Vector VEC248 User Manual

OWNER’S MANUAL & WARRANTY INFORMATION

THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY,
OPERATION, MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USING,
READ AND UNDERSTAND ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND
PRODUCT LABELS, PLUS YOUR VEHICLE'S BATTERY MANUFACTURER GUIDELINES.
FAILURE TO DO SO COULD RESULT IN INJURY AND/OR PROPERTY DAMAGE.

4140 SW 28th Way, FT. LAUDERDALE, FL 33312

Tel [phone] • TOLL FREE: 866-584-5504 • Fax [phone]

www.vectormfg.com

VEC248

WET/DRY CANISTER

VA CUUM CLEANER

CORDED • CORDLESS • RECHARGEABLE

1 GALLON CAPACITY, WASHABLE FILTERS

UPHOLSTERY BRUSH AND CREVICE TOOLS

IMPORT

ANT SAFETY INSTRUCTIONS

1. Do not use Canister Vac to pick up burning objects.

2. Do not use in an area where dangerous items are stored.

3. Do not apply lubricants to the motor.

4. When you remove the battery, please make sure it's not placed near high heat or near
a risk of short circuit.

5. Do not use to pick up flammable fluids.

6. Do not use canister vac as a water pump! Although it's designed to pick up
minor water spills, it's NOT DESIGNED to replace or act as a sump pump or any other
pump designed to remove standing water.

7. This is not a toy, please keep away from children!

8. Do not allow Canister Vac to freeze or be submerged in water.

NOTES:

• The Canister Vac has a runtime of 15 minutes on a completely charged battery.

• Do NOT run battery completely down; recharge after every use.

• Fully recharge your Canister Vac at least once a month for optimum battery life.

• For locations that have 12 volts DC available, remove the battery and use the DC

adapter to power the Canister Vac.

FIGURES 1 AND 2 - Front and Rear views of the Canister Vac

2

BATTERY
STATUS LEDS

ON/OFF
ROCKER
SWITCH

HOSE
CONNECTION

LIFT LATCH TO DETACH
DIRT CONTAINER
FOR CLEANING

ONE GALLON
CANISTER DIRT
CONTAINER

BATTERY PACK
12 VOLT 3 AH
CAPACITY

BATTERY
RELEASE TAB

WARNING!

TO AVOID ELECTRICAL SHOCK

DO NOT EXPOSE TO RAIN. STORE INDOORS. READ THE USER MANUAL AND SAFETY INSTRUCTIONS
BEFORE OPERATING THIS UNIT. TO AVOID INJURY OR PROPERTY DAMAGE: DO NOT PICK UP FLAMMABLE,
COMBUSTIBLE, OR HOT MATERIALS. DO NOT USE AROUND EXPLOSIVE LIQUIDS OR VAPORS, AS
ELECTRICAL DEVICES PRODUCE ARCS OR SPARKS WHICH CAN CAUSE A FIRE OR EXPLOSION. DO NOT
USE AT FILLING STATIONS OR ANYWHERE GASOLINE IS STORED OR DISPENSED. TO AVOID HEALTH
HAZARDS FROM VAPORS OR DUST: DO NOT VACUUM TOXIC, CARCINOGENIC, OR OTHER HAZARDOUS
MATERIALS SUCH AS ASBESTOS, LEAD, PESTICIDES OR HEALTH ENDANGERING MATERIAL.

FIGURE 3 - Accessories

Optional wall mounting instructions for battery pack charging unit. FOR INDOOR USE ONLY:

1. Always make sure the area you choose to mount the Battery Pack Charging unit is free
from hidden electrical wires, water pipes and/or gas lines.

2. Select a place close to an indoor 120V ~ 60Hz wall outlet.

3. Do not locate in direct sunlight or close to any heat source.

4. Select a drill for the material and size of mounting screws.
Be careful that no wires, water or gas pipes are behind the wall where the Battery
Charging unit is to be installed.

5. Mark the wall where you want to mount the Battery Pack Charging unit.

6. After carefully drilling starter holes, install the screws so that the Battery Pack Charger
unit can hook onto the screw heads.

NOTE: This Battery Pack Charging unit is designed for INDOOR MOUNTING ONLY!

POWERING THE BATTERY PACK RECHARGE UNIT

Connect the AC/DC Adapter into a working 120 VAC outlet.
Plug the barrel connector into the receptacle on the Battery Pack Recharge unit. The unit may

be either continuously powered or disconnected after use.
If desired, the tools may be placed in the tool wells for storage.

3

CREVICE TOOL

UPHOLSTERY BRUSH

3 FT LONG
VACUUM HOSE

AC/DC ADAPTER

BARREL
CONNECTOR

BATTERY PACK

BATTERY PACK
RECHARGE AND
TOOL STORAGE UNIT