid premature clogged filter, turn OFF the unit during construction
or renovation.

5. Please read the unit specification label on the product for further
information and requirements.

6. At least once a year, the unit mechanical and electronic parts (if need
be) should be inspected by qualified service personnel.

7. The FAE125M or VFAE125M must be connected to a 24-volt class 2
circuit only.

4

1. S

ERVICE PARTS ................................................................................... 5

2. TECHNICAL DATA ................................................................................ 6-7

2.1 AIR DISTRIBUTION ....................................................................................... .6

2.2 H

EAT RECOVERY .........................................................................................6

2.3 DURING COLD WEATHER...............................................................................6

2.4 DIMENSIONS ...............................................................................................7

2.5 SPECIFICATIONS ........................................................................................... 7

2.6 PERFORMANCE CHART .................................................................................7

3. TYPICAL INSTALLATIONS .......................................................................... 8

4. INSTALLATION ................................................................................... 8-10

4.1 LOCATING AND MOUNTING THE UNIT................................................................ 8

4.2 CONNECTING DUCTS TO THE UNIT .................................................................. 9

4.3 INSTALLING EXTERIOR HOODS ........................................................................ 9

4.4 CONNECTING THE DRAIN ............................................................................. 10

5. AIR FLOW BALANCING ..................................................................... 10-12

6. WALL CONTROL (FAE125M AND VFAE125M ONLY) .............................. 12

6.1 INSTRUCTIONS REGARDING WALL CONTROL .................................................. .12

6.2 WALL CONTROL CONNECTION TO THE UNIT ................................................... 12

7. M AINTENANCE ..................................................................................... 13

8. TROUBLESHOOTING .............................................................................. 14

TABLE OF CONTENTS

5

1. S ERVICE PARTS

1

3

4

5

6

8

7

9

10

11

12

13

2

REPLACEMENT PARTS AND REPAIRS

In order to ensure your ventilation unit remains in good working condition, you must use the manufacturer
genuine replacement parts only. The manufacturer replacement parts are specially designed for each
unit and are manufactured to comply with all the applicable certification standards and maintain a high
standard of safety. Any third party replacement part used may cause serious damage and drastically
reduce the performance level of your unit, which will result in premature failing. The manufacturer
recommends to contact a certified service depot for all replacement parts and repairs.

NO.PART NO.DESCRIPTION

FAE125 OR

VFAE125

FAE125M OR

VFAE125M

1 02253 B

ALANCING DAMPER 22

2 02256 PORT FOR BALANCING DAMPER 22
3 18620 HEAT RECOVERY CORE 11
4 09214 FILTER 11
5 18619 DOOR ASSEMBLY (WITH SCREWS)1 1

6 18618

MOTORIZED DAMPER ASSEMBLY
(WITH DAMPER SPRING)

—1

7 18682 DRAIN CONNECTOR WITH FOAM 11
8 18683 DOOR SCREWS (4 PER KIT)1 1

9 02021 PORT 22
10 09221 DAMPER SPRING 11
11 09220 H

ARDWARE KIT 11

12 18617 DAMPER MOTOR ASSEMBLY —1
13 10177 DAMPER MOTOR COVER —1

VL0037