Vector VEC255 User Manual

VEC255

CORDED, CORDLESS,

RECHARGEABLE COMPRESSOR

AND INFLATOR COMBO

OWNER’S MANUAL

& WARRANTY INFORMATION

THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING
SAFETY, OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT.
BEFORE USE, READ AND UNDERSTAND ALL CAUTIONS, WARNINGS,
INSTRUCTIONS AND PRODUCT LABELS. FAILURE TO DO SO COULD
RESULT IN INJURY AND/OR PROPERTY DAMAGE.

TEL [phone] • TOLL FREE: 866-584-5504 • FAX [phone]

4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312

www.vectormfg.com

1

IMPORTANT SAFETY INFORMATION

Be sure to read and understand all WARNINGS and CAUTIONS before using
this product. Please read this guide carefully before use to ensure optimum
performance and avoid damage to the system or items that you are using it
with. Failure to follow instructions may cause property damage, and/or
personal injury. Warnings define conditions that can cause injury to people.
Cautions define conditions that may cause damage to equipment.

WARNINGS:

1. Improperly attached hoses or nozzles can fly out under compressor pres­sure. Make sure all connections are tight before turning compressor ON.

2. There is risk of dust or dirt projectiles being released if the compressor
hose or nozzles are not clean when the compressor is turned on.

3. Wearing protective goggles while operating these appliances can
protect eyes from flying particles of dust and dirt.

4. Keep out of reach of children. These appliances are not toys!

5. Replace worn or defective parts immediately - contact Vector® Customer
Service Department at [phone] or toll free at 866-584-5504.

6. During AC recharge, make sure that the AC Charging Adapter is kept
away from water or moisture during use. If recharging around water,
make sure the 110 VAC outlet is GFCI protected.

7. Make sure all cords and adapter wires are placed so they are not tripped
over or damaged by pinching, abrading or cutting. Do not place wires
near moving objects, doors or sharp objects.

8. Never exceed recommended pressures - bursting articles can cause
serious injury. Always check pressure with the pressure gauge.

9. Do not carry charger and adapters by their cords, carry items by the
body of unit itself.

10. There are no user serviceable parts except for a replaceable battery
pack, AC Recharge Adapter and Hose.

11. Do not operate unit if there is any evidence of damage.

12. Never use air compressor or inflator near flammable liquids, gas or
open flames.

13. Keep working area well lit.

14. Do not direct air into eyes, ears, nose or other parts of the body.

CAUTIONS:

1. When the compressor or inflator is powered from external DC, make sure

the voltage is rated at 12 VDC. Do not operate with 6 volts or 24 volts.

2. Make sure that the appliances are not operated continuously for more

than 10 minutes. Allow them to cool for at least five minutes before
turning it back on.

3. Make sure battery pack is fully charged before operating. Recharge

every 60 days for the recommended time to extend life of battery pack’s

2

2

internal battery. For immediate use, attach the DC adapter and operate
the appliances from an external 12 volt DC source.

4.

To avoid over-inflation, carefully follow instructions on articles to be inflated.

5. Never leave appliances unattended while in use. Allow appliance to cool

for five minutes after 10 minutes of continuous operation.

6. Do not use accessories that are not designed to be used with these

appliances.

7. Do not place battery pack on heater and keep it out of sunlight.

8. Do not charge battery when it is at or above 122° F (50° C). Allow the

battery pack to cool before charging.

CONTENTS

1. INTRODUCTION .................................................... 4

2. ADDITIONAL KEY FEATURES .................................. 5

3. ATTACHING THE COMPRESSOR’S AIR HOSE .......... 6

4. POWERING THE COMPRESSOR OR INFLATOR ....... 6

4.1 Powering from the battery pack ........................

4.2 DC Power Adapter Use .................................. 6

5. CHARGING/RECHARGING THE BATTERY PACK...... 7

5.1 AC Recharge of battery pack .......................... 7

6. COMPRESSOR/TIRE INFLATOR............................... 8

6.1 Tire inflation or products with a valve stem ....... 8

6.2 Inflate other articles (without valve stem) .......... 9

7. TYPICAL INFLATION TIMES ..................................... 9

8. LOW PRESSURE INFLATOR................................... 10

8.1 Inflator ........................................................ 11

8.2 Deflator ...................................................... 11

9. MAINTENANCE/REPLACEMENT PARTS ................ 11

10. BATTERY REPLACEMENT....................................... 11

11. BATTERY DISPOSAL .............................................. 12

12. SPECIFICATIONS ................................................. 12

WARRANTIES ................................................. 13,14

3

1. INTRODUCTION

Congratulations on selecting the Vector Air Pro™ Model VEC255
Compressor & Inflator Combo. This system is an advanced high-pressure
(up to 260 PSI) multi-use air compressor system with unique features that set
it far above the value and utility of ordinary compressors for mobile use. It is
supplied with a standard tire valve chuck for filling auto, truck, bike, and
motorcycle tires. Additionally, two different adapters are supplied to inflate
soccer balls, footballs, and popular inflatables. These adapters are conve­niently stored in a hatch in the compressor body. It is powered from its own
snap-on/off powerful battery to be used anywhere it is needed. It can also
operate from a standard 12 volt DC electrical system found on: trucks, cars,
boats, airplanes, RVs and tractors, using the supplied DC Power Adapter. A
supplied standard 110 VAC charger recharges the battery when required.
Typically, up to three completely flat tires can be inflated before the snap-on
battery has to be recharged.

A separate Inflator shares the battery pack and DC Power Adapter. The inflator
is used to inflate: air mattresses; beach balls, etc.(See Sections 8 thru 10)

A customer can purchase extra snap-on battery packs if completely cordless
operation is required (Part VEC194). Operating these appliances with the
snap-on DC Power Adapters is ideal for use with Vector 12 volt DC cordless,
portable, rechargeable DC Power supplies if extended operating time in the
field is required.

FIGURE 1

RIBBED BRASS
FITTING

COMPRESSOR
OUTLET

HOSE RETAINING
RING

NOZZLE HATCH
COVER

4

4

COMPRESSOR
HOSE

TRIGGER LOCK

TRIGGER
SWITCH

TIRE CHUCK

The Compressor On/Off Switch controls operation of the compressor. It
conveniently is depressed and released to control inflation. An exact pres­sure is obtained by observing the gauge and releasing the trigger when the
correct pressure is achieved. For longer inflation operations, the Trigger
Lock can be moved laterally to lock the trigger in the ON position. Pushing
the trigger lock to the opposite direction releases the trigger (OFF) and
inflation stops.

2. ADDITIONAL KEY FEATURES

•Trigger Switch with lock to allow hands free operation

• Corded -includes a DC power adapter for use with standard 12 volt power
supply

• Battery Pack includes non-spillable, maintenance-free, heavy duty, sealed,
high-density lead-acid battery

• Requires no maintenance (other than recharging and cleaning) for
optimum operation

• Supplied 110 volt AC charger is Underwriter Laboratories (UL) safety
tested and listed

• Battery Charging LED on battery automatically activated during
AC recharge

• Analog Pressure Gauge to 260 PSI Compressor

• Nozzle Hatch for storing nozzles in compressor

• 3 nozzles for inflator

FIGURE 2

NOZZLE HATCH
COVER

NOZZLES

PRESSURE
GAUGE

CAUTION: This battery pack is delivered in a partially charged state - you

must fully charge it before using it for the first time. Initial AC Charge
should be for 10 hours. Refer to Section 6 for use of AC Adapter and
detailed charging instructions.

5