Vector VEC021STC User Manual

JUMP-STARTER, AIR COMPRESSOR

AND 12 VOLT DC POWER SUPPLY

Portable • Cordless • Rechargeable

VEC021STC

®

OWNER’S MANUAL

& WARRANTY INFORMATION

THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING SAFETY, OPERATION,
MAINTENANCE AND STORAGE OF THIS PRODUCT. BEFORE USING, READ AND UNDERSTAND
ALL CAUTIONS, WARNINGS, INSTRUCTIONS AND PRODUCT LABELS, PLUS YOUR VEHICLE’S
BATTERY MANUFACTURER GUIDELINES. FAILURE TO DO SO COULD RESULT IN INJURY AND/
OR PROPERTY DAMAGE.

TEL: [phone] • TOLL FREE: 866-584-5504 • FAX: [phone]

4140 SW 28TH WAY, FT. LAUDERDALE, FL 33312

www.vectormfg.com

1

NOTE: This unit is shipped in a partially charged state, charge for 24 hours using

AC method.

SAFETY INFORMATION

WARNING:

(Warning statements identify conditions or practices that may result in personal
injury or loss of life)

1) When working with lead acid batteries, always make sure immediate assistance
is available in case of accident or emergency.

2) Always use protective eyewear when using this product: contact with battery acid
may cause blindness and/or severe burns, be aware of first aid procedures in
case of accidental contact with battery acid.

3) There is a risk of explosive gases being released when lead acid batteries are
being charged or discharged. Failure to follow instructions may cause property
damage, explosive hazard, and/or personal injury.

4) When connecting the battery clamps to a discharged battery, and an alarm sounds

- the polarity is reversed.

5) When charging unit from a 120 Volt ac electrical outlet in any wet or damp
area, make sure that the outlet used is protected by a ground fault interrupt (GFCI)
outlet.

6) When charging the unit near water, do not allow the electrical cords and outlets
to get wet or come near water–electrical shock could result.

7) Jump-start procedures should only be performed in a safe, dry, well-ventilated
area.

8) Always store battery clamps in built-in holsters when not in use. Never touch
battery clamps together, this can cause dangerous sparks, power arcing
and/or explosion.

9) When using this unit in proximity to the vehicle’s battery and engine, stand the
unit on a flat, stable surface, and be sure to keep all clamps, cords, clothing and
body parts away from moving vehicle components.

10) Do not wear vinyl clothing when jump-starting a vehicle, friction can cause
dangerous static-electricity sparks. Remove all jewelry or metal objects that could
cause short circuits or react with battery acid.

11) Always disconnect the negative (Black) jumper cable first: followed by the
positive (Red) jumper cable, except for positive ground systems.
Never allow red and black clamps to touch each other or another common metal

12)
conductor–this could cause damage to the unit and/or create sparking/
explosion hazard. Always store battery clamps in built-in holsters when not in use.

13) Do not expose battery to fire or intense heat as it may explode. Before disposing
of the battery, protect exposed terminals with heavy-duty electrical tape to
prevent shorting (shorting can result in injury or fire).

14) Do not smoke or use inflammable items (matches, cigarette lighters, etc.) while
working on a vehicle’s battery system.

15) Keep unit out of reach of children (whether stored, or in use)!

FIRST AID:

SKIN: If battery acid comes in contact with skin, rinse immediately with water, then

wash thoroughly with soap and water. If redness, pain, or irritation occurs, seek
immediate medical attention.

EYES: If battery acid comes in contact with eyes, flush eyes immediately, for a

minimumof 15 minutes and seek immediate medical attention.

2

CAUTION:

(Caution statements advise against certain conditions and practices that may result
in damage to vehicles, appliances and/or The POWER ON BOARD® Jump-starter)

IMPORTANT:

Although this unit is delivered in a partially charged state, you must fully charge it
with the supplied 120 Volt AC charger for a full 24 hours before using it for

the first time. You can not overcharge the unit using the AC charger method.

1) Use only the supplied cords/adapters for recharging this unit. Do not recharge
for more than 3-4 hours maximum using 12 Volt DC method. Recharge unit after
each use.

2) All On/Off switches should be in the OFF position when the unit is charging or
not in use. Make sure all switches are in the OFF position before connection to a
power source or load.

3) Never insert anything other than the supplied power/recharging cords or
recommended appliance power/recharging cords into the 12 Volt DC charging/
power socket on this unit. Do not use any accessory that is not recommended or
provided by the manufacturer.

4) Do not use this unit to operate appliances that draw more than 20 amps.

5) This system is designed to be used only on vehicles with 12 Volt DC battery
systems. Do not connect to a 6 Volt or 24 Volt battery system.

6) This system is not designed to be used as a replacement for a vehicular battery.
Do not attempt to operate a vehicle that does not have a battery installed.

7) Vehicles that have on-board computerized systems may be damaged if vehicle
battery is jump-started. Before jump-starting, read the vehicle’s owners manual
to confirm that external-starting assistance is advised.

8) Excessive engine cranking can damage a vehicle’s starter motor. If the engine
fails to start after the recommended number of attempts, discontinue jump-start
procedures and look for other problems that may need to be corrected.

9) Although this unit contains a non-spillable battery, it is recommended that unit be
kept upright during storage, use and recharging. To avoid possible damage that
may shorten the unit’s working life, protect it from direct sunlight, direct heat
and/or moisture.

10) Check unit periodically for wear and tear. Replace worn or defective parts
immediately. Contact Vector Customer Service department toll-free 866-584-5504.

11) Do not attempt to jump-start a frozen battery.

12) Never submerge this unit in water.

13) DO NOT over-inflate tires.

3

CONTENTS

1. INTRODUCTION ....................................................................................... 5

2. USING POWER ON BOARD™ AS A JUMP-START SYSTEM ......................... 5,6

2.1 Easy, Step-by-Step Jump-starting Instructions ................................... 7,8

3. CHARGING/RECHARGING ........................................................................ 9

3.1 110/120 Volt AC Charging ................................................................ 9

3.2 12 Volt DC Charging ......................................................................... 10

3.3 Estimated Battery Life ...................................................................... 10

4. OPERATING AS A PORTABLE POWER SUPPLY .......................................... 10

5. EMERGENCY/WORK LIGHT ...................................................................... 10

6. COMPRESSOR/TIRE INFLATOR ................................................................ 11

6.1 Warnings for Compressor Use ........................................................... 11

6.2 Tire Inflation or Products w/ Valve Stem............................................ 11,12

6.3 Inflate other Articles (w/out Valve Stem) ........................................... 12

6.4 Typical Inflation Times ...................................................................... 12

7. REPLACEMENT PARTS ........................................................................... 12

7.1 Battery Disposal ............................................................................... 13

7.2 Battery Replacement ........................................................................ 13

7.3 Battery Disposal ............................................................................... 13

8. SPECIFICATIONS ................................................................................... 13

9. WARRANTY ........................................................................................... 14

4

1. INTRODUCTION

Congratulations on selecting the POWER ON BOARD® JUMP-STARTER, AIR
COMPRESSOR and 12 VOLT DC POWER SUPPLY. This compact jump-starter is unique
in the amount of energy it can supply for its size. The internal battery is a high density
sealed, lead-acid battery that stores and delivers energy comparable to full sized
ordinary jump-starters. Please read this guide carefully before use to ensure optimum
performance and avoid damage to the unit or items that you are using it with.

A standard feature of this model is a high pressure, self-contained tire compressor
with lighted gauge. This compressor allows quick inflation of vehicle tires to 260 PSI
and with supplied adapter nozzles, inflates beach balls, rafts and virtually any low­pressure inflatables. Three different sized nozzles allow for easy connection to all
popular inflatables.

The POWER ON BOARD® JUMP-STARTER & 12 VOLT DC POWER SUPPLY is a
compact, durable and portable jump-start system for vehicles and boats that have a
standard 12 Volt battery system. This self-contained, rechargeable system will start
most vehicles and boats without the need for a host vehicle or 110/120 Volt AC
power supply. It can also be used as a safe, portable source of 12 Volt DC electric
power in remote locations and/or emergency situations. It is ideal for use with Vector
12 Volt DC cordless, portable, rechargeable products and POWER ON BOARD®
DC/AC Power Inverters.

Use the POWER ON BOARD to:

• Jump-start any engine system with a standard 12 Volt DC battery: boat; truck; car;

airplane; RV; personal watercraft; snowmobile; garden tractor; gasoline engine
generator, etc.

• Operate: 12 Volt DC fans, inflators, fluorescent work lights, cellular phones (can

quick-charge a cellular phone by using the phone’s 12 Volt DC adapter cord),
spotlights, TVs, portable radios, cassette or CD players, and more.
Operate: Certain 120 Volt AC Accessories (requires a Vector 12 volt power
inverter, sold separately).

The POWER ON BOARD SYSTEM has an easy-to-read series of LED (Light Emitting
Diode) charge indicators that show when the unit is fully charged, or the level of
charge in the battery. Charge level can be viewed when the charge status push button
is pressed. A 12 Volt DC cigarette lighter-type socket is provided for use with
appliances that can operate from a vehicle cigarette lighter. This allows maximum
portability and utility when the POWER ON BOARD is used in remote locations.

POWER ON BOARD can be recharged from any standard 120 Volt AC power source
using the supplied AC Recharge Adapter. The adapter barrel connector
attaches to the Recharge Port on the top panel of the jump-starter. A built-in 12 Volt
appliance socket and the appropriate DC/DC charging/adapter cord is used to
recharge the battery from another 12 volt DC source. When pressed, the CHARGE
STATUS button will show the battery power level status (from Low to Full). The green
LED full indicator illuminates when the unit is fully recharged and charging can be
discontinued. An ON/OFF switch operates the built-in work/emergency light.

5