Velleman MONCOLHA Operation Manual

Page 1
MONCOLHA GB1
4" TFT LC MONITOR MONCOLHA
OPERATION MANUAL I. Detailed Description
II. Specifications III. Descriptions of the Functions of the Front Rear-Panel IV. Set Function Descriptions of Pressing Keys V. Drawing of Wiring Applications : Basic Wiring
I. Detailed Description This model completely uses digitised push buttons to adjust the colour,
contrast, tint, voices, brightness of 4" LCD monitor module and even setting values, which will not be changed because of power failure. However, if an original setting value is required, it can be recovered by pressing the "power" & "mode" keys at the same time. Then release them both, pressing the "mode" key for one second longer.
II. Specifications LCD panel colour
Display resolution (dot) 480(W) x 234(W) Number of pixels 112320 dots Active (mm) 82.0(W) x 61.8(H) Screen size (inch) 4" (diagonal) Dot pitch 0.171(W) x 0.264(H) System PAL / NTSC Input signal
1Vp-p (Positive) 75 Back light CCFT back light Power source
DC 12V ± 10% Operation temperature
-5°C +50°C
Storage temperature
-25°C +70°C Power consumption 8W max. Dimensions 143(W) x 103(H) x 45(D)mm Weight 500g
Page 2
MONCOLHA GB2
III. Descriptions of the functions of the front & rear panels
2-1 The front panel
2-2 The back panel
IV. Fixed function descriptions of pushing buttons (1) Make sure that power supply of DC 12V, video input, and audio input are
properly connected.
(2) When power supply of DC 12V is properly connected, press "Power"
button to check if power LED is lit or not.
(3) Press "Power" and "Mode" buttons at the same time. Then release
"Power" button first, and release "Mode" button one second later. (This action makes the monitor return to the original setting values.) At this moment, all LEDs flash simultaneously, then original setting values are displayed on the monitor.
(4) The adjustment and setting of function keys.
1. Adjustment of "Contrast" function 1-1 When the "Power" LED is on, press the "Mode" button to
choose the "Contrast" LED.
1-2 Press "up" or "down" button to adjust a proper value. After 5
seconds of this action, the light indicator returns to "Power" automatically. (When adjusting the "Contrast", the light indicator flashes ; however, when the contrast value achieves Maximum or Minimum, the light indicator keeps shining.)
Page 3
MONCOLHA GB3
VIDEO IN
DC IN (+12V) ADAPTOR
VIDEO IN
AUDIO IN
ADAPTOR
VIDEO IN
DC IN (+12V)
ADAPTOR
2. Adjustment of "Bright" function 2-1 When the "Power" LED is on, press the "Mode" button to
choose the "Bright" LED
2-2 Operation of "2-2" and "1-2" are the same.
3. Adjustment of "Color" function 3-1 When the "Power" LED is on, press the "Mode" button to
choose the "Color" LED
3-2 Operations of "3-2" and "1-2" are the same.
4. Adjustment of "Tint" function 4-1 When the "Power" LED is on, press the "Mode" button to
choose the "Tint" LED
4-2 Operations of "4-2" and "1-2" are the same.
5. Adjustment of "Volume" function 5-1 When the "Power" LED is on, press the "Mode" button to
choose the "Volume" LED
5-2 Operations of "5-2" and "1-2" are the same.
IV. Drawing of wiring application Basic Wiring
Loading...