STROBOSCOPE 20 W
STROBOSCOOP 20 W
STROBOSCOPE 20 W
ESTROBOSCOPIO 20 W
STROBOSKOP 20 W
USER MANUAL 2
GEBRUIKERSHANDLEIDING 4
NOTICE D’EMPLOI 6
MANUAL DEL USUARIO 8
BEDIENUNGSANLEITUNG 10
VDL20ST Rev. 03
USER MANUAL
1. Introduction
To all residents of the European Union
Important environmental information about this product
If in doubt, contact your local waste disposal authorities.
Thank you for choosing HQPower! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect
• This device falls under protection class II. It is therefore essential that the device be earthed. Have a
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the
• There may be some smoke or a particular smell when the device is activated for the first time. This is
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Do not operate the stroboscope without or with a cracked glass pane. Have it replaced when it is
3. General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
• This stroboscope should only be used indoors with an alternating current of max. 230 VAC ~ 50 Hz.
• Do not shake the device. Avoid brute force when installing or operating the device.
• Select a location where the device is protected against extreme heat, dust and moisture. Respect a
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be
returned to your distributor or to a local recycling service. Respect the local environmental
rules.
Indoor use only.
Keep the stroboscope away from rain, moisture, splashing and dripping liquids.
Protect the device against extreme heat and dust.
on top of the device.
Never put objects filled with liquid
Risk of electroshock during installation.
Touching live wires can cause life-threatening electroshocks. Wait 5 minutes after
disconnecting the stroboscope from the mains before handling the device. Make sure not
to make contact with the mains plug contacts after disconnection.
DO NOT disassemble or open the cover(s).
Keep out of reach of children and unauthorized users or users with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instructions concerning use of the
appliance by a person responsible for their safety. Children should be supervised
to ensure that they do not play with the device.
the dealer will not accept responsibility for any ensuing defects or problems.
the device against damage by leaving it switched off until it has reached room temperature.
qualified person carry out the electric connection.
manual.
necessary.
plug only.
normal and any smoke or smell will gradually disappear.
damaged.
minimum distance of 0.5 m between the device’s light output and any illuminated surface.
• Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
4. Installation
• The installation construction should be able to support a minimum point load of 10 times the weight of
the device.
• The installation must always be secured with a secondary attachment e.g. a safety cable (VDLSC7 or
VDLSC8).
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used… Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may result
in injuries.
• The installation has to be approved by an expert before the device is taken into service.
• The glass pane has to be replaced when it is damaged.
5. Use
1. Connect the stroboscope to the mains.
2. Set the flash frequency (0 to 10 flashes per second) by means of the knob at the rear.
3. Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
6. Maintenance
1. All screws should be tightened and free of corrosion.
2. The housing, the glass pane, the mounting supports and the installation location (e.g. ceiling,
suspension, trussing) should not be deformed, modified or tampered with.
3. The electric power supply cables must not show any damage. Have a qualified technician maintain the
device.
4. Disconnect the device from the mains prior to maintenance activities.
5. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
6. There are no user-serviceable parts. Only authorized dealers may maintain and service this device.
7. Technical Specifications
power supply max. 230 VAC ~ 50 Hz
power consumption 20 W
dimensions 85 x 125 x 53 mm
total weight 240 g
lamp LAMP20ST (20 W)
Use this device with original accessories only. Velleman nv cannot be held responsible in the
event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.hqpower.eu. The information in this
manual is subject to change without prior notice.
All worldwide rights reserved. No part of this manual may be copied, reproduced, translated or reduced
to any electronic medium or otherwise without the prior written consent of the copyright holder.
Aan alle ingezetenen van de Europese Unie
Belangrijke milieu-informatie betreffende dit product
Hebt u vragen, contacteer dan de plaatselijke autoriteiten betreffende de verwijdering.
Dank u voor uw aankoop! Lees deze handleiding grondig voor u het toestel in gebruik neemt. Werd het
toestel beschadigd tijdens het transport, installeer het dan niet en raadpleeg uw dealer.
2. Veiligheidsinstructies
• De garantie geldt niet voor schade door het negeren van bepaalde richtlijnen in deze handleiding en
• Laat een geschoolde technicus dit toestel installeren en onderhouden.
• Om beschadiging te vermijden, mag u het toestel niet inschakelen onmiddellijk nadat het werd
• Dit toestel valt onder beschermingsklasse II, wat wil zeggen dat het toestel geaard moet zijn. Een
• De beschikbare netspanning mag niet hoger zijn dan de spanning in de specificaties achteraan de
• De voedingskabel mag niet omgeplooid of beschadigd zijn. Laat uw dealer zo nodig een nieuwe kabel
• Trek de stekker uit het stopcontact (trek nooit aan de kabel!) voordat u het toestel reinigt en als u het niet
• Wanneer u het toestel voor het eerst gebruikt, kan dit gepaard gaan met een lichte rookontwikkeling
• Kijk niet rechtstreeks in de lichtbron. De lichtbron kan bij gevoelige mensen leiden tot een aanval van
• Schade door wijzigingen die de gebruiker heeft aangebracht aan het toestel vallen niet onder de
• Gebruik de stroboscoop niet zonder of met een beschadigd glasplaatje. Laat het vervangen als het
3. Algemene richtlijnen
Raadpleeg de Velleman® service- en kwaliteitsgarantie achteraan deze handleiding.
Dit symbool op het toestel of de verpakking geeft aan dat, als het na zijn levenscyclus wordt
weggeworpen, dit toestel schade kan toebrengen aan het milieu. Gooi dit toestel (en eventuele
batterijen) niet bij het gewone huishoudelijke afval; het moet bij een gespecialiseerd bedrijf
terechtkomen voor recyclage. U moet dit toestel naar uw verdeler of naar een lokaal
recyclagepunt brengen. Respecteer de plaatselijke milieuwetgeving.
Enkel voor gebruik binnenshuis.
Bescherm de stroboscoop tegen regen, vochtigheid en opspattende vloeistoffen.
Bescherm de stroboscoop tegen extreme hitte en stof.
met vloeistof op het toestel.
Elektrocutiegevaar.
Raak geen kabels aan die onder stroom staan om dodelijke elektroshocks te vermijden.
Wacht 5 minuten nadat u de stekker uit het stopcontact hebt getrokken alvorens de
stroboscoop aan te raken. Raak na uittrekken van de stekker uit het stopcontact de
contacten op de stekker niet aan.
U mag de behuizing niet openen.
Dit apparaat is niet geschikt voor gebruik door personen (inclusief kinderen)
met een verminderd fysiek, sensorisch of geestelijk vermogen, of gebrek aan
ervaring en kennis, tenzij supervisie of instructie is gegeven betreffende het
gebruik van het apparaat door een persoon welke verantwoordelijk is voor hun
veiligheid. Zorg dat kinderen niet met dit apparaat kunnen spelen.
uw dealer zal de verantwoordelijkheid afwijzen voor defecten of problemen die hier rechtstreeks
verband mee houden.
blootgesteld aan temperatuurschommelingen. Wacht tot het toestel op kamertemperatuur gekomen is.
geschoolde technicus moet de elektrische aansluiting verzorgen.
handleiding.
plaatsen.
gebruikt.
en een bepaalde geur. Dit is normaal en de eventuele rook of geur zal geleidelijk aan verdwijnen.
epilepsie.
garantie.
beschadigd is.
4
Plaats geen objecten gevuld
Loading...
+ 9 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.